Backsplashes Clause Samples

Backsplashes a. All countertop pricing includes a nominal 6" splash. Any deviation from this must be priced by the Ceramic Tile Trade Partner's estimating department and be clearly designated on the designer'spapenvork. b. Splashes are mud set however; a deco with a trim on top (such as a rope) can be mastic set per ▇▇▇▇ ▇▇▇▇▇▇. c. Full backsplash will be set on the back and side walls of the countertop It will not wrap onto cabinet sides, only onto drywall. TileJStone trim pieces will be mitred at corners and return down to countertop. d. Decos, listelles or nominal 6" backsplashes will be wrapped around all countertop edges. Wrapping A. CARPET INSTALLATION 1. All pads to be in"thick, unless otherwise selected. 2. Tmde Contractor shall not install flooring over an uneven or cracked surface. Trade Contractor is responsible for thorough sweeping prior to flooring instauation. 3. Trade Contractor shall be responsible for minor tilling of floors as required for satisfactow installation. 4. Carpet shall be in installed in a manner to minimize seams. The "grain" of the carpet shall run in the same direction throughout. 5. Use of a power stretcher is mandatory on all wall- to- wall installations. 6. Each room shall be measured before installation to ensure efficient use of carpet and proper location ofjogs, projections, openings, hearths, closets, stairs, and door swings. 7. Carpet pile shall run in the same direction and toward the entrance unless specified otherwise. 8. Dye lots of carpet shall be matched or sequenced. 9. A 3 inch minimum overage is required for each cut of carpet unless the pattern repeat demands otherwise. 10. Stair nosing should be rounded at a radius of 'A inch -1 inch. 11. For curved or slopped areas, tailor the carpet to fitthe tread and riser without wTirMes and with the edgesneatly fished. 12. Amount of stretch is per manufactures recommendations. 13. Do not put doors in the tubs. 14. All mirrored doors are to be marked for their exact location which room front back lefl rigbt. 15. Install all removed door hardware. 16. Do not razor cut the baseboards. 17. Carpet to terminate at the backside of bi-pass door guides if there is a flooring change. 18. Warrantv scranes to be lefl in the master closet. 19. A heat shield is required on all irons. B. SEAMS 1 Seams shonld be kept to a minimum 2 Main Wc nmsalong, rather than across, the seam 3 The seams are away f?om areas subject to pivoting traffic when possible.