Position Description The employee shall be responsible for drafting his/her position description form and shall forward it to his/her supervisor for approval. When the employee and the supervisor disagree on the job description, they shall meet promptly and attempt to reach an agreement on the employee’s job duties. In the event that an agreement cannot be reached, the supervisor will finalize the job description in accordance with the supervisor’s understanding and expectations of the position. The employee may submit his or her comments for the classification analyst to consider when reviewing the position description.
Position Descriptions Individual position descriptions shall be reduced to writing and delineate the duties currently assigned to an employee’s position. A dated copy of the position description shall be given to the employee upon assuming the position and when the position description is amended. The individual position description shall be subject to at least an annual review with the employee. Nothing contained herein shall compromise the right or the responsibility of the Agency to assign work consistent with the classification specification.
Project Location & Description The Project, for which the provision of financial assistance is the subject of this Agreement, is hereby described as follows:
Work Description T-804 Opening Roads - Removal of closure devices, cleaning ditches, removing berms, and blading the traveled-way T-811 Closing Roads - Entrance treatment for 150' cross-rip; debris block (slash, earth, berm, rocks, etc.) + seed + water bar T-811 Closing Roads - Water bar frequency per BMPs for remainder of road T-811 Closing Roads - Engineering Rep. or Construction Inspector must be notified prior to performing closeout NFSR Road No. Lane Width & Maintenance Level Mile Marker Begin End 76L Single Lane / Level 2 76 0.00 Ending 0.48
Task Description This task includes activities associated with permit-required monitoring conducted in accordance with the conditions specified by state or federal regulatory agencies. All monitoring tasks must be located within or adjacent to the Project area and follow the Department’s Regional Coastal Monitoring Program and FWC's marine turtle and shorebird monitoring programs. Guidance for monitoring of nearshore resources is available in the Department's Standard Operation Procedures For Nearshore Hardbottom Monitoring Of Beach Nourishment Projects. The Local Sponsor must submit work products directly to the appropriate state or federal regulatory agencies in accordance with permit conditions to be eligible for reimbursement under this task, unless otherwise directed.
Additional Description If any additional information would help describe the property, include it here. Step 3 – Identify Lease Term 7.
Description Details Type of personal data The personal data to be processed is defined in the ILR specification. xxxxx://xxx.xxx.xx/government/collections/individualised- learner-record-ilr Categories of data subject The data subjects are Learners on education or training programmes administered by the Department that are subject to this Agreement. Retention and destruction of the data once the processing is complete UNLESS requirement under union or member state Law to preserve that type of data Information on how the data must be supplied to the Department is detailed in the ILR specification and its appendices. xxxxx://xxx.xxx.xx/government/collections/individualised- learner-record-ilr For the purposes of the Department as a data controller of the data, the Provider is required to retain the data for the funding and audit purposes set out in this Agreement for 6 years from the end of the Financial Year in which the last payment is made under this Agreement. For the purposes of the Department for Work & Pensions as a data controller, where Learner data is used as match on the 2014-20 ESF programme, the data must be retained securely until 31st December 2030. The Provider (and any other data controller) is responsible for determining any further need to process the data, including its retention, prior to secure destruction.
Brief Description Identification of the device: mirror, camera/monitor, other device 2/ Device for indirect vision of Class I, II, III, IV, V, VI, S 2/ Δ Symbol 2m as defined in paragraph 6.1.3.1.1. of this Regulation: yes/no 2/ Annex 3
Job Description The Employer agrees to draw up job descriptions for all positions for which the Union is bargaining agent. These descriptions shall be presented and discussed with the Union and shall become the recognized job descriptions unless the Union presents written objection with thirty (30) calendar days. If such objection cannot be resolved, the issue may be subject to grievance and arbitration.
Topic Description Licensee Responsibilities Licensee must: Take appropriate steps to ensure the security, integrity, and confidentiality of Confidential Information and must comply with all relevant applicable laws and regulations, including laws protecting borrower privacy. Not disclose Confidential Information to third parties, without Xxxxxx Mae’s prior written approval, except on a need‐to‐know basis to Licensee’s partners, Topic Description affiliates, officers, employees, directors, contractors, counsels, agents or representatives, provided they are subject to confidentiality obligations at least as stringent as those set forth in this Section A3. Not use Confidential Information in any way that could be viewed as a conflict of interest, a breach of confidentiality or privacy, or the gaining of an unfair advantage from the relationship with Xxxxxx Xxx. Implement commercially reasonable measures meeting or exceeding industry standards to ensure the security, integrity, and confidentiality of Confidential Information, including using industry‐standard encryption for data in transit and virus checking programs designed to prevent the transmission and receipt of viruses and other malicious code, implementing appropriate disaster recovery and back‐up procedures, implementing appropriate procedures to prevent disclosure of data and other materials to a party other than the intended recipient, and employing methods for securely disposing or destroying such information. These measures must meet, at least, the same level of protection that the Receiving Party seeks for its own information of a similar nature. Licensee must collaborate with Xxxxxx Mae in assessing the sufficiency of these measures and Licensee’s information security program, upon reasonable request. Instruct its Related Parties who may receive Confidential Information about the requirements of this Section A3, and the processes and procedures necessary to comply with them. Comply with all reasonable security policies and procedures required by Xxxxxx Xxx related to the access and use of Xxxxxx Mae’s systems or any Licensed Materials. Not transmit to Xxxxxx Mae’s systems any materials that contain bugs, viruses, worms or other functions, routines, devices or instructions which may create any unauthorized access or damage to, or interruption in the functioning of, the Licensed Application or Xxxxxx Mae’s systems. Restrictive Legends Licensee must abide by and reproduce and include any restrictive legend or proprietary rights notice that appears in or on any Confidential Information of Xxxxxx Xxx or any Third‐Party Licensor (or other third‐party owner) that it is authorized to reproduce. Licensee also agrees that it will not remove, alter, cover or distort any trademark, trade name, copyright or other proprietary rights notices, legends, symbols or labels appearing on or in any Confidential Information of Xxxxxx Mae or any Third‐Party Licensor (or other third‐party owner). Required Actions in Case of Data Breach Licensee must address any Data Breach with prompt and effective corrective action, including cooperation with Xxxxxx Xxx in the investigation and remediation of such Data Breach, as well as prompt disclosure and notification where legally required; and Licensee must promptly notify Xxxxxx Mae of any Data Breach in writing ‐‐ at xxxxxxx_xxxxxxxxxxxx@xxxxxxxxx.xxx ‐‐ and must take all steps reasonably requested by Xxxxxx Xxx to mitigate the consequences of such Data Breach.
