Examples of Heating mode in a sentence
Heating mode is activated with the button, and reduced operation mode with the button.
The average dew point temperature of the air entering the outdoor coil during wet coil tests must be within±3.0 °F of the average dew point temperature of the air entering the indoor coil over the 30- minute data collection interval described in section 3.3. For dry coil tests on such units, it may be necessary to limit the moisture content of the air entering the outdoor side of the unit to meet the requirements of section 3.4. 2.2.4.2 Heating mode tests.
If CDc is negative, then set it equal to zero.3.6 Heating mode tests for different types of heat pumps, including heating-only heat pumps.3.6.1 Tests for a heat pump having a single-speed compressor that is tested with a fixed speed indoor blower installed, with a constant-air-volume-rate indoor blower installed, or with no indoor blower installed.
If flame is proved when flame should not be present, the furnace control CPU will lock out of Gas-- Heating mode and operate the inducer motor IDM on high speed until flame is no longer proved.
These tools can perform jobs like creating reports and therefore provide more time for professionals to focus on solving more complex problems, further enhancing efficiency.
Constitutional Proposal 18 requires the Legislature to amend the laws of the state to permit entry into an agreement with other states to simplify the process that remote sellers may use to calculate and remit sales and use taxes to the state.
In the Heating mode, the temperature will decrease by 1℃ after the unit runs under Sleep 1 for 1hr and 1℃ after another 1hr.
If press either of them continuously, thetemperature will be increased or decreased by 1℃ every 0.5s,as shown in Fig.6.In the Cooling, Dry or Heating mode, the temperature setting range is 16℃~ 30℃ .In the Fan mode, the setting temperature is fixed at 26℃ .
Power shut off at Heating mode - The automatic over heat protection function.
Start the heat pump, see Paragraph 5.2.4, press to select the operating mode:• Heating, is displayed, see Figure 13.• Cooling, is displayed, see Figure 14.Whenever the operating mode changes, the set temperature is switched to the following default values:• Heating mode, 40 [°C].• Cooling mode, 30 [°C].Thus, the set temperature must be regulated, see Paragraph 5.2.6, whenever the operating mode changes.