Casing Diameter definition

Casing Diameter or “Diameter of Casing” means the largest nominal permanent water bearing casing. For the purpose of this chapter, the diameter of the casing at the upper terminus will be presumed to be the diameter for the entire length, unless the well owner or contractor can demonstrate that the well has a smaller diameter permanent water bearing casing below the upper terminus.

Examples of Casing Diameter in a sentence

  • PE pipe shall have the following minimum wall thickness: Casing Diameter (inches)Minimum Wall Thickness (inches)30.31840.40960.60280.785100.97812 (maximum acceptable)1.160115.34(5) Reinforced concrete pipe.

  • Welded steel pipe shall have the following minimum wall thickness: Casing Diameter (inches)Under 6Minimum Wall Thickness (inches)Standard wall pipe or .188 wall pipe6, 8, 10, 12, 14, 16.188 - 3/1618, 20, 22.250 - 1/424, 26.281 - 9/3228, 30, 32, 34.312 - 5/1636, 38, 40, 48.344 - 11/32115.34(2) Cast iron or ductile iron pipe.

  • BOREHOLE DEPTHTotal Depth ……..= 200 meters Casing Diameter = 6 Inch (153 mm) Anticipated yield = 20 m3/hrS E C T I O N 3 FORM OF TENDER TO: The Principal SecretaryState Department for WildlifeP.O. Box 30126 – 00100, GPO NAIROBI.

  • BOREHOLE DEPTHTotal Depth ……..= 180 meters Casing Diameter = 6 Inch (153 mm) Anticipated yield = 20 m3/hrS E C T I O N 3 FORM OF TENDER TO: The Principal SecretaryState Department for WildlifeP.O. Box 30126 – 00100, GPO NAIROBI.

  • Minimum size and Thickness shall be as follows: Pipe Diameter Casing Diameter Wall Thickness (Inches) (Inches) (Inches) 6120.2508160.25012180.25016240.25020300.31224360.37530420.375 B.

  • Chlorine Compound Required to Produce a 100 mg/l Solution per 100 Feet of Water-filled Casing Well Casing Diameter 65% HTH dry wt.(l) 5.25% CommercialBleach liquid measure6 inch4.0 oz.40 oz.8 inch6.0 oz.64 oz.

  • Casing Diameter in InchesVolume per: 100 Feet (Gallons)70% Sodium Hypochlorite (Oz. Dry Wt.)5% Sodium Hypochlorite (Liquid Meas.)2160.54 ounces465218 ounces6147440 ounces826164.25 pints1040887 pints125881210 pints161045202 gallons201632323.3 gallons242350484.67 gallons303672707.3 gallons36528810110.5 gallons 12 VAC 5-630-480.

  • Nominal Casing Diameter (in inches)Minimum Wall Thickness(in inches)40.23750.25860.28080.322100.365120.375140.375160.375180.375200.375240.500260.500 b.

  • TABLE 3.2.1: WELL CASING DIAMETER VOLUME FACTORS Casing Diameter (inches)Gallons/ft, One Water ColumnGallons/ft, Three Water Columns1 With respect to volume, an adequate purge is normally achieved when three to five well volumes have been removed.

  • Utilize a level-setting mechanism to educate all participants on the program.

Related to Casing Diameter

  • Diameter means the diameter of the stem of a tree measured outside the bark at a specified point of measurement.

  • Casing means a pipe or tubing of appropriate material, of varying diameter and weight, lowered into a borehole during or after drilling in order to support the sides of the hole and thus prevent the walls from caving, to prevent loss of drilling mud into porous ground, or to prevent water, gas, or other fluid from entering or leaving the hole.

  • Sub-meter means a metering point for electricity consumption that does not include all electricity consumption for the end-use customer as defined by the electric distribution company account number. PJM shall only accept sub-meter load data from end-use customers for measurement and verification of Regulation service as set forth in the Economic Load Response rules and PJM Manuals.

  • Stinger-steered automobile or watercraft transporter means an automobile or watercraft transporter

  • Hydraulic fracturing means the fracturing of underground rock formations, including shale and non-shale formations, by manmade fluid-driven techniques for the purpose of stimulating oil, natural gas, or other subsurface hydrocarbon production.

  • Engine degreaser means a cleaning product designed to remove grease, grime, oil and other contaminants from the external surfaces of engines and other mechanical parts.

  • Horizontal well means a well bore drilled laterally at an angle of at least eighty (80) degrees to the vertical or with a horizontal projection exceeding one hundred (100) feet measured from the initial point of penetration into the productive formation through the terminus of the lateral in the same common source of supply.

  • Tube means an x-ray tube, unless otherwise specified.

  • Flash point means the lowest temperature of a liquid at which its vapours form a flammable mixture with air;

  • Drum means any cylindrical metal shipping container of 13 to 110 gallon capacity.

  • glider means a non-power-driven heavier-than-air aircraft, deriving its lift in flight chiefly from aerodynamic reactions on surfaces, which remain fixed under given conditions of flight;

  • Check Meter means the Buyer revenue-quality meter section(s) or meter(s), which Buyer may require at its discretion, and which will include those devices normally supplied by Buyer or Seller under the applicable utility electric service requirements.

  • Tank wagon means a straight truck having 1 or more compartments other than the fuel supply tank designed or used to carry motor fuel.

  • Basal area means the effective surface area available to transmit the treated effluent from the filter media in a mound system into the in-situ receiving soils. The perimeter is measured at the interface of the imported fill material and in-situ soil. On sloping sites, only the area down-gradient from the up-slope edge of the distribution media may be included in this calculation.

  • E-cigarette means any electronic oral device, such as one composed of a heating element and battery or electronic circuit, or both, which provides a vapor of nicotine or any other substances, and the use or inhalation of which simulates smoking. The term shall include any such device, whether manufactured, distributed, marketed, or sold as an e-cigarette, e-cigar, and e-pipe or under any other product, name, or descriptor.

  • borehole means a hole sunk into the earth for the purpose of locating, abstracting or using subterranean water and includes a spring;

  • water meter means any apparatus for measuring or showing the volume of water supplied to, or of effluent discharged from any premises;

  • Pressurized gas duster means a pressurized product labeled to remove dust from a surface solely by means of mass air or gas flow, including surfaces such as photographs, photographic film negatives, computer keyboards, and other types of surfaces that cannot be cleaned with solvents. “Pressurized Gas Duster” does not include “Dusting Aid.”

  • Cartridge means a pleated or surface-type filter component with fixed dimensions that is designed to remove suspended particles from water flowing through the filter.

  • Taximeter means any device for calculating the fare to be charged in respect of any journey in a hackney carriage or private hire vehicle by reference to the distance travelled or time elapsed since the start of the journey, or a combination of both; and

  • Loop Concentrator/Multiplexer or "LCM" is the Network Element that does one or more of the following: aggregates lower bit rate or bandwidth signals to higher bit rate or bandwidth signals (multiplexing); disaggregates higher bit rate or bandwidth signals to lower bit rate or bandwidth signals (demultiplexing); aggregates a specified number of signals or channels to fewer channels (concentrating); performs signal conversion, including encoding of signals (e.g., analog to digital and digital to analog signal conversion); or in some instances performs electrical to optical (E/O) conversion. LCM includes DLC, and D4 channel banks and may be located in Remote Terminals or Central Offices.

  • Elevation means the vertical distance of a point or a level, on or affixed to the surface of the earth, measured from mean sea level;

  • Diatomaceous earth filtration means a process resulting in substantial particulate removal in which a precoat cake of diatomaceous earth filter media is deposited on a support membrane (septum), and while the water is filtered by passing through the cake on the septum, additional filter media known as body feed is continuously added to the feed water to maintain the permeability of the filter cake.

  • Intermodal Rail Yard means a rail facility in which cargo is transferred from drayage truck to train or vice-versa.

  • SOFR with respect to any day means the secured overnight financing rate published for such day by the Federal Reserve Bank of New York, as the administrator of the benchmark, (or a successor administrator) on the Federal Reserve Bank of New York’s Website.

  • PAD means a Preauthorized Debit.