Unit Limits Sample Clauses

Unit Limits. 16 a) Any bargaining unit member shall be limited to not more than twenty-six (26) 17 such units of credit in the total of seventy-five (75) that may be accumulated from 18 Class I to Class V. Within the fifteen (15) units required to move from any one 19 class to the next, not more than six (6) units shall be earned in this program.
AutoNDA by SimpleDocs
Unit Limits. The maximum number of Units that may be delivered pursuant to all Awards granted under this Plan shall not exceed 120,001 Units (the “Unit Limit”).

Related to Unit Limits

  • Profit Limitation (a) Notwithstanding any other provision of this Agreement, in no event shall the Grantee's Total Profit exceed the Profit Cap and, if it otherwise would exceed such amount, the Grantee, at its sole election, shall either (i) deliver to the Company for cancellation Option Shares previously purchased by Grantee, (ii) pay cash or other consideration to the Company, (iii) reduce the amount of the fee payable to Grantee under Section 9.5 of the Merger Agreement or (iv) undertake any combination thereof, so that the Grantee's Total Profit shall not exceed the Profit Cap after taking into account the foregoing actions.

  • Investment Limits In the performance of its duties and obligations under this Agreement, Subadviser shall act in conformity with applicable limits and requirements, as amended from time to time, as set forth in the (A) Fund's Prospectus and Statement of Additional Information ("SAI"); (B) instructions and directions of AEFC and of the Board; (C) requirements of the 1940 Act, the Internal Revenue Code of 1986, as amended, as applicable to the Fund, and all other applicable federal and state laws and regulations; and (D) the procedures and standards set forth in, or established in accordance with, the Advisory Agreement.

  • Credit Limits 18.1 The Client understands that:

  • Benefit Limit A. Should it be determined that the aggregate Present Value (measured as of the Closing Date) of the Parachute Payment attributable to the Payment(s) does not exceed one hundred ten percent (110%) of the Permissible Parachute Amount, then no Gross-Up Payment shall be made to Executive under Paragraph 1 of this Appendix. Instead, the limitations set forth in this Paragraph 2 shall apply. Accordingly, the amount of the Payments otherwise due the Executive shall be reduced to the extent necessary to assure that the aggregate Present Value of the Payment(s) does not exceed the greater of the following dollar amounts (the “Benefit Limit”)

  • Deposit Limits We reserve the right to impose limits on the amount(s) and/or number of deposits that you transmit using the Services and to modify such limits from time to time.

  • Amount Limitations Notwithstanding any other term of this Agreement or any other Loan Document, no Lender shall be required to make a Loan, the Issuing Bank shall not be required to issue a Letter of Credit and no reduction of the Revolving Commitments pursuant to Section 2.13 shall take effect, if immediately after the making of such Loan, the issuance of such Letter of Credit or such reduction in the Revolving Commitments:

  • Dollar Limits Per Service Agreement Cost to diagnose, repair and/or replace - Geothermal and water source systems $1,500 Water cooled air conditioners, high velocity and hydronic systems $1,500 Concrete encased or concealed ductwork $500 Refrigerant lines $500 Appliances l Standard/Seller Coverage S Supreme Coverage l S Appliance color matchSM l S Built-in microwave l S Dishwasher l S Garbage disposal l S Range, oven, cooktop and vent hood l S Refrigerator - INCLUDING ICE MAKER! S Washer and dryer S Range, oven, cooktop, hood: handles, hinges, clocks, rotisseries, racks, knobs and dials, interior lining, glass/ceramic cooktops, self cleaning mechanisms and latch assemblies S Kitchen Refrigerator: handles, hinges, ice crusher, beverage dispenser and respective equipment S Built-in microwave: handles, hinges, interior lining, clocks and shelves, turntable platforms and rollers S Dishwasher: handles, hinges, racks, baskets, rollers, tub and interior lining, springs, latch assemblies and soap dispensers S Permits up to $250 per Service Agreement S Modifications up to $250 per Service Agreement S Haul away/disposal fees S Items under manufacturer’s warranty Excluded Items: ✖ Appliances not located in the primary kitchen (except washer and dryer) and duplicate appliances, unless additional refrigerator option(s) are purchased. ✖ Meat probe assemblies, door glass, sensi-heat burners will only be replaced with standard burners for range, oven, cooktop. ✖ Multimedia center including technology convenience items like LCD screens, Wi-Fi and cameras. ✖ Racks, hinges, shelves, interior thermal shells, food spoilage and freezers which are not an integral part of the kitchen refrigerator. ✖ Door glass, portable or counter top units, trim kits, meat probe assemblies, rotisseries for built-in microwave. ✖ Damage to clothing, plastic mini-tub, soap dispensers, filter screens, knobs, dials, hinges and lint screen for washer or dryer. ✖ Gas supply line to stove.

  • Minimum Limits The minimum limits to be maintained by the School (inclusive of any amounts provided by an umbrella or excess policy) shall be $1 million per occurrence/$3 million annual aggregate.

  • Coverage Minimum Limits Commercial General Liability $1,000,000 per occurrence $2,000,000 aggregate Automobile Liability including coverage for owned, non-owned and hired vehicles $1,000,000 per occurrence

  • Individual Flexibility Arrangements 7.1 An Employer and Employee covered by the Agreement may agree to make an individual flexibility arrangement to vary the effect of terms of the Agreement if:

Time is Money Join Law Insider Premium to draft better contracts faster.