Common use of SMALL EQUIPMENT Clause in Contracts

SMALL EQUIPMENT. An Operating Engineer servicing and maintaining the following listed Class IV machinery: Small Air Compressors, Small Generators, Small Electric Winches, Welding Machines, and Sump Pumps three inches (3”) or under, shall not be required to maintain more than a total of five (5) such machines of the same type, except Small Electric Winches for which the total number maintained shall not be more than four (4), nor shall such employee be required to service and maintain more than a total of five (5) of the above listed machines in combination. When employees of the bargaining unit are employed to service and maintain mechanical heaters, such employees shall not be required to service and maintain more than a total of five (5) such heaters. Where a member of the bargaining unit is required to service and maintain more than a total of five (5) heaters, such employee shall be compensated at the Class I rate of pay negotiated for Crane Operators in this Agreement. Assignment of such machines shall not exceed a total of eight (8). An Engineer shall not be required on one (1) small heater of less than 250,000 B.T.U.

SMALL EQUIPMENT. An Operating Engineer servicing and maintaining the following listed Class IV machinery: Small Air CompressorsCompressor, Small Generators, Small Electric Winches, Welding Machines, Machines and Sump Pumps three inches (3”) inch or under, under - shall not be required to maintain more than a total of five (5) such machines of the same type, except Small Electric Winches for which the total number maintained shall not be more than four (4), nor shall such employee employees be required to service and maintain more than a total of five (5) of the above listed machines in combination. When employees of the bargaining unit Bargaining Unit are employed to service and maintain mechanical heaters, such employees shall not be required to service and maintain more than a total of five (5) such heaters. Where a member of the bargaining unit Bargaining Unit is required to service and maintain more than a total of five (5) heaters, such employee shall be compensated at the Class I rate of pay negotiated for Crane Operators in this Agreement. Assignment of such machines shall not exceed a total of eight (8). An Engineer shall not be required on one (1) small heater of less than 250,000 B.T.U.

SMALL EQUIPMENT. An Operating Engineer servicing servicing, operating and maintaining the following listed Class IV III machinery: ; Small Air Compressors, Small Generators, Small Electric Winches, and Welding Machines, and Sump Pumps three inches (3”) or under, Machines - shall not be required to maintain more than a total of five six (56) such machines of the same type, except Small Electric Winches for which the total number maintained shall not be more than four six (4), 6) nor shall such employee employees be required to service service, operate and maintain more than a total of five six (56) of the above listed machines in combination. When employees of the bargaining unit are employed to service and maintain mechanical heaters, or ground heaters such employees shall not be required to service and maintain no more than a total of five six (56) such heaters. Where a member of the bargaining unit is required to service service, operate and maintain more than a total of five six (56) heaters, such employee shall be compensated at the Class I rate of pay negotiated for Crane Operators in this Agreement. Assignment of such machines shall not exceed a total of eight nine (8)9). An Engineer shall not be required on one (1) small heater of less than 250,000 B.T.U.