Common use of Second Class Certificate Clause in Contracts

Second Class Certificate. Upon successful completion of the Department of Education Correspondence Course for a SECOND CLASS STATIONARY STEAM ENGINEERING CERTIFICATE, or possessing equivalent qualifications acceptable to the Vocational School authorities, employees shall be granted ten (10) weeks leave of absence with pay, on the basis set forth hereunder, to attend an approved Vocational School to complete the two-part course and write the examination for the Second Class Stationary Steam Engineering Certificate: (i) Five (5) weeks leave of absence with pay to complete Part "A" (Mathematics & Physics). (ii) Five (5) weeks leave of absence with pay to complete Part "B" (Basic Engineering). During his first week at the school in each of the above mentioned cases (i) and (ii) the employee will be evaluated by the school authorities to determine his knowledge of the subject, and if the evaluation is favourable he will continue his studies at the school during the following four (4) weeks and write the examination prescribed for Part "A" or "B", whichever is applicable. In the event that the evaluation is not favourable, the school authorities will indicate to the employee those areas where further study is needed and he will return to the mill and carry out the recommended home studies. Upon completion of this additional studying, the employee will be granted five (5) weeks leave of absence, four (4) weeks with pay and one (1) without, to return to the Vocational School to complete the course and write the examination prescribed for Part "A" or "B", whichever is applicable.

Second Class Certificate. Upon successful completion of the Department of Education Correspondence Course for a SECOND CLASS STATIONARY STEAM ENGINEERING CERTIFICATE, or possessing equivalent qualifications acceptable to the Vocational School authorities, employees shall be granted ten (10) weeks leave of absence with pay, on the basis set forth hereunder, to attend an approved Vocational School to complete the two-part course and write the examination for the Second Class Stationary Steam Engineering Certificate: (i) Five (5) weeks leave of absence with pay to complete Part "“A" ” (Mathematics & Physics). (ii) Five (5) weeks leave of absence with pay to complete Part "“B" ” (Basic Engineering). During his first week at the school in each of the above mentioned cases (i) and (ii) the employee will be evaluated by the school authorities to determine his knowledge of the subject, and if the evaluation is favourable he will continue his studies at the school during the following four (4) weeks and write the examination prescribed for Part "“A" ” or "“B"”, whichever is applicable. In the event that the evaluation is not favourable, the school authorities will indicate to the employee those areas where further study is needed and he will return to the mill and carry out the recommended home studies. Upon completion of this additional studying, the employee will be granted five (5) weeks leave of absence, four (4) weeks with pay and one (1) without, to return to the Vocational School to complete the course and write the examination prescribed for Part "“A" ” or "“B"”, whichever is applicable.

Second Class Certificate. Upon successful completion of the Department of Education Correspondence Course for a SECOND CLASS STATIONARY STEAM ENGINEERING CERTIFICATE, or possessing equivalent qualifications acceptable to the Vocational School authorities, employees shall be granted ten (10) weeks leave of absence with pay, on the basis set forth hereunder, to attend an approved Vocational School to complete the two-part course and write the examination for the Second Class Stationary Steam Engineering Certificate: (i) Five (5) weeks leave of absence with pay to complete Part "A" (Mathematics & Physics). (ii) Five (5) weeks leave of absence with pay to complete Part "B" (Basic Engineering). During his their first week at the school in each of the above mentioned cases (i) and (ii) the employee will be evaluated by the school authorities to determine his their knowledge of the subject, and if the evaluation is favourable he will continue his studies at the school during the following four (4) weeks and write the examination prescribed for Part "A" or "B", whichever is applicable. In the event that the evaluation is not favourable, the school authorities will indicate to the employee those areas where further study is needed and he the employee will return to the mill and carry out the recommended home studies. Upon completion of this additional studying, the employee will be granted five (5) weeks leave of absence, four (4) weeks with pay and one (1) without, to return to the Vocational School to complete the course and write the examination prescribed for Part "A" or "B", whichever is applicable.

Second Class Certificate. Upon successful completion of the Department of Education Correspondence Course for a SECOND CLASS STATIONARY STEAM POWER ENGINEERING CERTIFICATE, or possessing equivalent qualifications acceptable to the Vocational School authorities, employees shall be granted ten (10) weeks leave of absence with pay, on the basis set forth hereunder, to attend an approved Vocational School to complete the two-part course and write the examination for the Second Class Stationary Steam Power Engineering Certificate: (i) Five Five- (5) weeks leave of absence with pay to complete Part "A" (Mathematics & Physics). (ii) Five Five- (5) weeks leave of absence with pay to complete Part "B" (Basic Engineering). During his the first week at the school in each of the above mentioned cases (i) and (ii) the employee will be evaluated by the school authorities to determine his the employee's knowledge of the subject, and if the evaluation is favourable he favorable the employee will continue his studies at the school during the following four (4) weeks and write the examination prescribed for Part "A" or "B", whichever is applicable. In the event that the evaluation is not favourablefavorable, the school authorities will indicate to the employee those areas where further study is needed and he the employee will return to the mill and carry out the recommended home studies. Upon completion of this additional studying, the employee will be granted five (5) weeks leave of absence, four (4) weeks with pay and one (1) without, to return to the Vocational School to complete the course and write the examination prescribed for Part "A" or "B", whichever is applicable.

Second Class Certificate. Upon successful completion of the Department of Education Correspondence Course for a SECOND CLASS STATIONARY STEAM ENGINEERING CERTIFICATE, or possessing equivalent qualifications acceptable to the Vocational School authorities, employees shall be granted ten (10) weeks leave of absence with pay, on the basis set forth hereunder, to attend an approved Vocational School to complete the two-part course and write the examination for the Second Class Stationary Steam Engineering Certificate: (i) Five (5) weeks leave of absence with pay to complete Part "A" (Mathematics & Physics). (ii) Five (5) weeks leave of absence with pay to complete Part "B" (Basic Engineering). During his his/her first week at the school in each of the above mentioned cases (i) and (ii) the employee will be evaluated by the school authorities to determine his his/her knowledge of the subject, and if the evaluation is favourable he he/she will continue his his/her studies at the school during the following four (4) weeks and write the examination prescribed for Part "A" or "B", whichever is applicable. In the event that the evaluation is not favourable, the school authorities will indicate to the employee those areas where further study is needed and he he/she will return to the mill and carry out the recommended home studies. Upon completion of this additional studying, the employee will be granted five (5) weeks leave of absence, four (4) weeks with pay and one (1) without, to return to the Vocational School to complete the course and write the examination prescribed for Part "A" or "B", whichever is applicable.

Second Class Certificate. Upon successful completion of the Department of Education Correspondence Course for a SECOND CLASS STATIONARY STEAM ENGINEERING CERTIFICATE, or possessing equivalent qualifications qualifications acceptable to the Vocational School authorities, employees shall be granted ten (10) weeks leave of absence with pay, on the basis set forth hereunder, to attend an approved Vocational School to complete the two-part course and write the examination for the Second Class Stationary Steam Engineering CertificateCertificate: (i) Five (5) weeks leave of absence with pay to complete Part "“A" ” (Mathematics & Physics). (ii) Five (5) weeks leave of absence with pay to complete Part "“B" ” (Basic Engineering). During his first first week at the school in each of the above mentioned cases (i) and (ii) the employee will be evaluated by the school authorities to determine his knowledge of the subject, and if the evaluation is favourable he will continue his studies at the school during the following four (4) weeks and write the examination prescribed for Part "“A" ” or "“B"”, whichever is applicable. In the event that the evaluation is not favourable, the school authorities will indicate to the employee those areas where further study is needed and he will return to the mill and carry out the recommended home studies. Upon completion of this additional studying, the employee will be granted five five (5) weeks leave of absence, four (4) weeks with pay and one (1) without, to return to the Vocational School to complete the course and write the examination prescribed for Part "“A" ” or "“B"”, whichever is applicable.

Second Class Certificate. Upon successful completion of the Department of Education Correspondence Course for a SECOND CLASS STATIONARY STEAM ENGINEERING CERTIFICATE, or possessing equivalent qualifications acceptable to the Vocational School authorities, employees shall be granted ten (10) weeks leave of absence with pay, on the basis set forth hereunder, to attend an approved Vocational School to complete the two-part course and write the examination for the Second Class Stationary Steam Engineering Certificate: (i) Five (5) weeks leave of absence with pay to complete Part "“A" ” (Mathematics & Physics). (ii) Five (5) weeks leave of absence with pay to complete Part "“B" ” (Basic Engineering). During his first week at the school in each of the above mentioned cases (i) and (ii) the employee will be evaluated by the school authorities to determine his knowledge of the subject, and if the evaluation is favourable he will continue his studies at the school during the following four (4) weeks and write the examination prescribed for Part "“A" ” or "“B", ”. whichever is applicable. In the event that the evaluation is not favourable, the school authorities will indicate to the employee those areas where further study is needed and he will return to the mill and carry out the recommended home studies. Upon completion of this additional studying, the employee will be granted five (5) weeks leave of absence, four (4) weeks with pay and one (1) without, to return to the Vocational School to complete the course and write the examination prescribed for Part "“A" ” or "“B"”, whichever is applicable.

Second Class Certificate. Upon successful completion of the Department of Education Correspondence Course for a SECOND CLASS STATIONARY STEAM ENGINEERING CERTIFICATE, or possessing equivalent qualifications qualifications acceptable to the Vocational School authorities, employees shall be granted ten (10) weeks leave of absence with pay, on the basis set forth hereunder, to attend an approved Vocational School to complete the two-part course and write the examination for the Second Class Stationary Steam Engineering CertificateCertificate: (i) Five (5) weeks leave of absence with pay to complete Part "“A" ” (Mathematics & Physics). (ii) Five (5) weeks leave of absence with pay to complete Part "“B" ” (Basic Engineering). During his first first week at the school in each of the above mentioned cases (i) and (ii) the employee will be evaluated by the school authorities to determine his knowledge of the subject, and if the evaluation is favourable he will continue his studies at the school during the following four (4) weeks and write the examination prescribed for Part "“A" ” or "“B"”, whichever is applicable. In the event that the evaluation is not favourable, the school authorities will indicate to the employee those areas where further study is needed and he will return to the mill and carry out the recommended home studies. Upon completion of this additional studying, the employee will be granted five five (5) weeks leave of absence, four (4) weeks with pay and one (1) without, to return to the Vocational School to complete the course and write the examination prescribed for Part "“A" ” or "“B"”, whichever is applicable.

Second Class Certificate. Upon successful completion of the Department of Education Correspondence Course for a SECOND CLASS STATIONARY STEAM ENGINEERING CERTIFICATE, or possessing equivalent qualifications acceptable to the Vocational School authorities, employees shall be granted ten (10) weeks leave of absence with pay, on the basis set forth hereunder, to attend an approved Vocational School to complete the two-part course and write the examination for the Second Class Stationary Steam Engineering Certificate: (i) : Five (5) weeks leave of absence with pay to complete Part "A" (Mathematics & Physics). (ii) . Five (5) weeks leave of absence with pay to complete Part "B" (Basic Engineering). During his first week at the school in each of the above mentioned cases (i) and (ii) the employee will be evaluated by the school authorities to determine his knowledge of the subject, and if the evaluation is favourable he will continue his studies at the school during the following four (4) weeks and write the examination prescribed for Part "A" or "B", whichever is applicable. In the event that the evaluation is not favourable, the school authorities will indicate to the employee those areas where further study is needed and he will return to the mill and carry out the recommended home studies. Upon completion of this additional studying, the employee will be granted five (5) weeks leave of absence, four (4) weeks with pay and one (1) without, to return to the Vocational School to complete the course and write the examination prescribed for Part "A" or "B", whichever is applicable.

Second Class Certificate. Upon successful completion of the Department of Education an approved Correspondence Course for a SECOND CLASS STATIONARY STEAM POWER ENGINEERING CERTIFICATE, or possessing equivalent qualifications acceptable to the Vocational or Technical School authorities, employees shall be granted ten (10) weeks weeks’ leave of absence with pay, on the basis set forth hereunder, to attend an approved Vocational or Technical School to complete the two-part course and write the examination for the Second Class Stationary Steam Power Engineering Certificate: (ia) Five (5) weeks weeks’ leave of absence with pay to complete Part "“A" (Mathematics & Physics)”. (iib) Five (5) weeks weeks’ leave of absence with pay to complete Part "“B" (Basic Engineering)”. During his their first week at the school in each of the above above-mentioned cases (i) and (ii) the employee will be evaluated by the school School authorities to determine his their knowledge of the subject, and if the evaluation is favourable he favourable, they will continue his their studies at the school during the following four (4) weeks and write the examination prescribed for Part "“A" ” or "“B", ” whichever is applicable. In the event that the evaluation is not favourable, the school authorities will indicate to the employee those areas where further study is needed needed, and he they will return to the mill Mill and carry out the recommended home studies. Upon completion of this additional studying, the employee will be granted five (5) weeks weeks’ leave of absence, four (4) weeks with pay and one (1) without, to return to the Vocational or Technical School to complete the course and write the examination prescribed for Part "“A" ” or "“B"”, whichever is applicable.

Second Class Certificate. Upon successful completion of the Department of Education Correspondence Course for a SECOND CLASS STATIONARY STEAM ENGINEERING CERTIFICATE, or possessing equivalent qualifications qualifications acceptable to the Vocational School authorities, employees shall be granted ten (10) weeks leave of absence with pay, on the basis set forth hereunder, to attend an approved Vocational School to complete the two-part course and write the examination for the Second Class Stationary Steam Engineering CertificateCertificate: (i) Five (5) weeks leave of absence with pay to complete Part "A" (Mathematics & Physics). (ii) Five (5) weeks leave of absence with pay to complete Part "B" (Basic Engineering). During his first first week at the school in each of the above mentioned cases (i) and (ii) the employee will be evaluated by the school authorities to determine his knowledge of the subject, and if the evaluation is favourable he will continue his studies at the school during the following four (4) weeks and write the examination prescribed for Part "A" or "B", whichever is applicable. In the event that the evaluation is not favourable, the school authorities will indicate to the employee those areas where further study is needed and he will return to the mill and carry out the recommended home studies. Upon completion of this additional studying, the employee will be granted five five (5) weeks leave of absence, four (4) weeks with pay and one (1) without, to return to the Vocational School to complete the course and write the examination prescribed for Part "A" or "B", whichever is applicable.