Common use of POWER DEFINITIONS Clause in Contracts

POWER DEFINITIONS. “Nominal Power Output (PO0)” means the original manufactured nameplate specification of the Module, expressed in Xxxxx, as certified by Xxxxx and indicated on the Module, excluding any specified positive tolerance. “Actual Power Output (POt)” means the power output of the Module, expressed in Xxxxx, at Watt peak that a Module generates at a given point in time in a year after the Warranty Start Date (t) in its ‘Maximum Power Point’ under Standard Test Conditions, corrected for any measurement error (“STC”). STC are as follows, measured in accordance with IEC 61215: (a) light spectrum of AM 1.5; (b) an irradiation of 1000W per m2; and (c) a cell temperature of 25 degrees centigrade at right angle irradiation. The “Degradation Rate (DR)” shall be any positive amount calculated in accordance with the following formula, expressed as a percent:

POWER DEFINITIONS. “Nominal Power Output (PO0)” means the original manufactured nameplate specification of the Module, expressed in Xxxxx, as certified by Xxxxx Jinko and indicated on the Module, excluding any specified positive tolerance. “Actual Power Output (POt)” means the power output of the Module, expressed in Xxxxx, at Watt peak that a Module generates at a given point in time in a year after the Warranty Start Date (t) in its ‘Maximum Power Point’ under Standard Test Conditions, corrected for any measurement error (“STC”). STC are as follows, measured in accordance with IEC 61215: (a) light spectrum of AM 1.5; (b) an irradiation of 1000W per m2; and (c) a cell temperature of 25 degrees centigrade at right angle irradiation. The “Degradation Rate (DR)” shall be any positive amount calculated in accordance with the following formula, expressed as a percent: