Common use of Other Traffic Control Methods Clause in Contracts

Other Traffic Control Methods. The posting of CB channel signs may be authorized. On roads listed in C5.31#, Purchaser may be authorized to install temporary gates, barricades (except cables), or natural barriers. The devices must be installed with the necessary hazard markers, be reasonably passable by Forest Service, and be removed to acceptance of the subdivision being served by the road. Sale Name: Cubbie SBA Page: 141c SAMPLE Name Name Purchaser Title Forest Service Title Date Date C2.35# (OPTION 1) - INDIVIDUAL TREE DESIGNATION (06/2008) All trees meeting the attached designation description which meet the minimum tree diameter stated in A2 are designated for cutting. Additional timber to be cut, if any, will be designated for cutting in accordance with B2.37. Leave trees, Marked with orange , or identified by the description in the attached criteria and table are not to be cut, unless designated by the Forest Service. SAMPLE CRITERIA PURSUANT TO C2.35# (Option 1) – INDIVIDUAL TREE DESIGNATION BY DESCRIPTION (06/2008) Apply Designation only to the trees within the unit boundary. Refer to the Individual Tree Designation by Description Table in “TABLE PURSUANT TO C2.35# (Option 1)” to reference appropriate designation by description technique(s) and specification(s). The Individual Tree Designation by Description Table identifies designation prescription(s), designating tree species1, and designation specification(s) for each respective unit(s). Any tree(s) species NOT identified within the Individual Tree Designation by Description Table in “TABLE PURSUANT TO C2.35# (Option 1)” are to be considered a “ghost tree species2”. Trees that are adjacent to but outside of the unit boundary, boundary trees3, individual trees marked with pink tracer paint, and Dead trees are not to be considered in applying the designation requirements. Designating Tree Species1: Tree species identified within the Designation by Description Table in “TABLE PURSUANT TO C2.35# (Option 1)” for which the designation prescription applies to.

Appears in 1 contract

Sources: Timber Sale Contract

Other Traffic Control Methods. The posting of CB channel signs may be authorized. On roads listed in C5.31#, Purchaser may be authorized to install temporary gates, barricades (except cables), or natural barriers. The devices must be installed with the necessary hazard markers, be reasonably passable by Forest Service, and be removed prior to acceptance of the subdivision being served by the road. Sale Name: Cubbie SBA PagePoole Thin DxP Page 141c Part II. Specific Requirements: 141c SAMPLE There are no additional specifications. Purchaser and Forest Service agree to the above stated requirements of the Traffic Control Plan: Name Name Purchaser Title Forest Service Title Date Date C2.35C2.355# - DESIGNATION BY PRESCRIPTION (OPTION 105/2015) - INDIVIDUAL TREE DESIGNATION (06/2008Within Subdivision(s) or Cutting Unit(s) All , as shown on the Sale Area Map, the following criteria shall be used by Purchaser to designate trees meeting the and other products for cutting and removal: (a) 1/ see attached designation description which meet the minimum tree diameter stated in A2 are designated for cutting. table 1 (b) Additional timber trees to be cut, if any, will are marked by Forest Service with 2/ green tracer paint. (c) Cutting unit boundaries and other trees that shall be designated for left uncut are marked by Forest Service with 2/ Purchaser may select cut trees in cutting units 3/ N/A without pre-harvest marking in accordance with B2.37the criteria in section (a). If specified in section (a), Purchaser shall mark leave trees in cutting units 4/ N/A with Purchaser's non-tracer 2/ N/A paint for inspection and approval by Forest Service prior to cutting. TABLE I PRESCRIPTION PURSUANT TO C2.355# – DESIGNATION BY PRESCRIPTION. (05/2015) Table 1 – Prescription* Subdivision Number Designated Cut Tree Species Individual Tree Designation Average Leave Trees per Acre Acceptable Range of Leave Trees per Acre 1 Acre Gaps 1 ▇▇▇▇▇▇▇-fir D X P 66 58-65 3 2 ▇▇▇▇▇▇▇-fir D X P 66 58-65 1 3 ▇▇▇▇▇▇▇-fir D X P 66 58-65 4 ▇▇▇▇▇▇▇-fir D X P 66 58-65 2 5 ▇▇▇▇▇▇▇-fir D X P 66 58-65 6 ▇▇▇▇▇▇▇-fir D X P 66 58-65 1 7 ▇▇▇▇▇▇▇-fir D X P 66 58-65 2 8 Red Alder ITM N/A N/A *See Prescription Criteria #8 below for Prescription Criteria within Unit #8, Prescription Criteria #5 below for Big Leaf maple release, and Prescription Criteria #7 for gap creation. 1. Leave treesthe largest and most vigorous live trees meeting minimum specification in A2 2. Outside of approved yarding corridors and skid trails, Marked with orange all live, non-designated conifers, if their diameter at DBH is 12.0 inches or identified by greater, shall be retained and counted to achieve the description desired Average Leave Tree Per Acre shown in Table 1. 3. To facilitate harvest operation, all tree species are designated cut tree within the width of approved yarding corridors and skid roads. 4. Include in the attached criteria number of Average Leave Tree Per Acre up to 5 tree/acre that have multiple tops and/or larger than normal branches. These leave trees shall be recruited from the largest trees available. 5. All Big Leaf ▇▇▇▇▇▇ are required to be left standing unless otherwise agreed or required to be cut for safety or operational reasons. In addition, up to three (3) of the largest and table most vigorous live Big Leaf maple trees per acre exceeding 6.0 inches DBH shall have all designated tree species shown in Table 1, less than 20” DBH, cut within 37 feet slope distance2/. These areas will be included in calculating the Average Leave Trees per Acre targets for the unit. Trees released in this manner shall occur at random over the entire cutting area where the Big Leaf Maple is found. Avoid overlapping the Big Leaf Maple release areas. If there are areas in the subdivision where Big Leaf maple trees exceeding 6.0 inches DBH are not to be cutpresent, unless designated by the Forest Service. SAMPLE CRITERIA PURSUANT TO C2.35# then one (Option 1) – INDIVIDUAL TREE DESIGNATION BY DESCRIPTION (06/2008) Apply Designation only to red alder per acre exceeding 12.0 inches DBH may be released with the same criteria for releasing the Big Leaf maple. If neither Big Leaf maple nor red alder are present in the subdivision, this requirement will be waived. Avoid releasing Big Leaf Maple trees located within 37 feet of the unit boundary. Refer to the Individual Tree Designation by Description Table in “TABLE I PRESCRIPTION PURSUANT TO C2.35C2.355# – DESIGNATION BY PRESCRIPTION. (Option 9/2004) 6. Subdivision boundaries are marked with blue boundary cards and orange tracer paint at DBH1/ and on ▇▇▇▇▇. Except along system roads, these will be virtual boundaries. Along system roads, boundary will be marked with yellow tracer paint facing road. 7. Gap Creation - all designated cut tree species shown in Table 1 above shall be cut within the specified distance of any pink marked leave tree. The specified distance for subdivisions 1), 2, 4, 6, and 7 is 118 feet (radius) slope distance to create one acre “gapsto reference appropriate designation by description technique(s) and specification(s(See Contract Area Map). The Individual leave trees are marked with one pink paint band (1 acre) at diameter breast height and ▇▇▇▇▇ ▇▇▇▇ on the downhill side of the tree. 8. Prescription Criteria for Unit #8 – Unit 8 is individual Tree Designation by Description Table identifies designation prescription(s), designating tree species1, Marked with blue tracer paint at DBH and designation specification(s) for each respective unit(s)a ▇▇▇▇▇ ▇▇▇▇ to identify included timber. Any tree(s) species NOT identified Each individual Red Alder within the Individual Tree Designation by Description Table in “TABLE PURSUANT TO C2.35# (Option 1)” are to be considered a “ghost tree species2”. Trees that are adjacent to but outside unit has been identified and marked along System road 5081. 1 Diameter at Breast Height is measured at 4.5 feet above the natural forest floor on the high or uphill side of the unit boundary, boundary trees3, individual trees marked with pink tracer paint, and Dead trees are not tree. Diameter is taken at a right angle to be considered in applying the designation requirements. Designating Tree Species1: Tree species identified within lean of the Designation by Description Table in “TABLE PURSUANT TO C2.35# (Option 1)” for which the designation prescription applies totree.

Appears in 1 contract

Sources: Timber Sale Contract