Off Mode (Power Switch Off Clause Samples

Off Mode (Power Switch Off. (1) At the conclusion of the Sleep Mode test, initiate the display's Off Mode using the power switch that is most easily accessed by the user. The method of adjustment shall be documented along with the sequence of events required to reach the Off Mode. Power on all test equipment and properly adjust operation range. (2) Allow the display to remain in Off Mode until stable power readings are measured. Measurements are considered stable once the wattage reading does not vary more than 1% over a three-minute period. Tester shall ignore the input sync signal check cycle when metering the model in Off Mode. (3) Record the test conditions and test data. The measurement time shall be sufficiently long to measure the correct average value (i.e., not peak or instantaneous power). (4) Reporting results: Upon completion of this test procedure, please refer to the Product Test Documentation section of the specification for guidance on how to report your test results to EPA or the European Commission, as applicable.