Common use of MOWING - Operation Clause in Contracts

MOWING - Operation. 13.01 Mowing operations shall be performed in a workmanlike manner that ensures a smooth, surface appearance without scalping or allowing excessive cuttings to remain. This includes the safe operation of equipment as determined by the Director and within the manufacturer's guidelines. It is strongly recommended that a large mulching mower be used for the large turf areas. 13.01.01 Mowing that creates excessive cuttings shall be removed by raking at the sole expense of the Contractor. 13.02 Turf shall be mowed with a reel-type mower equipped with rollers or a rotary-type deck and shall be configured so that the outer edges of the blade shall extend 18" to 24" beyond the outer edge of the wheel. 13.02.01 Turf area located in the Rose Garden and surrounding areas, as shown in Exhibit N-2, shall be mowed with a reel-type mower with rollers to a height set between ¼ inch and ½ inch. 13.02.02 All other turf areas, as shown in Exhibit N-3, shall be mowed with a rotary-type mower to a height set between 1 inch and 2 inches. 13.03 All equipment shall be adjusted to the proper cutting heights and shall be adequately sharpened. 13.04 Mowing height shall be appropriate to turf species and use parameters. Mowing heights may vary for special events and conditions. Heights shall be determined by the Director. 13.05 Mowing operation shall be on a schedule that is acceptable to the Director. 13.06 Walkways and hard surface areas shall be cleaned immediately following each mowing so that no clippings create a hazardous condition. 13.07 Mowing of turf shall be completed as identified in the Contractor's schedule and in one operation.