Common use of Electrical characteristics Clause in Contracts

Electrical characteristics. 1.3.1.1 The output jitter shall not exceed 0.75 UI under worst case operating conditions when measured in the frequency range 20 Hz to 100 KHz, as defined in ITU-T G.921 table 3. 1.3.1.2 The tolerance of both the LIME and the Telco input ports to jitter should be as defined in ITU-T Recommendation G.823. 1.3.1.3 A jitter measuring set conforming to the requirements of ITU-T Recommendation O.171 (Timing Jitter Measuring Equipment for Digital Systems) shall be used to measure jitter. LIME and the Telco shall co-operate in the application of testing methods as described in ITU-T Recommendation G.823. 1.3.1.4 The wander specification is set out in ITU-T recommendation G.823. The maximum values of wander at input ports must conform to section 3.1.1 of ITU-T Recommendation G.823.

Electrical characteristics. 1.3.1.1 The output jitter shall not exceed 0.75 UI under worst case operating conditions when measured in the frequency range 20 Hz to 100 KHzkHz, as defined in ITU-T G.921 table 3. 1.3.1.2 The tolerance of both the LIME and the Telco input ports to jitter should be as defined in ITU-T Recommendation G.823. 1.3.1.3 A jitter measuring set conforming to the requirements of ITU-T Recommendation O.171 (Timing Jitter Measuring Equipment for Digital Systems) shall be used to measure jitter. LIME and the Telco shall co-operate in the application of testing methods as described in ITU-T Recommendation G.823. 1.3.1.4 The wander specification is set out in ITU-T recommendation G.823. The maximum values of wander at input ports must conform to section 3.1.1 of ITU-T Recommendation G.823.