Computer Equipment Recycling Program If this Contract is for the purchase or lease of computer equipment, then Contractor certifies that it is in compliance with Subchapter Y, Chapter 361 of the Texas Health and Safety Code related to the Computer Equipment Recycling Program and the Texas Commission on Environmental Quality rules in 30 TAC Chapter 328.
Needs Improvement the Educator’s performance on a standard or overall is below the requirements of a standard or overall, but is not considered to be unsatisfactory at this time. Improvement is necessary and expected.
Selection of Subcontractors, Procurement of Materials and Leasing of Equipment The contractor shall not discriminate on the grounds of race, color, religion, sex, national origin, age or disability in the selection and retention of subcontractors, including procurement of materials and leases of equipment. The contractor shall take all necessary and reasonable steps to ensure nondiscrimination in the administration of this contract.
a. The contractor shall notify all potential subcontractors and suppliers and lessors of their EEO obligations under this contract.
b. The contractor will use good faith efforts to ensure subcontractor compliance with their EEO obligations.
Testing of Metering Equipment Connecting Transmission Owner shall inspect and test all of its Metering Equipment upon installation and at least once every two (2) years thereafter. If requested to do so by NYISO or Developer, Connecting Transmission Owner shall, at Developer’s expense, inspect or test Metering Equipment more frequently than every two (2) years. Connecting Transmission Owner shall give reasonable notice of the time when any inspection or test shall take place, and Developer and NYISO may have representatives present at the test or inspection. If at any time Metering Equipment is found to be inaccurate or defective, it shall be adjusted, repaired or replaced at Developer’s expense, in order to provide accurate metering, unless the inaccuracy or defect is due to Connecting Transmission Owner’s failure to maintain, then Connecting Transmission Owner shall pay. If Metering Equipment fails to register, or if the measurement made by Metering Equipment during a test varies by more than two percent from the measurement made by the standard meter used in the test, Connecting Transmission Owner shall adjust the measurements by correcting all measurements for the period during which Metering Equipment was in error by using Developer’s check meters, if installed. If no such check meters are installed or if the period cannot be reasonably ascertained, the adjustment shall be for the period immediately preceding the test of the Metering Equipment equal to one-half the time from the date of the last previous test of the Metering Equipment. The NYISO shall reserve the right to review all associated metering equipment installation on the Developer’s or Connecting Transmission Owner’s property at any time.
Alterations, Additions, and Improvements Tenant shall not make any alterations, additions or improvements which affect the structure of the Building or which decrease the square footage of the Building or which reduce the value of the Premises, in each case without the prior written consent of Landlord, which consent shall not be unreasonably withheld, conditioned or delayed. Notwithstanding the above, and provided Tenant complies with all Legal Requirements in connection therewith, Tenant shall have the right at all times to make all other alterations, additions or improvements to the Building without Landlord’s prior written approval. Tenant shall not be required to restore any alterations or additions permitted under this paragraph to the Premises or remove improvements at the end of the Term. All alterations, additions and improvements permitted under this paragraph or consented to in writing by Landlord are referred to as “Permitted Alterations”. All alterations, additions or improvements made by Tenant which are permanently attached to and made part of the Premises shall become the property of Landlord at the expiration of the Term, except for signs, trade fixtures, furnishings, machinery and equipment used in or on the Premises and furnished by Tenant which Tenant may remove, provided Tenant repairs any damage to the Premises caused thereby (reasonable and ordinary wear and tear excepted). For federal income tax purposes, Tenant’s signs, trade fixtures and furnishings are defined herein as equipment. Tenant shall pay, when due, all claims for labor or materials furnished or alleged to have been furnished to or for Tenant for use in the Premises, which claims are or may be secured by any mechanics’ or materialmen’s lien against the Premises or any interest therein.
