Determination of the Material Plate Change Payment Sample Clauses

Determination of the Material Plate Change Payment. (a) To claim a Material Plate Change Payment, the Concessionaire must within 120 Business Days following the occurrence of the relevant Material Plate Change, give notice to the RTA in writing setting out the full particulars of the impact of the Material Plate Change on the SNP Business and the SNP Revenue and an estimate of the amount of the Material Plate Change Payment (if any) (a Material Plate Change Notice).
AutoNDA by SimpleDocs

Related to Determination of the Material Plate Change Payment

  • Contract Renegotiation, Suspension, or Termination Due to Change in Funding If the funds DSHS relied upon to establish this Contract or Program Agreement are withdrawn, reduced or limited, or if additional or modified conditions are placed on such funding, after the effective date of this contract but prior to the normal completion of this Contract or Program Agreement:

  • Independence from Material Breach Determination Except as set forth in Section X.D.1.c, these provisions for payment of Stipulated Penalties shall not affect or otherwise set a standard for OIG’s decision that CHSI has materially breached this CIA, which decision shall be made at OIG’s discretion and shall be governed by the provisions in Section X.D, below.

  • Average Log Length and Payment Reduction If the average log length for all logs delivered under this contract is less than the average log length specified in the table in clause G-024.2, The amount of allowable payment reduction shall be calculated by multiplying the payment rate in P-028.2 by the total volume delivered, and the difference between the average length of logs delivered and the average log length specified in G-024.2, times 1% as follows: Log Length Payment Reduction = (B x V x L) x (.01) 1/10th) Where: B = Bid rate from P-028.2 clause V = total delivered log Volume L = Length in feet below specified average (rounded to nearest Average log length payment reductions calculated by the Purchaser must be approved by the State, prior to payment for the final billing period. Third-party scaling organization information is required to determine Xxxxxxxx mbf and Average log length for payment reduction purposes. Average log length is determined on a piece count basis. Value of log length price reduction will be derived from the applicable sort value as described in this contract. Scale information for determining Average log length for payment reduction eligibility must be obtained from roll-out scale. Truck-ramp, sample scaling, and/or bundle scaling information is not acceptable for determining eligibility. Purchaser’s exclusive remedy for below average log lengths shall be the payment reduction described in this clause, notwithstanding other provisions in the Uniform Commercial Code.

  • TERMINATION DUE TO CHANGE IN FUNDING ‌ 35 In the event funding from HCA, MCO, State, Federal, or other sources is withdrawn, reduced, or limited 36 in any way after the effective date of this Contract and prior to its normal completion, either party may 37 terminate this Contract subject to re-negotiations.

  • Determination Final The determination by Xxxxxxx Mac or the Global Agent of the interest rate on the Notes and the determination of any payment on any Note (or any interim calculation in the determination of any such interest rate, index or payment) shall, absent manifest error, be final and binding on all parties. If a principal or interest payment error occurs, Xxxxxxx Mac or the Global Agent may correct it by adjusting payments to be made on later Payment Dates or in any other manner Xxxxxxx Mac or the Global Agent considers appropriate. If the source of One-Month LIBOR changes in format, but Xxxxxxx Mac or the Global Agent determines that the source continues to disclose the information necessary to determine the related Class Coupon substantially as required, Xxxxxxx Mac will amend the procedure for obtaining information from that source to reflect the changed format. All One-Month LIBOR values used to determine interest payments are subject to correction within 30 days from the applicable payment. The source of a corrected value must be the same source from which the original value was obtained. A correction might result in an adjustment on a later date to the amount paid to the Holder.

  • Penalty Determination H&SC section 39619.7 requires CARB to provide information on the basis for the penalties it seeks. This Agreement includes this information, which is also summarized here. The provision of law the penalty is being assessed under and why that provision is most appropriate for that violation. The penalty provision being applied in this case is H&SC section 42402 et seq. because IIT sold, supplied, offered for sale, consumer products for commerce in California in violation of the Consumer Products Regulations (17 CCR section 94507 et seq.). The penalty provisions of H&SC section 42402 et seq. apply to violations of the Consumer Products Regulations because the regulations were adopted under authority of H&SC section 41712, which is in Part 4 of Division 26. The manner in which the penalty amount was determined, including aggravating and mitigating factors and per unit or per vehicle basis for the penalty. H&SC section 42402 et seq. provides strict liability penalties of up to $10,000 per day for violations of the Consumer Product Regulations with each day being a separate violation. In cases like this, involving unintentional violations of the Consumer Products Regulations where the violator cooperates with the investigation, CARB has obtained penalties for selling uncertified charcoal lighter material in California. In this case, the total penalty is $7,500 for selling uncertified charcoal lighter material in California. The penalty in this case was reduced because this was a strict liability first-time violation and IIT made diligent efforts to cooperate with the investigation. To come into compliance, IIT no longer offers Safegel BBQ & Fireplace Lighting Gel Fire Starter for commerce in California. Final penalties were determined based on the unique circumstances of this matter, considered together with the need to remove any economic benefit from noncompliance, the goal of deterring future violations and obtaining swift compliance, the consideration of past penalties in similar negotiated cases, and the potential cost and risk associated with litigating these particular violations. The penalty reflects violations extending over a number of days resulting in quantifiable harm to the environment considered together with the complete circumstances of this case. Penalties in future cases might be smaller or larger on a per ton basis. The final penalty in this case was based in part on confidential financial information or confidential business information provided by IIT that is not retained by CARB in the ordinary course of business. The penalty in this case was also based on confidential settlement communications between CARB and IIT that CARB does not retain in the ordinary course of business. The penalty also reflects CARB’s assessment of the relative strength of its case against IIT, the desire to avoid the uncertainty, burden and expense of litigation, obtain swift compliance with the law and remove any unfair advantage that IIT may have secured from its actions. Is the penalty being assessed under a provision of law that prohibits the emission of pollution at a specified level, and, if so a quantification of excess emissions, if it is practicable to do so. The Consumer Product Regulations do not prohibit emissions above a specified level, but they do limit the concentration of VOCs in regulated products. In this case, a quantification of the excess emissions attributable to the violations was not practicable.

  • Termination Due To Lack Of Funding Appropriation If, in the judgment of the Director of Accounts and Reports, Department of Administration, sufficient funds are not appropriated to continue the function performed in this agreement and for the payment of the charges hereunder, State may terminate this agreement at the end of its current fiscal year. State agrees to give written notice of termination to contractor at least 30 days prior to the end of its current fiscal year, and shall give such notice for a greater period prior to the end of such fiscal year as may be provided in this contract, except that such notice shall not be required prior to 90 days before the end of such fiscal year. Contractor shall have the right, at the end of such fiscal year, to take possession of any equipment provided State under the contract. State will pay to the contractor all regular contractual payments incurred through the end of such fiscal year, plus contractual charges incidental to the return of any such equipment. Upon termination of the agreement by State, title to any such equipment shall revert to contractor at the end of the State's current fiscal year. The termination of the contract pursuant to this paragraph shall not cause any penalty to be charged to the agency or the contractor.

  • TERMINATION OF THE MOU Either Party may terminate this MOU through written notice to the other party given not later than the last calendar day in December and to be effective for the ensuing academic fall semester. In the event of termination, the School District, School and College will prepare an agreeable plan of dissolution in accordance with all Applicable Laws to be submitted and approved by the authorized representatives from both Parties as listed herein.

  • Deviation from Grievance Procedure The Employer agrees that, after a grievance has been discussed at Step 2 of the grievance procedure the Employer or his representatives shall not initiate any discussion or negotiations with respect to the grievance, either directly or indirectly with the aggrieved employee without the consent of the xxxxxxx or the Union.

  • INDEPENDENT PRICE DETERMINATION 6.1 By signing and submitting this bid, the Bidder certifies that the prices in this bid have been arrived at independently, without consultation, communication or agreement, for the purpose of restricting competition, as to any matter relating to such prices with any other Bidder or with any competitor; unless otherwise required by law, the prices which have been quoted in this bid have not been knowingly disclosed by the Bidder prior to bid opening directly or indirectly to any other Bidder or to any competitor; no attempt has been made, or will be made, by the Bidder to induce any person or firm to submit, or not to submit, a bid for the purpose of restricting competition.

Time is Money Join Law Insider Premium to draft better contracts faster.