Citation of Departmental or Institutional Needs
Citation of Departmental or Institutional Needs Sample Clauses
Related to Citation of Departmental or Institutional Needs
Department of State Registration Consistent with Title XXXVI, F.S., the Contractor and any subcontractors that assert status, other than a sole proprietor, must provide the Department with conclusive evidence of a certificate of status, not subject to qualification, if a Florida business entity, or of a certificate of authorization if a foreign business entity.
International or National Shopping Goods estimated to cost less than $30,000 equivalent per contract may be procured under contracts awarded on the basis of international or national shopping procedures in accordance with the provisions of paragraphs 3.5 and 3.6 of the Guidelines.
Organization of Company The Company, a corporation duly organized, validly existing and in good standing under the laws of the State of Illinois and the Company is legally qualified to transact business in Illinois. The Company has full power and authority to own or lease and to operate and use its assets and to carry on its business at the Project. There is no pending or threatened proceeding for the dissolution, liquidation, insolvency, or rehabilitation of the Company.
COMMISSIONER OR AUTHORIZED USER Contractor warrants, covenants and represents that any confidential information obtained by Contractor, its agents, Subcontractors, officers, distributors, resellers or employees in the course of performing its obligations, including without limitation, security procedures, business operations information, or commercial proprietary information in the possession of the State or any Authorized User hereunder or received from another third party, will not be divulged to any third parties without the written consent of the Commissioner or Authorized User. Contractor shall not be required to keep confidential any such material that is publicly available through no fault of Contractor, independently developed by Contractor without reliance on confidential information of the Authorized User, or otherwise obtained under the Freedom of Information Law or other applicable New York State laws and regulations. This warranty shall survive termination of this Contract. Contractor further agrees to take commercially reasonable steps to inform its agents, Subcontractors, officers, distributors, resellers or employees of the obligations arising under this clause to ensure such confidentiality.
Formation of Company The Company was formed on February 23, 2017 pursuant to the provisions of the Delaware Act. The filing of the Certificate of Formation of the Company with the Secretary of State of the State of Delaware are hereby ratified and confirmed in all respects.
Commissioner or Authorized User Contractor further warrants, covenants and represents that any confidential information obtained by Contractor, its agents, Subcontractors, officers, distributors, resellers or employees in the course of performing its obligations, including without limitation, security procedures, business operations information, or commercial proprietary information in the possession of the State or any Authorized User hereunder or received from another third party, will not be divulged to any third parties. Contractor shall not be required to keep confidential any such material that is publicly available through no fault of Contractor, independently developed by Contractor without reliance on confidential information of the Authorized User, or otherwise obtained under the Freedom of Information Act or other applicable New York State laws and regulations. This warranty shall survive termination of this Contract. Contractor further agrees to take appropriate steps as to its agents, Subcontractors, officers, distributors, resellers or employees regarding the obligations arising under this clause to insure such confidentiality.
Restriction on Sale of Securities by Company For the period specified below (the “Lock-Up Period”), the Company will not, directly or indirectly, take any of the following actions with respect to its Securities or any securities convertible into or exchangeable or exercisable for any of its Securities (“Lock-Up Securities”): (i) offer, sell, issue, contract to sell, pledge or otherwise dispose of, directly or indirectly, Lock-Up Securities, (ii) offer, sell, issue, contract to sell, contract to purchase or grant any option, right or warrant to purchase Lock-Up Securities, (iii) enter into any swap, hedge or any other agreement that transfers, in whole or in part, any of the economic consequences of ownership of Lock-Up Securities, (iv) establish or increase a put equivalent position or liquidate or decrease a call equivalent position in Lock-Up Securities within the meaning of Section 16 of the Exchange Act or (v) file with the Commission a registration statement under the Act relating to Lock-Up Securities, or publicly disclose the intention to take any such action, without the prior written consent of the Representative (whether any transaction mentioned in (i) through (iii) is to be settled by delivery of the Securities or such other securities, in cash or otherwise), except (A) the issuance of Lock-Up Securities pursuant to the terms of an employee benefit plan, qualified stock option plan or other director or employee compensation plan, or an agreement existing pursuant to such plan, in effect on the date hereof, (B) the performance by the Company of its obligations under the registration rights agreements between the Company and the Selling Stockholder or the certificate of designations for the Company’s Class A Convertible Preferred Stock, each as disclosed in the General Disclosure Package, or (C) the issuance of Lock-Up Securities in an amount not to exceed in the aggregate 15% of the Company’s outstanding common stock on the date hereof as consideration in, or in a capital raising transaction the proceeds of which are used for, any merger, acquisition or other business combination, subject to the recipients of such issuance being bound by the terms of a similar lock-up agreement and no public disclosure being made in connection with such issuance during the Lock-Up Period unless required under the Exchange Act. The initial Lock-Up Period will commence on the date hereof and continue for 90 days after the date hereof or such earlier date that the Representative agrees to in writing; provided, however, that if (1) during the last 17 days of the initial Lock-Up Period, the Company releases earnings results or material news or a material event relating to the Company occurs or (2) prior to the expiration of the initial Lock-Up Period, the Company announces that it will release earnings results during the 16-day period beginning on the last day of the initial Lock-Up Period, then in each case the Lock-Up Period will be extended until the expiration of the 18-day period beginning on the date of release of the earnings results or the occurrence of the materials news or material event, as applicable, unless the Representative waives, in writing, such extension. The Company will provide the Representative with notice of any announcement described in clause (2) of the preceding sentence that gives rise to an extension of the Lock-Up Period.
REGISTRATION WITH DEPARTMENT OF REVENUE The CONTRACTOR shall complete registration with the Washington State Department of Revenue and be responsible for payment of all taxes due on payments made under this contract.
Proof of Execution of Instruments and of Holding of Securities Subject to Sections 6.1 and 6.2, the execution of any instrument by a Securityholder or his agent or proxy may be proved in the following manner:
200 Domestic Preferences for Procurements As appropriate and to the extent consistent with law, the non-Federal entity should, to the greatest extent practicable under a Federal award, provide a preference for the purchase, acquisition, or use of goods, products, or materials produced in the United States (including but not limited to iron, aluminum, steel, cement, and other manufactured products). The requirements of this section must be included in all subawards including all contracts and purchase orders for work or products under this award. For purposes of 2 CFR Part 200.322, “Produced in the United States” means, for iron and steel products, that all manufacturing processes, from the initial melting stag through the application of coatings, occurred in the United States. Moreover, for purposes of 2 CFR Part 200.322, “Manufactured products” means items and construction materials composed in whole or in part of non-ferrous metals such as aluminum, plastics and polymer-based products such as polyvinyl chloride pipe, aggregates such as concrete, glass, including optical fiber, and lumber. Pursuant to the above, when federal funds are expended by ESC Region 8 and TIPS Members, Vendor certifies that to the greatest extent practicable Vendor will provide a preference for the purchase, acquisition, or use of goods, products, or materials produced in the United States (including but not limited to iron, aluminum, steel, cement, and other manufactured products). Does vendor agree? Yes
