Bolts Sample Clauses
The 'Bolts' clause defines the specifications, standards, or requirements for bolts used in a project or contract. It typically outlines the types, sizes, materials, and quality standards that bolts must meet, and may specify testing, certification, or installation procedures. By clearly detailing these requirements, the clause ensures that all bolts used are suitable for their intended purpose, thereby promoting safety, reliability, and compliance with industry standards.
Bolts. All main case bolts shall be of 300 series non-magnetic stainless steel to prevent corrosion.
Bolts. Kg 3 390 x 180 x 6mm Shaped connector plate, four times holed for bolts and welded to post (bolts and holes elsewhere measured). No
Bolts. These are of two types namely turned and fitted bolts and black bolts. Turned & fitted bolts are turned to exact diameter in automatic lathe. For these bolts, whether reamed or drilled bolts, the same unit stresses are allowed as for rivets. In case of black bolts which are not finished to exact sizes, a lower working stress other than for turned bolts is adopted. They shall conform to IS 1367 – Technical supply conditions for threaded steel fasteners.
Bolts. ▇▇▇▇ plates and steady bearings shall be attached to the tank using 316 stainless steel anchors set in holes drilled by the Contractor under this Contract.
Bolts. (1) The Engineer will randomly select at least five bolts for test purposes from each bin of bolts furnished.
Bolts. A. Bolts, nuts, and washers for stainless steel flange assemblies and stainless steel couplings: Same material, conforming to ASTM A320 for low-temperature service and ASTM A193 and ASTM A194 for high-temperature service.
1. Bolts, nuts and washers for other couplings: As specified in referenced paragraphs for the couplings.
Bolts. Standard mild steel, square or hexagonal head machine bolts with matching nuts and cut washers, or carriage bolts with square nuts and cut washers as indicated.