Posted Speed Limit definition

Posted Speed Limit. : means the speed limit indicated by the numerals on the speed limit sign or 50 kilometres per hour in the absence of a speed limit sign in a built-up area.
Posted Speed Limit means the speed prescribed for motor vehicles on a section of road by municipal by-law and signed accordingly.
Posted Speed Limit means the maximum rate of speed prescribed under section 128 of the Act for a highway or portion of a highway.

Examples of Posted Speed Limit in a sentence

  • Posted Speed Limit – 30 mph Posted or prima facie speeds shall be the same as the design speed.

  • Posted Speed Limit – 25 mph Posted or prima facie speeds for local street classifications shall be the same as the design speed of that street.

  • The following restrictions, based on the type of roadway, will apply: Roadways with Posted Speed Limit of 55 Mph or Greater The Contractor shall install asphalt concrete overlays to the depths specified for the specific routes identified in the Contract.

  • Design Speed and Posted Speed Limit: Design speed is a selected speed used to determine the various geometric design features of a roadway.

  • Non-Limited Access Roadways with an ADT of 10,000 or Greater (Traffic Group XV and above) and a Posted Speed Limit of 45 Mph or Greater 1.

  • Posted Speed Limit (mph) 25303540455055Sight Distance (ft.) 250300350400450500550 Where necessary, corner lots shall be cleared of all growth and sight obstructions, including ground excavation, to achieve the required visibility.

  • Posted Speed Limit – 30-40 mph Posted or prima facie speeds for the various street classifications shall be five (5) mph less than the design speed of that street.

  • Posted Speed Limit – 35-45 mph Actual posted speed to be determined by the City Engineer prior to submittal of construction plans.

  • Posted Speed Limit (mph):Input the highest posted speed within the project limits.

  • Posted Speed Limit (mph)25303540455055Sight Distance250300350400450500550 Where necessary, corner lots shall be cleared of all growth and sight obstructions, including ground excavation, to achieve the required visibility.

Related to Posted Speed Limit

  • Concentration Limit means at any time for any Obligor, the product of (i) such Obligor’s Specified Concentration Percentage, times (ii) the aggregate Unpaid Balance of the Eligible Receivables included in the Receivables Pool at the time of determination.

  • Aggregate Overcollateralization Release Amount With respect to any Distribution Date, the lesser of (x) the aggregate of the Principal Remittance Amounts for each Mortgage Pool for such Distribution Date and (y) the amount, if any, by which (i) the Overcollateralization Amount for such date, calculated for this purpose on the basis of the assumption that 100% of the aggregate of the Principal Remittance Amounts for such Distribution Date is applied on such date in reduction of the aggregate Certificate Principal Amount of the Certificates, exceeds (ii) the Targeted Overcollateralization Amount for such Distribution Date.

  • Maximum contaminant level (MCL) means the maximum permissible level of a contaminant in water which is delivered to any user of a public water system.

  • Sub-Limit means a cost sharing requirement under a health insurance policy in which an Insurer would not be liable to pay any amount in excess of the pre-defined limit.

  • Prescribed Limit means ten per cent (10%) of the issued ordinary share capital of the Company as at the date of passing of this resolution unless the Company has effected a reduction of the share capital of the Company in accordance with the applicable provisions of the Companies Law, at any time during the Relevant Period, in which event the issued ordinary share capital of the Company shall be taken to be the amount of the issued ordinary share capital of the Company as altered (excluding any treasury share that may be held by the Company from time to time); and

  • Annual limit on intake or "ALI" means the derived limit for the amount of radioactive material taken into the body of an adult worker by inhalation or ingestion in a year. ALI is the smaller value of intake of a given radionuclide in a year by the reference man that would result in a committed effective dose equivalent of 0.05 sievert (five rem) or a committed dose equivalent of 0.5 sievert (fifty rem) to any individual organ or tissue. ALI values for intake by ingestion and by inhalation of selected radionuclides are given in appendix C to rule 3701:1-38-12 of the Administrative Code.

  • Loan Limit means, at any time, the lesser of (a) the Total Commitment at such time and (b) the Borrowing Base at such time (including as it may be reduced pursuant to Section 2.14(h)).

  • Collateral Deficiency Amount With respect to any AB Modified Loan as of any date of determination, the excess of (i) the Stated Principal Balance of such AB Modified Loan (taking into account the related junior note(s) included therein), over (ii) the sum of (in the case of a Loan Combination, solely to the extent allocable to the subject Mortgage Loan) (x) the most recent Appraised Value for the related Mortgaged Property or Mortgaged Properties, plus (y) solely to the extent not reflected or taken into account in such Appraised Value and to the extent on deposit with, or otherwise under the control of, the lender as of the date of such determination, any capital or additional collateral contributed by the related Mortgagor at the time the Mortgage Loan became (and as part of the modification related to) such AB Modified Loan for the benefit of the related Mortgaged Property or Mortgaged Properties (provided, that in the case of an Outside Serviced Mortgage Loan, the amounts set forth in this clause (y) will be taken into account solely to the extent relevant information is received by the Special Servicer), plus (z) any other escrows or reserves (in addition to any amounts set forth in the immediately preceding clause (y)) held by the lender in respect of such AB Modified Loan as of the date of such determination. The Certificate Administrator, the Master Servicer and the Operating Advisor (other than with respect to any Collateral Deficiency Amount calculations that the Operating Advisor is required to review, recalculate and/or verify pursuant to Section 3.29) shall be entitled to conclusively rely on the Special Servicer’s calculation or determination of any Collateral Deficiency Amount.

  • Lower explosive limit (LEL) means the concentration of a compound in air below which a flame will not propagate if the mixture is ignited.

  • Overcollateralization Release Amount With respect to any Distribution Date, the lesser of (x) the Principal Remittance Amount for such Distribution Date and (y) the Excess Overcollateralized Amount.

  • Total Available Funds shall have the meaning set forth in Section 5.7(a).

  • Concentration Limits has the meaning given to such term in Section 5.03(a) hereof.

  • Stepdown Date The earlier to occur of (i) the first Distribution Date on which the aggregate Certificate Principal Balance of the Class A Certificates has been reduced to zero and (ii) the later to occur of (a) the Distribution Date occurring in March 2006 and (b) the first Distribution Date on which the Credit Enhancement Percentage (calculated for this purpose only after taking into account distributions of principal on the Mortgage Loans but prior to any distribution of the Principal Distribution Amount to the Certificates then entitled to distributions of principal on such Distribution Date) is equal to or greater than 37.00%.

  • Credit Support Amount has the meaning specified in Paragraph 3.

  • Retained limit means the greater of:

  • Target Overcollateralization Amount means, with respect to any Payment Date, 3.00% of the Adjusted Pool Balance as of the Cutoff Date. Notwithstanding the foregoing, the Target Overcollateralization Amount shall not exceed the Adjusted Pool Balance on such Payment Date.

  • Upper Limit means a specified maximum amount of costs which may be claimed under a Unit of Work, but which may be extended on application. An Upper Limit operates in the same way as a Costs Limitation;

  • Senior Credit Support Depletion Date The date on which the Class Certificate Balance of each Class of Subordinated Certificates has been reduced to zero.

  • Credit Support Depletion Date The first Distribution Date on which the Certificate Principal Balances of the Subordinate Certificates have been reduced to zero.

  • Overcollateralization Deficiency Amount With respect to any Distribution Date, the amount, if any, by which the Overcollateralization Target Amount exceeds the Overcollateralized Amount on such Distribution Date (assuming that 100% of the Principal Remittance Amount is applied as a principal distribution on such Distribution Date).

  • Yield Supplement Overcollateralization Amount means, with respect to any calendar month and the related Payment Date, or with respect to the Closing Date, the aggregate amount by which the Principal Balance as of the last day of the related Collection Period or the Cutoff Date, as applicable, of each of the related Receivables with an APR as stated in the related contract of less than the Required Rate, other than Defaulted Receivables, exceeds the present value, calculated by using a discount rate equal to the Required Rate, of each scheduled payment of each such Receivables assuming such scheduled payment is made on the last day of each month and each month has 30 days.

  • Concentration Limitations has the meaning set forth in Schedule 4.

  • Targeted Overcollateralization Amount means, for a Payment Date, an amount equal to:

  • Plantwide applicability limitation (PAL means an emission limitation expressed in tons per year, for a pollutant at a major stationary source, that is enforceable as a practical matter and established source-wide in accordance with Chapter 19, section 011.

  • Delinquency Amount means, as of any Distribution Date, the Principal Balance of all Contracts that were delinquent 60 days or more as of the end of the related Due Period (including Contracts in respect of which the related Motorcycles have been repossessed and are still in inventory).

  • emission limit value means the mass, expressed in terms of certain specific parameters, concentration and/or level of an emission, which may not be exceeded during one or more periods of time;