Pleasant Valley definition
Examples of Pleasant Valley in a sentence
The Facilities Study identified certain Network Upgrade Facilities at Central ▇▇▇▇▇▇’▇ ▇▇▇▇▇ 115 kV Substation, North Catskill Substation, Pleasant Valley 115 kV Substation, Rock Tavern 345 kV and 115 kV Substations, and Roseton 345 kV Substation that are required to reliably interconnect the Transmission Project to Central ▇▇▇▇▇▇’▇ system.
The following milestones shall apply to the construction and interconnection of the Large Generating Facility, the new second conductor to Pleasant Valley, the reconductored segment of Feeder 398, and the remote end relay protection upgrades.
All work, including engineering and design, that may be required at the Pleasant Valley Substation related to the installation of a new feeder and/or modifications to existing Feeder 398 are not included in the engineering services described in this Section 5.
The operation of the SPS will allow postcontingency loading of either the Leeds to Pleasant Valley or Athens to Pleasant Valley 345 kV lines (Lines 91 and 92) up to their STE ratings for outage of the other line.
Case with SPS with Athens dispatched at 1080 MW The redispatch performed to increase flow on the Athens-Pleasant Valley and Leeds- Pleasant Valley (Lines 91 and 92) path to determine the thermal transfer limit first increased Athens to full power output with subsequent generation shifts from Ontario to Con Ed to increase the transfer level on the interface concerned as shown in Table 4-1.
The contingencies include three-phase faults on all 345 kV buses in the Leeds, Athens and Pleasant Valley substations and also stuck breaker faults on each bus section.
The Transmission Developer shall provide an interconnection point between its OPGW and Connecting Transmission Owner’s fiber optic cable and equipment at the Pleasant Valley Substation or just outside of the Pleasant Valley Substation.
Without this capacitor bank, the voltages at the Pleasant Valley, Millwood, Sprain Brook and ▇▇▇▇▇▇▇▇▇ stations are below 348 kV (a recently updated pre-contingency low voltage limit for these stations).
The normal transfer limit is the transfer level at which: a branch has reached its normal rating for pre-contingency conditions, or a branch has reached its LTE rating following a contingency, except that the SPS will allow post-contingency loading of either the Leeds to Pleasant Valley or Athens to Pleasant Valley 345 kV lines (Lines 91 and 92) up to their STE ratings for outage of the other line.
Case with SPS with Athens dispatched at 1080 MW and a 240 MVAr capacitor bank installed at Millwood A series of power flow cases were created with increasing transfer levels on Leeds - Pleasant Valley using generation shifts similar to those used for the thermal analysis.