Examples of Detection Limits in a sentence
Estimating Mean Concentrations Under Transformations for Environmental Data With Detection Limits.
The Permittee shall use an analytical method prescribed in A.A.C. R9-14-610, 40 CFR 136.3, or an alternative analytical method approved under A.A.C. R9-14-610(C) with test methods with Method Detection Limits (MDLs) and Minimum Levels (MLs) that are lower than the applicable SWQS.
B., "Minimum Detection Limits for Saltstone Quarterly WAC Analyses", Savannah River Remediation, SRR-WSE-2013-00005, Rev.
Detection Limits The reference laboratory LRLs for the target analytes are listed in Table 3-2.
Jenkins, "Comparison of Low Concentration Measurement Capability Estimates in Trace Analysis: Method Detection Limits and Certified Reporting Limits," USACE Cold Regions Research and Engineering Laboratory, Special Report 89-20, 1989.
Minimum Detection Limits - all groundwater quality analyses reported shall have a minimum detection limit or reporting limit that is less than its respective Ground Water Compliance Limit concentration defined in Table 2.
Required Analytical Methods, Detection Limits, Hold Times, and Preservatives4 Analyte or ParameterAnalytical MethodDetection LimitMax.
Table 1—Chromatographic Conditions and Method Detection Limits Column 1 conditions: Supelcoport (100 / 120 mesh) coated with 1.5% SP-2250 / 1.95% SP-2401 packed in a 1.8 m long x 4 mm ID glass column with 5% methane / 95% argon carrier gas at 60 mL / min.
Method Detection Limits (MDLs) – Initial MDLs should beestablished for NO3+NO2 using a spiked water sample, typically two to 10 times the estimated MDL and no more than ten times higher than the estimated MDL.
These samples can be used for averaging if they are conducted using EPA- approved test methods (generally found in 40 CFR 136) and if the Method Detection Limits are less than the effluent limits.