Crystal Ball Sample Clauses

Crystal Ball. An extension of the theoretical approach used for the hadronic decays of the η meson will be applied for the interpretation of the η' meson decays η'→ππη and η'→πππ (task leader ▇. ▇▇▇▇▇, UBO).
View Source
Crystal Ball. Main Hall maintenance closet. On the back wall turn switch to “on”. Light control panel on the stage needs to be plugged in with all rocker switches in neutral position. Channel 1 and 2 controls spot lights on the ball. Entry Lights – Left entry wall, looking at the Main Hall doorway. Exterior courtesy lights – Outside front wall as you look at the main door. Dining Hall Lights – Base of front stairwell, far facing wall. Kitchen Lights- Switch on southerly wall of dining room and pull chains over sinks. Main Hall Lights – Immediately to the right as you enter the Main Hall. Rotary dimmer switch. Stage Lights – Through northerly door from Main Hall up the stage steps to the right. Stairway Lights (front) – Left entry wall as you face the Main Hall doorway from the foyer. Stairway Lights (rear) – Sensor light, no switch. Exhaust Fan for Main Hall – Through northerly door from Main Hall up stage steps on the right. Sump Pump (kitchen sinks) – Left end of the stainless steel counter along the south wall. Basement sinks are below ground level and a pump is used for draining the sinks. Turn the pump on when water starts backing up into the bottoms of the sinks. Turn it off a couple minutes after water is removed.
View Source

Related to Crystal Ball

  • Spares/bunkers, etc The Sellers shall deliver the Vessel to the Buyers with everything belonging to her on board and on shore. All spare parts and spare equipment including spare tail-end shaft(s) and/or spare propeller(s)/propeller blade(s), if any, belonging to the Vessel at the time of inspection used or unused, whether on board or not shall become the Buyers' property, but spares on order are to be excluded. Forwarding charges, if any, shall be for the Buyers' account. The Sellers are not required to replace spare parts including spare tail-end shaft(s) and spare propeller(s)/propeller blade(s) which are taken out of spare and used as replacement prior to delivery, but the replaced items shall be the property of the Buyers. The radio installation and navigational equipment shall be included in the sale without extra payment if they are the property of the Sellers. Unused stores and provisions shall be included in the sale and be taken over by the Buyers without extra payment. The Sellers have the right to take ashore crockery, plates, cutlery, linen and other articles bearing the Sellers' flag or name, provided they replace same with similar unmarked items. Library, forms, etc., exclusively for use in the Sellers' vessel(s), shall be excluded without compensation. Captain's, Officers' and Crew's personal belongings including the slop chest are to be excluded from the sale, as well as the following additional items (including items on hire): Please see Clause 19 The Buyers bunkers are the Charterers property and are to be excluded from the sale. The shall take over the remaining bunkers and unused lubricating oils in storage tanks and sealed drums shall remain the property of the sellers. Vessel’s new managers will pay sellers for these lubricating oils at net contract price as and when they are broached and pay the current net market price (excluding barging expenses) at the port and date of delivery of the Vessel. Payment under this Clause shall be made at the same time and place and in the same currency as the Purchase Price.

  • Check Meters Developer, at its option and expense, may install and operate, on its premises and on its side of the Point of Interconnection, one or more check meters to check Connecting Transmission Owner’s meters. Such check meters shall be for check purposes only and shall not be used for the measurement of power flows for purposes of this Agreement, except as provided in Article 7.4 below. The check meters shall be subject at all reasonable times to inspection and examination by Connecting Transmission Owner or its designee. The installation, operation and maintenance thereof shall be performed entirely by Developer in accordance with Good Utility Practice.

  • Preservative-treated Wood Containing Arsenic Grantee may not purchase preservative-treated wood products containing arsenic in the performance of this Agreement unless an exemption from the requirements of Chapter 13 of the San Francisco Environment Code is obtained from the Department of the Environment under Section 1304 of the Code. The term “preservative-treated wood containing arsenic” shall mean wood treated with a preservative that contains arsenic, elemental arsenic, or an arsenic copper combination, including, but not limited to, chromated copper arsenate preservative, ammoniacal copper zinc arsenate preservative, or ammoniacal copper arsenate preservative. Grantee may purchase preservative-treated wood products on the list of environmentally preferable alternatives prepared and adopted by the Department of the Environment. This provision does not preclude Grantee from purchasing preservative-treated wood containing arsenic for saltwater immersion. The term “saltwater immersion” shall mean a pressure-treated wood that is used for construction purposes or facilities that are partially or totally immersed in saltwater.

  • Appointment Above Entrance Rate 242. Appointments may be made by an appointing officer at any step in the salary grade upon the approval of the Human Resources Director under one or more of the following conditions: a. A former permanent City employee, following resignation with service satisfactory, is being reappointed to a permanent position in his/her former classification. 244. b. Loss of compensation would result if appointee accepts position at the normal step.

  • How to get a TIN If you do not have a TIN, apply for one immediately. To apply for an SSN, get Form SS-5, Application for a Social Security Card, from your local SSA office or get this form online at ▇▇▇.▇▇▇.▇▇▇. You may also get this form by calling ▇-▇▇▇-▇▇▇-▇▇▇▇. Use Form W-7, Application for IRS Individual Taxpayer Identification Number, to apply for an ITIN, or Form SS-4, Application for Employer Identification Number, to apply for an EIN. You can apply for an EIN online by accessing the IRS website at ▇▇▇.▇▇▇.▇▇▇/▇▇▇▇▇▇▇▇▇▇ and clicking on Employer Identification Number (EIN) under Starting a Business. Go to ▇▇▇.▇▇▇.▇▇▇/▇▇▇▇▇ to view, download, or print Form W-7 and/or Form SS-4. Or, you can go to ▇▇▇.▇▇▇.▇▇▇/▇▇▇▇▇▇▇▇▇▇ to place an order and have Form W-7 and/or SS-4 mailed to you within 10 business days. If you are asked to complete Form W-9 but do not have a TIN, apply for a TIN and write “Applied For” in the space for the TIN, sign and date the form, and give it to the requester. For interest and dividend payments, and certain payments made with respect to readily tradable instruments, generally you will have 60 days to get a TIN and give it to the requester before you are subject to backup withholding on payments. The 60-day rule does not apply to other types of payments. You will be subject to backup withholding on all such payments until you provide your TIN to the requester.