Unit Ventilator Replacement Sample Clauses

Unit Ventilator Replacement. JCI shall replace the unit ventilators per scope below. • Disconnect and isolate existing electrical connection. • Removal and disposal of the old unit vents. • New unit ventilators to be same size and type as originals. • Connect new unit vents to existing electrical circuits. The following table lists the quantity of unit ventilators to be replaced. Intermediate School 14 • Resolution of existing design, service, and or distribution conditions known or unknown. • Correction of any existing applicable building code violations and Federal Americans with Disabilities Act (ADA) violations identified by JCI during the execution of the Work. Such violations will be brought to the attention of the Customer for remedy. • Temporary space conditioning unless otherwise identified in a FIM Scope of Work. • Test and balance of existing air and water HVAC systems unless otherwise noted in a specification FIM Scope of Work. • Duct cleaning and coil cleaning unless otherwise identified in a FIM Scope of Work. • Repair or replacement of defective mechanical, controls, and electrical equipment and electrical distribution system, except the equipment described in the Scope of Work (Defective equipment identified by JCI during implementation of the Scope of Work will be brought to the attention of the Customer). • Repairs/replacement of insulation, piping, electrical or ductwork found to be corroded or rusted or otherwise unacceptable for installation of components or fittings required for installation other than what is specified in the Scope of Work.