TEST TRANSMITTERS Clause Samples

TEST TRANSMITTERS. 2.2.1 CTI shall install the test transmitters at the Stations specified in Schedule 1 by the Test Dates. 2.2.2 CTI has submitted to the BBC a High Level Design for each of the test transmitters. As these transmitters will be test transmitters, the BBC acknowledges that the designs may not be complete. Subject to Clause 2.2.3, each High Level Design must comply with the Transmission Requirements. 2.2.3 It is acknowledged by the BBC and CTI that the High Level Design is based on information, data and documentation produced and/or approved by the Joint Frequency Planning Board. Accordingly, if, notwithstanding CTI's compliance with the High Level Design, CTI does not comply with the Transmission Requirements through no fault of CTI's, CTI shall not be in breach of this Agreement in consequence thereof and any material costs of overcoming a failure of the High Level Design to comply with the Transmission Requirements shall be for the account of the BBC. 2.2.4 The test transmitters must be installed so that they comply with the radio frequency parameters set out in Schedule 1, Schedule 5, the technical parameters in Schedule 8 and the provisions of Schedule 12. Distribution Links and multiplex facilities will not be required, except as may be agreed between the BBC and CTI. The BBC and CTI will negotiate in good faith to agree what other requirements the test transmitters will be required to meet. 2.2.5 CTI must provide the BBC with such access to the test transmitters as may be reasonably required as soon as they are available, and in any event by the Test Dates, for the purpose of inspecting the transmitters and conducting or participating in the conduct of test broadcasts. CTI must perform such test broadcasts and such other tests using the test transmitters as the BBC reasonably requires. The BBC will provide such material for test broadcasts by CTI as it considers reasonably appropriate. Further detail of the tests to be conducted will be reasonably agreed in good faith between the parties.
View Source

Related to TEST TRANSMITTERS

  • Transmission encryption All data transmissions of County PHI or PI outside the secure internal network must be encrypted using a FIPS 140-2 certified algorithm which is 128-bit or higher, such as AES. Encryption can be end to end at the network level, or the data files containing PHI can be encrypted. This requirement pertains to any type of PHI or PI in motion such as website access, file transfer, and E-Mail.

  • Data Transmission Control Except as necessary for the provision of the Cloud Services in accordance with the Agreement, Personal Data must not be read, copied, modified or removed without authorization during transfer. Where data carriers are physically transported, adequate measures are implemented at SAP to provide the agreed-upon service levels (for example, encryption and lead-lined containers).

  • Data Transmission The procedures for transmitting load obligation data to PJM for DS Supplier’s DS Load shall be as set forth by PJM.

  • No Transmission Delivery Service The execution of this Agreement does not constitute a request for, nor agreement to provide, any Transmission Service under the NYISO OATT, and does not convey any right to deliver electricity to any specific customer or Point of Delivery. If Developer wishes to obtain Transmission Service on the New York State Transmission System, then Developer must request such Transmission Service in accordance with the provisions of the NYISO OATT.

  • Loop Transmission Types 3.1 Subject to the conditions set forth in Section 1 of this Attachment, Verizon shall allow CBB to access Loops unbundled from local switching and local transport, in accordance with this Section 3 and the rates and charges provided in the Pricing Attachment. Verizon shall allow CBB access to Loops in accordance with, but only to extent required by, Applicable Law. The available Loop types are as set forth below: