Work Description T-804 Opening Roads - Removal of closure devices, cleaning ditches, removing berms, and blading the traveled-way T-811 Closing Roads - Entrance treatment for 150' cross-rip; debris block (slash, earth, berm, rocks, etc.) + seed + water bar T-811 Closing Roads - Water bar frequency per BMPs for remainder of road T-811 Closing Roads - Engineering Rep. or Construction Inspector must be notified prior to performing closeout NFSR Road No. Lane Width & Maintenance Level Mile Marker Begin End 9312 Single Lane / Level 1 NFSR 300 0.00 END 0.40
Site Description 2.5.1 If reasonably requested by the A/E as necessary for the Project, the Owner shall furnish a legal description and a certified land survey of the Site, giving, as applicable, grades and lines of streets, alleys, pavements and adjoining property; rights-of-way, restrictions, easements, encroachments, zoning, deed restrictions, boundaries and contours of the Site; locations, dimensions, and complete data pertaining to existing buildings, other improvements, and trees; and full information concerning available service and utility lines, both public and private, above and below grade, including inverts and depths.
System Description The wet detention basin is designed to trap 80% of sediment in runoff and maintain pre-development downstream peak flows. The basin has two forebays (smaller ponds) located at the low end of two grass xxxxxx. In addition to runoff conveyance, the grass xxxxxx also allow infiltration and filtering of pollutants, especially from smaller storms. The forebays are each 4 feet deep. They are connected to the main pool by 18 and 24-inch metal pipes that outlet onto a rock chute. The forebays will trap coarse sediments in runoff, such as road sands, thus reducing maintenance of the main basin. The main pool will trap the finer suspended sediment. To do this, the pond size, water level and outlet structures must be maintained as specified in this Agreement (see Figures 1, 2 and 3). The main basin receives runoff from a 67.1 acre drainage area (41.2 acres within the subdivision and 25.9 acres off-site drainage coming from the east). During high rainfall or snow melt events, the water level will temporarily rise and slowly drain down to the elevation of the control structure. The water level is controlled by a 12-inch concrete pipe extending through the berm in the northwest corner of the basin (see Figures 1 and 3). On the face of the 12-inch pipe, there is metal plate with a 3-inch drilled hole (orifice) with stone in front of it. This orifice controls the water level and causes the pond to temporarily rise during runoff events. Washed stone (1- 2” diameter) is placed in front of the orifice to prevent clogging. High flows may enter the grated concrete riser or flow over the rock lined emergency spillway. “As-built” construction drawings of the basin, showing actual dimensions, elevations, outlet structures, etc. will be recorded as an addendum(s) to this agreement within 60 days after [Municipality Name] accepts verification of construction from the project engineer.
Service Descriptions Available services for Transitional and Enhanced Supervision Services a. One (1) one-to-one meeting with the Contractor per week for case management services.
General Description Employer shall provide Employee with the compensation, incentives, benefits, and business expense reimbursement specified elsewhere in this agreement.
Project Description In two or three brief sentences, provide a concise description of your exhibition. Include the subject matter, type of objects to be included (paintings, sculpture, manuscripts, etc.), those responsible for organizing the exhibition, and catalogue author(s).
Legal Description The real property is a: (check one) ☐ - Single-Family Home ☐ - Condominium ☐ - Planned Unit Development (PUD) ☐ - Duplex ☐ - Triplex ☐ - Fourplex ☐ - Other: . Street Address: . Tax Parcel Information: . Other Description: .
General specifications 6.1.1. A vehicle and its electrical/electronic system(s) or ESA(s) shall be so designed, constructed and fitted as to enable the vehicle, in normal conditions of use, to comply with the requirements of this Regulation.
Topic Description Licensee Responsibilities Licensee must: Take appropriate steps to ensure the security, integrity, and confidentiality of Confidential Information and must comply with all relevant applicable laws and regulations, including laws protecting borrower privacy. Not disclose Confidential Information to third parties, without Xxxxxx Mae’s prior written approval, except on a need‐to‐know basis to Licensee’s partners, Topic Description affiliates, officers, employees, directors, contractors, counsels, agents or representatives, provided they are subject to confidentiality obligations at least as stringent as those set forth in this Section A3. Not use Confidential Information in any way that could be viewed as a conflict of interest, a breach of confidentiality or privacy, or the gaining of an unfair advantage from the relationship with Xxxxxx Xxx. Implement commercially reasonable measures meeting or exceeding industry standards to ensure the security, integrity, and confidentiality of Confidential Information, including using industry‐standard encryption for data in transit and virus checking programs designed to prevent the transmission and receipt of viruses and other malicious code, implementing appropriate disaster recovery and back‐up procedures, implementing appropriate procedures to prevent disclosure of data and other materials to a party other than the intended recipient, and employing methods for securely disposing or destroying such information. These measures must meet, at least, the same level of protection that the Receiving Party seeks for its own information of a similar nature. Licensee must collaborate with Xxxxxx Mae in assessing the sufficiency of these measures and Licensee’s information security program, upon reasonable request. Instruct its Related Parties who may receive Confidential Information about the requirements of this Section A3, and the processes and procedures necessary to comply with them. Comply with all reasonable security policies and procedures required by Xxxxxx Xxx related to the access and use of Xxxxxx Mae’s systems or any Licensed Materials. Not transmit to Xxxxxx Mae’s systems any materials that contain bugs, viruses, worms or other functions, routines, devices or instructions which may create any unauthorized access or damage to, or interruption in the functioning of, the Licensed Application or Xxxxxx Mae’s systems. Restrictive Legends Licensee must abide by and reproduce and include any restrictive legend or proprietary rights notice that appears in or on any Confidential Information of Xxxxxx Xxx or any Third‐Party Licensor (or other third‐party owner) that it is authorized to reproduce. Licensee also agrees that it will not remove, alter, cover or distort any trademark, trade name, copyright or other proprietary rights notices, legends, symbols or labels appearing on or in any Confidential Information of Xxxxxx Mae or any Third‐Party Licensor (or other third‐party owner). Required Actions in Case of Data Breach Licensee must address any Data Breach with prompt and effective corrective action, including cooperation with Xxxxxx Xxx in the investigation and remediation of such Data Breach, as well as prompt disclosure and notification where legally required; and Licensee must promptly notify Xxxxxx Mae of any Data Breach in writing ‐‐ at xxxxxxx_xxxxxxxxxxxx@xxxxxxxxx.xxx ‐‐ and must take all steps reasonably requested by Xxxxxx Xxx to mitigate the consequences of such Data Breach.
Additional Description If any additional information would help describe the property, include it here. Step 3 – Identify Lease Term 7.
