STEERING SYSTEM Clause Samples

STEERING SYSTEM. Steering box, steering box ▇▇▇▇▇▇ seals, rack and pinion unit and all their internal lubricated parts, steering rack shaft seals, power steering pump, pump shaft seal, idler arm, ▇▇▇▇▇▇ arm, inner tie rod ends, and outer tie rod ends.

STEERING SYSTEM. A. Steering gear shall be approved by the chassis manufacturer and designed to assure safe and accurate performance when a vehicle is operated with maximum load at maximum speed. B. If external adjustments are required, a steering adjustment mechanism shall be accessible. C. Changes may not be made in steering apparatus which are not approved by chassis manufacturer. D. There shall be a clearance of at least 2 inches between the steering wheel and cowl instrument panel or any other surface. E. Power steering is required and shall be of the integral type with integral valves. .13 Suspension (Springs and Shocks).

STEERING SYSTEM. Power steering gear box including PML control valve, pump, pump pulley, ignition lock including cylinder / tumblers, drag link, steering shock absorber, steering knuckle, tie rods, idler arm and idler arm bushing.

STEERING SYSTEM. The steering shall be equipped with dual ▇▇▇▇▇▇▇▇ integral power steering gears. The engine shall be equipped with a gear driven pump. A remote steel reservoir shall be provided with the ability to check the fluid level when the cab is in the lowered position. One (1) 10-MF-1810 The front tires shall be 385/65R22.5-20PR (L) MICHELIN XFE tread, tubeless radial tires. These tires shall be mounted on 22.5" x 12.25" rims. Front axle GAWR shall be 19,840 lbs. @ 130 psi. One (1) 10-GV-0065 The maximum tire speed rating is 65 MPH. One (1) 10-W0-1030

STEERING SYSTEM. Hydraulic power steering with height and angle adjustments provision and Adjustable steering column shall be provided.

STEERING SYSTEM. Steering box, rack and pinion unit and all related internal lubricated parts, power steering pump/shaft seal pump, ▇▇▇▇▇▇/idler arm, inner tie rod ends, and outer tie rod ends. 1. GASOLINE/DIESEL ENGINE: Cylinder block, cylinder head/heads (if damaged by internally lubricated covered part). Internally lubricated parts: pistons, piston

STEERING SYSTEM. The steering shall be from the helmsman position actuated by rim type wheel mounted at 450 to the vertical and transmitted by a mechanical ▇▇▇▇▇ system to OBM Unit at the transom. Arrangement for direct tiller control should also be provided. Cable wiring and hydraulic system shall be loomed inside the console and fed through ‘under deck cable ducting’ to the engine.