SPECIALIZED AVIATION SERVICE Sample Clauses

SPECIALIZED AVIATION SERVICE. OPERATOR (SASO) 5.1. Introduction A Specialized Aviation Service Operator (SASO) is a Commercial Aeronautical Operator engaged in providing Aviation products, services, and/or facilities. Aside from the various SASOs described in the subsequent sections of these Minimum Standards, other general SASOs may include, but not be limited to, Commercial Aeronautical Activities such as: aviation insurance, propeller or specialty maintenance or repair, aircraft interiors, nonstop sightseeing flights that begin and end at the Airport, aerial media, photography or survey, power line or pipeline patrol, fire-fighting or fire patrol, or airborne mineral exploration.
AutoNDA by SimpleDocs
SPECIALIZED AVIATION SERVICE. Operators (SASO) shall provide one (1) or more of the services listed in Sec. 8-275 and meet requirements for that specific activity.

Related to SPECIALIZED AVIATION SERVICE

  • Station Service Seller shall be responsible for arranging and obtaining, at its sole risk and expense, any station service required by the Facility that is not provided by the Facility itself.

  • Laundry Service If the Government provides a laundry service at the incident base camp, the Contractor may utilize the service at no cost.

  • Special Education Services 1. The parties agree to uphold the tenets contained within the "Special Education Services: A Manual of Policies, Procedures and Guidelines” document (February 2011) published by the BC Ministry of Education.

  • Electrical Service Electrical service for new construction or a renovated existing building shall be 480/277-volt, 3-phase, 4-wire or approved equal. Service shall be sized for HVAC and other mechanical system(s) loads, lighting, general building services, and dedicated computer based office equipment loads. 5 xxxxx per square foot shall be provided for lighting and general service receptacles. Size of neutral conductor of 3- phase circuits shall be twice that of phase conductor to accommodate potential harmonic currents associated with computer system electronic power supplies and fluorescent lighting fixtures electronic ballasts. An adequately sized 3 phase “wye” wound step down transformer shall be provided to supply 208/120-volt, 3 phase power, for lighting, general service receptacles and dedicated computer based office equipment. Dedicated, isolated ground circuits shall be supplied from separate isolated ground power distribution panel(s). Lighting circuits shall be supplied from separate lighting panel(s). Panels shall have 20% spare capacity and be complete with 10% spare breakers of each size, but no less than 1 spare. No more than 4 duplex receptacles shall be connected to any single 20-amp dedicated isolated ground circuit or general service circuit.

  • Provider Services The Contractor’s system shall collect, process, and maintain current and historical data on program providers. This information shall be accessible to all parts of the MCMIS for editing and reporting.

  • Janitorial Service Landlord shall not be obligated to provide any janitorial services to the Premises or replace any light bulbs, lamps, starters and ballasts for lighting fixtures within the Premises. Tenant shall be solely responsible, at Tenant’s sole cost and expense, for (i) performing all janitorial services, trash removal and other cleaning of the Premises, and (ii) replacement of all light bulbs, lamps, starters and ballasts for lighting fixtures within the Premises, all as appropriate to maintain the Premises in a first-class manner consistent with the first-class nature of the Building and Project. Such services to be provided by Tenant shall be performed by contractors and pursuant to service contracts approved by Landlord. Tenant shall deposit trash as reasonably required in the area designated by Landlord from time to time. All trash containers must be covered and stored in a manner to prevent the emanation of odors into the Premises or the Project. Landlord shall have the right to inspect the Premises upon reasonable notice to Tenant and to require Tenant to provide additional cleaning, if necessary. In the event Tenant shall fail to provide any of the services described in this Section 6.6 to be performed by Tenant within five (5) days after notice from Landlord, which notice shall not be required in the event of an emergency, Landlord shall have the right to provide such services and any charge or cost incurred by Landlord in connection therewith shall be deemed Additional Rent due and payable by Tenant upon receipt by Tenant of a written statement of cost from Landlord.

  • Installation Services 3.1 The Bitstream 2a Service includes a Standard Install as set out below (in each case to the extent that the relevant provisioning works are not already complete for the relevant Service Order).1

  • Interconnection Service Interconnection Service allows the Interconnection Customer to connect the Large Generating Facility to the Participating TO’s Transmission System and be eligible to deliver the Large Generating Facility’s output using the available capacity of the CAISO Controlled Grid. To the extent the Interconnection Customer wants to receive Interconnection Service, the Participating TO shall construct facilities identified in Appendices A and C that the Participating TO is responsible to construct. Interconnection Service does not necessarily provide the Interconnection Customer with the capability to physically deliver the output of its Large Generating Facility to any particular load on the CAISO Controlled Grid without incurring congestion costs. In the event of transmission constraints on the CAISO Controlled Grid, the Interconnection Customer's Large Generating Facility shall be subject to the applicable congestion management procedures in the CAISO Tariff in the same manner as all other resources.

  • Mediation Service The Mediation Service is a free and independent service available through MBIE. This service helps to resolve employment relationship problems and generally to promote the smooth conduct of employment relationships. Mediation is a mutual problem solving process, with the aim of reaching an agreement, assisted by an independent third party. If the parties can’t reach a settlement they can ask the mediator, in writing, to make a final and binding decision. A settlement reached through mediation and signed by the mediator at the request of the parties is final, binding and enforceable. Neither party can then take the matter any further and either party can be made to comply with the agreed settlement by court order. If the problem is unresolved through mediation either party may apply to have the matter dealt with by the Employment Relations Authority.

  • AIN Selective Carrier Routing for Operator Services, Directory Assistance and Repair Centers 4.3.1 BellSouth will provide AIN Selective Carrier Routing at the request of <<customer_name>>. AIN Selective Carrier Routing will provide <<customer_name>> with the capability of routing operator calls, 0+ and 0- and 0+ NPA (LNPA) 555-1212 directory assistance, 1+411 directory assistance and 611 repair center calls to pre-selected destinations.

Time is Money Join Law Insider Premium to draft better contracts faster.