Site Establishment Sample Clauses

Site Establishment.  The Contractor does not occupy any site or area other than that allocated to him.  The Contractor does not occupy the site or area prior to the take-over inspection.  The Contractor maintains the site or area provided to him to the satisfaction of the Employer. A site inspection to be conducted by both parties prior to site establishment  The Employer will require full access at all times of the Contractor’s site or area for inspection.  The Contractor will remain accountable for the security of his designated site area. The Employer will accept no accountability for any theft, losses or damage under the Contractors’ control
AutoNDA by SimpleDocs
Site Establishment. The pad (approximately 3500 m2) will be prepared using aggregate sourced from a local supplier. The aggregate will be spread out using a skid steer or similar equipment and compacted using a small compacting roller. The drilling site will be fenced with an 8’ high fence to prevent wildlife from entering the site and to limit site spread. The fence will be removed at the end of the planned work at the site. Equipment used during site establishment may include trucks for towing in the trailers, drilling support equipment and possibly the drill rig (may also be self-propelled), a small mobile crane to remove equipment from the transport trailers and place into final location (if required), pickup trucks and small equipment such as a skid steer.
Site Establishment. The Contractor shall establish the site camp and maintain throughout the construction period and allow for removal of such upon completion of Works. The Eskom Representative reserves the right to negotiate the rates for rental arrangements.
Site Establishment. The Contractor does not occupy any site or area other than that allocated to him.  The Contractor does not occupy the site or area prior to the take-over inspection.  The Contractor maintains the site or area provided to him to the satisfaction of the Employer.  The Employer subjects the Contractor’s site or area to periodic inspection.
Site Establishment. The Contractor shall be responsible for the provision of all temporary fencing and gates to the working areas, to ensure the protection of equipment, materials, operatives, disturbance to adjacent land/vegetation, prevention of vandalism and public hazard. Temporary fencing and gates are to be agreed with landowners and shall also be sufficient to discharge the Contractor’s obligations under the contract and health and safety legislation. The Contractor shall provide all the necessary signs and barriers. A formal notice of intention to commence the works will be given by the Employer, to owners and occupiers of all the land as designated by the working areas shown on the supplied drawings. The notice shall be as long as is reasonably practicable and will not normally be given less than 14 days before entry, other than in an emergency. To this effect the Contractor will be required to give the Employer 4 weeks notice of his intention to commence construction works. All access is to be via the routes as agreed with the site owners and contractors at least 2 weeks in advance of commencement of works. If the Contractor wishes to use any site for his compound or use additional land they shall gain approval of landowner/occupier and relevant authority and pay all associated land compensation costs. The Contractor shall ensure that continued unhindered access is provided to the landowners and occupiers at all times. The Contractor shall obtain any additional approvals from the relevant landowners, LPA and Local Highway Authority for these points and incorporate any specific requirements as necessary. If temporary access points are not acceptable the Contractor shall at his own cost provide alternative access points. All access routes, footpaths, working areas, site compounds, roads etc affected by the works shall be reinstated to their original state or to the requirements of the landowners/ occupiers and/or the relevant Authority. All delivery vehicles supplying the site should be scheduled to miss the peak usage times of the surrounding roads. Wheel wash facilities should be supplied at all access points to the working areas, where they meet public and private roads. 1.3.21
Site Establishment. The Contractor must survey the area out before tendering the job. Their survey must indicate the risks that the Contractor will encounter by executing the work in the limited space, as well a method statement of how the Contractor will execute the work with the mitigating actions for the risks they noted.  Contractor is to provide his own generator suitable for the type of activities that will form part of this project.  The Contractor to establish his site and ensure that it safe and environmentally sound.  The Contractor’s site to comply with OSH Act of 1983 and SANS 1200.
Site Establishment. With the steep sided open pit already at 52 m below surface at the time, establishing the vertical pit collar at that level meant that the preparation work and time required for the development of the collar infrastructure and erection of the headgear and winder was significantly reduced. Nevertheless, certain modifications to the open pit profile were necessary to provide sufficient working space and suitable access for the ore transport vehicles (Figure 8). Based on the available geological information, the maximum extent of the kimberlite pipe at depth was projected to surface, forming the perimeter of the vertical pit. The limited drillhole data suggested that the pipe plunged gently towards the south and the design work had taken that into account. However, during collar preparation, evidence was found of kimberlite infiltrating fractures in the country rock at the intended location of the headgear. Further investigations revealed a bulge in the pipe, typical of the irregularities commonly observed in the root zone of kimberlite pipes. The headgear had to be moved to a new location, requiring substantial additional waste stripping. The enlarged perimeter of the vertical pit made reworking of the geotechnical analyses and design work necessary. The increase in the pit floor area from approximately 3,480 m to 4,388 m impacted negatively on the final design depth, reducing the maximum depth from 180 m to approximately 100 m. Aerial view of No. 1 Pipe open pit prior to establishment of the vertical pit. Aerial view of No. 1 Pipe pit after waste stripping and establishment of the vertical pit collar. Commissioning of the headgear and winder in November 2005 Vertical pit headgear and collar infrastructure Figure 8 Stages in the development of the Koidu vertical pit. The Koidu Kimberlite Project reached steady state production from the No. 1 Pipe vertical pit during the third quarter of 2006, despite setbacks due to the delayed arrival of capital items required to meet the production schedule, breakdowns of the hoisting arrangement, and variable stripping ratios encountered due to the irregular geometry of the pipe. The vertical pit as at March 2008 is shown in Figures 9 and 10. Production from the No. 1 Pipe Vertical Pit progressed satisfactorily during the first three quarters of 2007, with the headfeed target of 26,000 tonnes per month being exceeded on three occasions. In addition to the higher tonnages mined and processed an increase in the average grad...
AutoNDA by SimpleDocs
Site Establishment. Figure 2: Route and location for Contractor’s site establishment on site.
Site Establishment i. Services and Facilities Provided by the Employer The location of and access to a proposed construction camp will be provided to the Contractor. Approval for the establishment of a construction camp must be obtained from ACSA. The Contractor is responsible for all arrangements for obtaining all necessary approvals, establishment and subsequent removal and reinstatement of his construction camp. Note that services for water and sewer will not be free of charge, and the utilization of these services will be at the expense of the Contractor. Other contractors may in part also use the proposed area. The Contractor must at all times limit his personnel, plant, equipment and materials at the Contractor's site or the working areas as approved by the Employer’s Agent. No personnel shall be accommodated on airport property. Only guards approved by the Employer and on duty may be on site at all times. The Contractor shall only use the designated gate(s) for access purposes to the airside. The area designated by the Employer’s Agent can be used for stockpiling material for use in the works and for temporary parking of plant and equipment. This location is to be confirmed by the Employer. All regulations and local authority ordinances, as regards smoke emissions and noise abatements shall apply and compliance will be enforced as well as height restrictions and any required obstacle markers. Also refer to the requirements of Clause 3 of the Procedure Manual for Working Airside (Volume 5).
Site Establishment. 7.9. All relevant permits and authorisations is as per TRN-IMS-GRP-TMP 014.7 List of Legal Permits and Authorisations shared and completed prior to site access. Contractor appointed within accordance with TRN-IMS-GRP-TMP-001.1 prior to site access by TPT.
Time is Money Join Law Insider Premium to draft better contracts faster.