Lessor's Obligations Subject to the provisions of Paragraphs 2.2 (Condition), 2.3 (Compliance), 9 (Damage or Destruction) and 14 (Condemnation), it is intended by the Parties hereto that Lessor have no obligation, in any manner whatsoever, to repair and maintain the Premises, or the equipment therein, all of which obligations are intended to be that of the Lessee. It is the intention of the Parties that the terms of this Lease govern the respective obligations of the Parties as to maintenance and repair of the Premises, and they expressly waive the benefit of any statute now or hereafter in effect to the extent it is inconsistent with the terms of this Lease.
Licensor’s Obligations 4.5.1. Xxxxx the Licensee the right to use the intellectual property (the Service) as in the Agreement. Ensure 24/7 availability of the Service, apart from preventive maintenance time.
Processor’s Obligations Except where expressly permitted by Article 28 (3)(a) GDPR, Processor shall process data subjects’ Data only within the scope of the Agreement and the instructions issued by Controller. Where Processor believes that an instruction would be in breach of applicable law, Processor shall notify Controller of such belief without undue delay. Processor shall be entitled to suspend performance on such instruction until Controller confirms or modifies such instruction. Processor shall, within Processor’s scope of responsibility, organize Processor’s internal organization so it satisfies the specific requirements of data protection. Processor shall implement technical and organizational measures to ensure the adequate protection of Controller’s Data, which measures shall fulfil the requirements of the GDPR and specifically its Article 32. Processor shall implement technical and organizational measures and safeguards that ensure ongoing confidentiality, integrity, availability and resilience of processing systems and services and shall implement a process for regularly testing, assessing and evaluating the effectiveness of technical and organizational measures for ensuring the security of the processing. Controller is familiar with these technical and organizational measures, and it shall be Controller’s responsibility that such measures ensure a level of security appropriate to the risk. The parties agree to refer to the existing certification of Processor by Kiwa International Cert GmbH in accordance with DIN ISO/IEC 27001:2015 which is considered sufficient evidence for these purposes by Controller and which is available on the website of Processor (xxx.xxxxxxx.xxx). Processor reserves the right to modify the measures and safeguards implemented, provided, however, that that the level of security shall not be less protective than initially agreed upon. Processor shall support Controller, insofar as is agreed upon by the parties, and where possible for Processor, in fulfilling data subjects’ requests and claims, as detailed in chapter III of the GDPR and in fulfilling the obligations enumerated in Articles 33 to 36 GDPR. Processor shall ensure that all employees involved in Contract Processing of Controller’s Data and other such persons as may be involved in Contract Processing within Processor’s scope of responsibility shall only do so within the scope of the instructions. Furthermore, Processor shall ensure that any person entitled to process Data on behalf of Controller has undertaken a commitment to confidentiality under terms similar to the confidentiality terms of the Agreement. All such confidentiality obligations shall survive the termination or expiration of such Contract Processing. Processor shall notify Controller without undue delay if Processor becomes aware of any Data breaches within Processor’s scope of responsibility. Processor shall implement the measures necessary for securing Data and for mitigating potential negative consequences for the data subject; the Processor shall coordinate such efforts with Controller without undue delay. Processor shall notify to Controller the point of contact for any issues related to data protection arising out of or in connection with the Agreement. The Exhibit provides for a list of the initially designated persons. Processor shall correct or erase Data if so instructed by Controller and where covered by the scope of the instructions permissible. Where an erasure, consistent with data protection requirements, or a corresponding restriction of processing is impossible, Processor shall, based on Controller’s instructions, and unless agreed upon differently in the Agreement, destroy, in compliance with data protection requirements, all carrier media and other material or return the same to Controller. In specific cases designated by Controller, such Data shall be stored or handed over. The associated cost for doing so and protective measures to put in place shall be agreed upon separately, unless already agreed upon in the Agreement. Processor shall, upon termination of Contract Processing and upon Controller’s instruction, return all Data, carrier media and other materials to Controller or delete the same. Where a data subject asserts any claims against Controller in accordance with Article 82 of the GDPR, Processor shall support Controller in defending against such claims, where possible at Controller’s cost as set out in Section 6 para. 3. § 4Controller’s Obligations Controller shall notify Processor without undue delay, and comprehensively, of any defect or irregularity with regard to provisions on data protection detected by Controller in the results of Processor’s work.
Vendor’s Obligations Vendor shall incur no further obligations in connection with the terminated work and on the date set in the notice of termination Vendor will stop work to the extent specified. Vendor shall also terminate outstanding orders and subcontracts as they relate to the terminated work. Vendor shall settle the liabilities and claims arising out of the termination of subcontracts and orders connected with the terminated work. The MTC or designee may direct Vendor to assign Vendor’s right, title, and interest under terminated orders or subcontracts to the MTC. Vendor must still complete the work not terminated by the notice of termination and may incur obligations as are necessary to do so.
Tenant’s Obligations Subject to the provisions of Article 10 (Casualty and Condemnation), at its sole cost and expense, Tenant will keep all portions of the Premises (including, without limitation, all systems and equipment, dock levelers, bumpers, doors and floors, including slabs and slab repairs, crack filling and joint repairs) in good order, condition and repair (including repainting and refinishing, as needed). If any portion of the Premises or any system or equipment in the Premises which Tenant is obligated to repair cannot be fully repaired or restored, Tenant will promptly replace such portion of the Premises or system or equipment. At Tenant’s request, Landlord may perform Tenant’s maintenance and repair obligations under this Section 9.03 and Tenant will reimburse Landlord for all costs incurred, plus fifteen (15%) percent, in doing so within thirty (30) days of receipt of an invoice from Landlord. Tenant shall, at its sole cost and expense, enter into and maintain a contract with a certified third-party HVAC service contractor, providing for the periodic (at least quarterly) service, maintenance and repair of the HVAC system serving the Premises, which shall provide for a scope of work and periodic services, at a minimum, in accordance with manufacturer’s specifications. Tenant shall, at its sole cost and expense, enter into and maintain a contract with a certified pest control service contractor that shall provide pest control treatments to the interior and exterior of the Premises at a minimum of 90-day intervals. Upon request by Landlord, Tenant shall furnish Landlord with a copy of the current service contracts, which contracts shall be in form and substance reasonably satisfactory to Landlord and a current certificate of insurance of the Tenant’s service contractor naming Landlord as an additional insured and such certificate shall be in form and substance and contain such coverages satisfactory to Landlord. In the event Landlord obtains an assignable warranty for any HVAC system servicing the Premises, to the extent assignable, Landlord shall assign to Tenant any such assignable warranty on parts and labor for the HVAC system. If any repairs or maintenance required to be made or maintained by Tenant hereunder are not made within ten (10) days after written notice delivered to Tenant by Landlord, or within such lesser time as is reasonable to require in the event of an emergency, Landlord may at its option make such repairs without liability to Tenant for any loss or damage which may result to Tenant’s stock or business by reason of such repairs; and Tenant shall pay to Landlord upon demand, as additional rental hereunder, the Landlord’s cost of such repairs plus interest thereon at the per annum rate set forth in Section 3.03, such interest to accrue continuously from the date of payment by Landlord until repayment by Tenant. At the expiration or termination of this Lease, Tenant shall surrender the Premises in good condition, excepting reasonable wear and tear and losses required to be restored by Landlord pursuant to the terms hereof. Industrial Lease
LANDLORD'S RIGHT TO PERFORM TENANT'S OBLIGATIONS (a) Without limiting the rights and remedies of Landlord contained in Paragraph 25 above, if Tenant shall be in Default in the performance of any of the terms, provisions, covenants or conditions to be performed or complied with by Tenant pursuant to this Lease, then Landlord may at Landlord's option, without any obligation to do so, and without notice to Tenant perform any such term, provision, covenant, or condition, or make any such payment and Landlord by reason of so doing shall not be liable or responsible for any loss or damage thereby sustained by Tenant or anyone holding under or through Tenant or any of Tenant's Agents.
HIRER’S OBLIGATIONS a) The Hirer acknowledges having received the Vehicle in a clean condition, with a full fuel tank and full bottle of gas (if applicable). The Hirer will return the Vehicle in a clean condition with a full fuel tank and a full bottle of gas (if applicable, and subject to any pre-purchase fuel and/or pre- purchase gas option being taken), on the Return Date at the time and at the Return Point set out in the Rental Agreement.
Conditions to Each Party’s Obligations The respective obligation of each Party to consummate the transactions contemplated by this Agreement is subject to the satisfaction (or written waiver by such Party) at or prior to the Closing of the following conditions:
Conditions to Each Party’s Obligation The respective obligations of each party to effect the transactions contemplated by this Agreement shall be subject to the satisfaction prior to or on the Closing Date of the following conditions:
Contractor’s Obligations The Contractor shall fully and timely provide all deliverables described in the Solicitation and in the Contractor’s Offer in strict accordance with the terms, covenants, and conditions of the Contract and all applicable Federal, State, and local laws, rules, and regulations.
