MEASUREMENT & TESTING Clause Samples

MEASUREMENT & TESTING. In accordance with ACTL 3.4, upon completion of the loading operation, Terminal Operator shall determine the quantity of LNG redelivered to Client using a calibrated weighbridge. The quality of LNG redelivered to Client shall be deemed to be the quality of the LNG of the storage tank from which the LNG is loaded. An LNG Truck Quality and Quantity Document shall be provided to the Trucker. Terminal Operator shall use reasonable endeavours to ensure a constant quality of LNG in the relevant tank used for truck loading.
View SourceView Similar (6)
MEASUREMENT & TESTING and Volume Determination
View SourceView Similar (2)
MEASUREMENT & TESTING. Mericom will perform network delay measurement testing between the Metricom service provider gateway and an interface node on the ASP's network. The network delay will be measured by determining roundtrip network latency in accordance with the following measurements: a) Software and hardware components capable of measuring traffic and responses shall be placed at each NIF to measure network delay using the statistics from ICMP PING packets. b) The roundtrip network latency measurements shall be taken at [**] minute intervals. These measurements shall be averaged on an hourly basis to determine the average network delay sample for that hour ("AVERAGE NETWORK DELAY SAMPLE") for that NIF.
View Source
MEASUREMENT & TESTING. Mericom will perform packet loss measurement testing on the ASP's circuits terminated at the NIF in accordance with the following measurements: a) Software and hardware components capable of measuring packet loss shall be placed at each Metricom NIF to measure the number of packets lost. Metricom Initials: ___ Confidential & Proprietary GoAmerica Initials: ______ Not for use or disclosure outside of Metricom or Contractor except under written permission Confidential Materials omitted and filed separately with the Securities and Exchange Commission. Asterisks denote omissions. b) The packet loss measurements shall be taken at [**] minute intervals on the ports used for the ASP's circuits. These measurements shall be averaged on an hourly basis to determine the average network capacity sample for that hour ("AVERAGE PACKET LOSS SAMPLE"). c) The packet loss measurement is based on measuring the number of packets lost while sending sixty four (64) byte ICMP PING packets to the ASP's LT2P network server. Metricom Initials: ___ Confidential & Proprietary GoAmerica Initials: ______ Not for use or disclosure outside of Metricom or Contractor except under written permission Confidential Materials omitted and filed separately with the Securities and Exchange Commission. Asterisks denote omissions.
View Source
MEASUREMENT & TESTING. Metricom will perform measurement testing on the ASP's circuits terminated at the NIF to determine bandwidth utilization in accordance with the following criteria: a) Software and hardware components capable of measuring traffic and responses shall be placed at each NIF to measure bandwidth utilization. b) The bandwidth utilization measurements shall be taken at [**] minute intervals on the ports used for the ASP's circuits. These measurements shall be averaged on an hourly basis to determine the average network capacity sample for that hour ("AVERAGE BANDWIDTH UTILIZATION SAMPLE"). Rev. 083000 GoAmerica Authorized Service Provider Agreement Page 35 of 41 Metricom Initials: ___ Confidential & Proprietary GoAmerica Initials: ______ Not for use or disclosure outside of Metricom or Contractor except under written permission Confidential Materials omitted and filed separately with the Securities and Exchange Commission. Asterisks denote omissions.
View Source

Related to MEASUREMENT & TESTING

  • Performance Testing (a) All performance tests of the Project, including any Initial Performance Test required in Section 2 of Appendix VIII, will be performed in accordance with the test procedures set forth in Appendix VIII (“Performance Test”), including additional procedures and protocols related to Performance Testing as mutually agreed between Buyer and Seller (“Test Procedures”). Seller shall bear all costs and receive all revenues, if applicable, associated with all Performance Tests. (b) After the Initial Delivery Date and during the Delivery Term, Buyer will have the right to conduct a Performance Test (“Buyer Performance Test”) no more than once a calendar year to demonstrate whether the Project is capable of delivering the Distribution Services at the Contract Capacity. Within 30 calendar days following a Buyer Performance Test, Seller will have the right to retest the Project with a Performance Test (“Seller Retest”). For the avoidance of doubt, the results of any Seller Retest will supersede the results of the preceding Buyer Performance Test. (i) If a Buyer Performance Test or, if a corresponding Seller Retest has occurred, a Seller Retest demonstrates the Project is capable of delivering Distribution Services at or above ninety-nine percent (99%) of the Initial Contract Capacity, the Contract Capacity will remain the Initial Contract Capacity; (ii) If a Buyer Performance Test or, if a corresponding Seller Retest has occurred, a Seller Retest demonstrates the Project is capable of delivering Distribution Services at more than or equal to eighty-five (85%) of the Initial Contract Capacity, but less than ninety-nine percent (99%) of the Initial Contract Capacity (“Testing Band”), the Contract Capacity will be automatically adjusted (upwards or downwards) to the capacity commensurate with the amount of Distribution Services the Project delivered during the Performance Test within the Testing Band. (iii) If a Buyer Performance Test or, if a corresponding Seller Retest has occurred, a Seller Retest demonstrates the Project is not capable of delivering Distribution Services of at least eighty-five percent (85%) of the Initial Contract Capacity, an Event of Default shall occur in accordance with Section 7.1(a)(viii).

  • ODUF Testing 6.6.1 Upon request from TWTC, AT&T shall send ODUF test files to TWTC. The Parties agree to review and discuss the ODUF file content and/or format. For testing of usage results, AT&T shall request that TWTC set up a production (live) file. The live test may consist of TWTC’s employees making test calls for the types of services TWTC requests on ODUF. These test calls are logged by TWTC, and the logs are provided to AT&T. These logs will be used to verify the files. Testing will be completed within thirty (30) days from the date on which the initial test file was sent.

  • STATEWIDE ACHIEVEMENT TESTING When CONTRACTOR is a NPS, per implementation of Senate Bill 484, CONTRACTOR shall administer all Statewide assessments within the California Assessment of Student Performance and Progress (“CAASPP”), Desired Results Developmental Profile (“DRDP”), California Alternative Assessment (“CAA”), achievement and abilities tests (using LEA-authorized assessment instruments), the Fitness Gram, , the English Language Proficiency Assessments for California (“ELPAC”), and as appropriate to the student, and mandated by LEA pursuant to LEA and state and federal guidelines. CONTRACTOR is subject to the alternative accountability system developed pursuant to Education Code section 52052, in the same manner as public schools. Each LEA student placed with CONTRACTOR by the LEA shall be tested by qualified staff of CONTRACTOR in accordance with that accountability program. ▇▇▇ shall provide test administration training to CONTRACTOR’S qualified staff. CONTRACTOR shall attend LEA test training and comply with completion of all coding requirements as required by ▇▇▇.

  • Random Testing Notwithstanding any provisions of the Collective Agreement or any special agreements appended thereto, section 4.6 of the Canadian Model will not be applied by agreement. If applied to a worker dispatched by the Union, it will be applied or deemed to be applied unilaterally by the Employer. The Union retains the right to grieve the legality of any imposition of random testing in accordance with the Grievance Procedure set out in this Collective Agreement.

  • Meter Testing Company shall provide at least twenty-four (24) hours' notice to Seller prior to any test it may perform on the revenue meters or metering equipment. Seller shall have the right to have a representative present during each such test. Seller may request, and Company shall perform, if requested, tests in addition to the every fifth-year test and Seller shall pay the cost of such tests. Company may, in its sole discretion, perform tests in addition to the fifth year test and Company shall pay the cost of such tests. If any of the revenue meters or metering equipment is found to be inaccurate at any time, as determined by testing in accordance with this Section 10.2 (Meter Testing), Company shall promptly cause such equipment to be made accurate, and the period of inaccuracy, as well as an estimate for correct meter readings, shall be determined in accordance with Section 10.3 (Corrections).