Loading And Electrical Installation Clause Samples

Loading And Electrical Installation. 11.1 The Tenant shall not bring into the Centre any machinery, equipment, goods or object which, in the absolute opinion of the Landlord, will or is likely to cause any structural or any other strain or damage to any part of the Centre. Without limiting the generality of the foregoing, the Tenant shall not load or permit or suffer to be loaded on any part of the floors of the Centre or the Premises to a weight greater than 3.5 KN/m² including partitions(or such other weight as may be prescribed by the Landlord from time to time as being applicable to the Premises) without the prior written consent of the Landlord and in any case shall comply with the directions and requirements of the Landlord in respect of the load distribution and positioning of all heavy equipment and articles in the Premises. The Tenant shall make good and indemnify the Landlord in respect of any damage to the Premises and Centre caused by the bringing in of any safe, items of machinery, plant, equipment or goods. 11.2 The Tenant shall not use any equipment or device which will cause an overload on the electrical supply to the Premises, such supply as may be prescribed by the Landlord or otherwise agreed in writing between the Landlord and the Tenant or in any way overload any Conducting Media in or serving the Premises or any part of the Centre. 11.3 The Tenant shall, at its own cost and expense, ensure that all coved lights installed at the perimeters of the Premises shall be kept turned on continuously every night between the hours of 7:00 pm and 1:00 am on gazetted public holidays and on the eve of gazetted public holidays and between the hours of 7:00 pm to 10:00 pm on other days, or such other hours as the Landlord may prescribe at any time and from time to time. 11.4 Except as provided in paragraph 11.6 below, the Tenant shall not, without the Landlord’s prior written approval, remove or adjust or in any way tamper with any of the coved lights referred to in paragraph 11.3 or any of the switches or timers connected to and used to operate such coved lights or with the protective sealed metal plate. Subject to the foregoing, the Tenant shall at all times and at its own cost repair and keep in good and tenantable repair and condition the coved lights, switches and timers referred to above, fair wear and tear excepted, and shall make good, repair or replace them in the event of any loss, damage or breakage thereof howsoever caused. 11.5 The Tenant shall permit the Landlord and its s...