Linear. Mean that the thrust develop linearly with the throttle setting, has more resolution at lower half of the throttle stick. This is the preferred factory setting. HALF EXPO: An intermediate setting between the previous two modes. The FADEC provides testing functions to the starter motor, glow plug, pump and both solenoid valves. These test screens are only available when the FADEC is on “Trim Low” status, that is to say, recently powered up and receiving a STOP signal from the TX. Pressing the (-) button (under the “ON” reading on the screen) will energize the selected device and pressing (+) will shut down. Special care should be taken when testing the pump, as it is possible that fuel can be pumped into the engine, flooding it, and causing a hot start on next startup. Always set-up and confirm the operation of your Auto-start installation on the test- stand, before installing into your model. The present version of auto start uses only one channel for the entire engine functions: To trigger the auto start cycle, the process is as follows:
Appears in 2 contracts
Sources: Purchase Agreement, Purchase Agreement