Installation Requirements Sample Clauses

Installation Requirements. 7.8 We (if we install the System) or our contractor (if we procure a contractor to install the System) must:
AutoNDA by SimpleDocs
Installation Requirements. The Applicant shall ensure that:
Installation Requirements. 4.6.1.All new TDM voice communications cabling systems installations shall utilize CAT-5E components. Terminations shall be in CAT-5E or CAT6 Outlets and on " patch panels". Cable shall be xxxx.
Installation Requirements. All work provided to customers under the Program by the Trade Ally must be in full compliance with the requirements of applicable laws, rules, licensing, and regulations of authorities having governmental and regulatory jurisdiction. Additionally, such work must be completed within 120 days of the commitment execution date on the agreement between the Program customer and the Trade Ally. In the removal of old equipment, the Trade Ally confirms that, as a requirement of the Program, Trade Ally will remove and dispose of, or confirm that the customer has done so, any and all equipment or materials that are replaced or removed in accordance with all applicable laws, rules, and regulations. If these requirements are not met, then ACE may cancel, withdraw, and revoke Trade Ally membership.
Installation Requirements. 3.1.1 All work shall conform to National Electrical Contractors Association standards of installation and the requirements of the manufacturer, Division 1, Division 16, and the Owner's Representative.
Installation Requirements. Subject to certain exceptions, the Service is available at locations with an unobstructed view of the southern sky. Your Service plan sets forth certain “up to” upload and download speeds. The upload and download speeds you will experience using your Service will vary significantly depending on a number of factors, including network or Internet traffic and congestion, the configuration of the device accessing the Internet, the speed of the websites you are visiting, the number of concurrent users and whether you are accessing the Service using Wi-Fi. Viasat does not guarantee stated “up to” speeds or uninterrupted use of the Service. In a variety of circumstances, actual upload and download speeds will be lower than stated “up to” speeds, particularly during peak congestion periods. You should also be aware that the performance of some games using the Service is very poor and some games may not work at all. Virtual private networks and remote computer access may also be very slow with the Service. Some virtual private networks may not work at all.
Installation Requirements. As applicable, as between the Company and Applicant, Applicant assumes sole responsibility for all installations related to Applicant’s participation in the Program. Applicant acknowledges that all work must comply fully with all applicable laws, rules, and regulations. Without limitation, Applicant shall perform any necessary interconnections in accordance with the requirements and terms and conditions set forth in the New York State Standardized Interconnection Requirements in order to deliver the Project safely and reliably. Subject also to such requirements of and full liability associated with any failures in connection with a “Permission to Operate” and associated interconnection, Applicant shall be responsible under this Agreement for all delays, costs and expenses associated with such interconnection.
AutoNDA by SimpleDocs
Installation Requirements. All installations shall follow the requirements set forth in the Regulation, except as specified in this Agreement or in any special Permit provisions. Specifically:
Installation Requirements. All required materials, equipment, hardware, software and station cabling (where re-use is unavailable or new locations are required) for installation and maintenance of the ITS shall be provided by the Contractor. Wherever possible, the Contractor shall re-use existing station cabling installed at each Department facility for the telephone instruments. In cases where existing station cabling cannot be used, the Contractor shall install new station cabling (Category 3 minimum) at no cost to the Department. Any new cabling shall include wall plate, cross connection, patch cords, etc. as required by the Department. The Contractor shall comply with all applicable electrical codes. The Contractor shall warrant that all members of the Contractor’s staff or subcontractors providing installation of the ITS have been fully trained and certified by the manufacturer as qualified to install the system, equipment and related services as required for service delivery. The Contractor shall comply with the Department’s security guidelines (Attachment 1) on institutional and facility security policies. Violations of these rules could result in termination of the Contract. Prior to beginning work at an institution, the Contractor shall contact the institution to obtain a copy of any specific additional institutional or facility rules. The Contractor or designee shall provide each institution or facility with the following items before entering the facilities:
Installation Requirements. I agree that, prior to Xcel Energy starting work: (1) the route of Xcel Energy’s service installation will be accessible to Xcel Energy’s equipment; (2) I will remove all obstructions from the route at no cost or expense to Xcel Energy; (3) I will clearly mark all septic tanks, drainfields, sprinkler systems, water xxxxx, owner-installed electric or pipeline facilities, or other customer owned facilities in the installation route; and
Time is Money Join Law Insider Premium to draft better contracts faster.