Installation and Use of Cisco 1120 Secure Access Control System Clause Samples

Installation and Use of Cisco 1120 Secure Access Control System. The Cisco Secure Access Control System (“ACS”) Software component of the Cisco 1120 Hardware Platform is pre installed. CDs containing tools to restore this Software to the 1120 Hardware are provided to Customer for reinstallation purposes only. Customer may only run the supported Cisco Secure Access Control System Software Products on the Cisco 1120 Hardware Platform designed for its use. No unsupported Software product or component may be installed on the Cisco 1120 Hardware Platform. Each Cisco 1120 Secure Access Control System is shipped with a Product Activation Key (“PAK”) that must be registered with Cisco to obtain an appropriate base license file. The PAK and associated license file are intended for use on one and only one Cisco 1120 Secure Access Control System.
View Source

Related to Installation and Use of Cisco 1120 Secure Access Control System

  • Installation and Use Rights You may install and use any number of copies of the software on your devices.

  • System Upgrade Facilities and System Deliverability Upgrades Connecting Transmission Owner shall design, procure, construct, install, and own the System Upgrade Facilities and System Deliverability Upgrades described in Appendix A hereto. The responsibility of the Developer for costs related to System Upgrade Facilities and System Deliverability Upgrades shall be determined in accordance with the provisions of Attachment S to the ISO OATT.

  • Installation and Use You may install and use the Software only for the number of licenses acquired by you. In order to exercise your rights to the Software under this Agreement, you must activate your copy of the Software in the manner described during the launch sequence.

  • Selection of Subcontractors, Procurement of Materials and Leasing of Equipment The contractor shall not discriminate on the grounds of race, color, religion, sex, national origin, age or disability in the selection and retention of subcontractors, including procurement of materials and leases of equipment. The contractor shall take all necessary and reasonable steps to ensure nondiscrimination in the administration of this contract. a. The contractor shall notify all potential subcontractors and suppliers and lessors of their EEO obligations under this contract. b. The contractor will use good faith efforts to ensure subcontractor compliance with their EEO obligations.

  • Installation, Maintenance, Testing and Repair Unless otherwise agreed in writing by the Parties, to the extent required by Applicable Law, Interconnection provided by a Party shall be equal in quality to that provided by such Party to itself, any subsidiary, affiliates or third party. If either Party is unable to fulfill its obligations under this Section 14.2, it shall notify the other Party of its inability to do so and will negotiate alternative intervals in good faith. The Parties agree that to the extent required by Applicable Law, the standards to be used by a Party for isolating and clearing any disconnections and/or other outages or troubles shall be at parity with standards used by such Party with respect to itself, any subsidiary, affiliate or third party.