Common use of Inspection and Testing during Manufacture Clause in Contracts

Inspection and Testing during Manufacture. Every facility shall be provided by the contractor to enable the Engineer to carry out the necessary inspection of the equipment to be provided under this contract the costs of all tests during manufacture and preparation of test records shall be borne by the contractor. The passing of such inspection or test will, however ,prejudice the right of the purchaser to reject the material if it does not comply with specification when erected or give complete satisfaction in service. Test instruments shall be approved and shall, if required by the Engineer, be calibrated by the National physical Laboratory or such other body as may be approved at the expense of the contractor Breakdown test voltages shall be measured by means of a crest or Electro – static voltmeter connected to the high voltage side of the transformer or by an instruments connected to the low voltage side of the transformer supplying the test voltage, and calibrated in an approved manner by means of a sphere spark gap Electrical tests other than impulse tests shall be carried out at a frequency of 50hz.

Inspection and Testing during Manufacture. Every facility shall be provided by the contractor to enable the Engineer to carry out the necessary inspection of the equipment to be provided under this contract the costs of all tests during manufacture and preparation of test records shall be borne by the contractor. The passing of such inspection or test will, however ,prejudice the right of the purchaser to reject the material if it does not comply with specification when erected or give complete satisfaction in service. Test instruments shall be approved and shall, if required by the Engineer, be calibrated by the National physical Laboratory or such other body as may be approved at the expense of the contractor Breakdown test voltages shall be measured by means of a crest or Electro – static voltmeter connected to the high voltage side of the transformer or by an instruments connected to the low voltage side of the transformer supplying the test voltagevoltage , and calibrated in an approved manner by means of a sphere spark gap Electrical tests other than impulse tests shall be carried out at a frequency of 50hz.

Inspection and Testing during Manufacture. Every facility shall be provided by the contractor to enable the Engineer to carry out the necessary inspection of the equipment to be provided under this contract the costs of all tests during manufacture and preparation of test records shall be borne by the contractor. The passing of such inspection or test will, however ,, prejudice the right of the purchaser to reject the material if it does not comply with specification when erected or give complete satisfaction in service. Test instruments shall be approved and shall, if required by the Engineer, be calibrated by the National physical Laboratory or such other body as may be approved at the expense of the contractor Breakdown test voltages shall be measured by means of a crest or Electro – static voltmeter connected to the high voltage side of the transformer or by an instruments connected to the low voltage side of the transformer supplying the test voltage, and calibrated in an approved manner by means of a sphere spark gap Electrical tests other than impulse tests shall be carried out at a frequency of 50hz.. Irbid District Electricity Co.

Inspection and Testing during Manufacture. Every facility shall be provided by the contractor to enable the Engineer to carry out the necessary inspection of the equipment to be provided under this contract the costs of all tests during manufacture and preparation of test records shall be borne by the contractor. The passing of such inspection or test will, however ,prejudice the right of the purchaser to reject the material if it does not comply with specification when erected or give complete satisfaction in service. Test instruments shall be approved and shall, if required by the Engineer, be calibrated by the National physical Physical Laboratory or such other body as may be approved at the expense of the contractor Breakdown test voltages shall be measured by means of a crest or Electro – static voltmeter connected to the high voltage side of the transformer or by an instruments connected to the low voltage side of the transformer supplying the test voltage, and calibrated in an approved manner by means of a sphere spark gap Electrical tests other than impulse tests shall be carried out at a frequency of 50hz.