Human Computer Interface (HCI) Requirements Clause Samples

Human Computer Interface (HCI) Requirements. The HCI Appendix 3 establishes the operator display and input requirements that the CUCS shall support. Appendix 3 specifies the requirements levied upon the CUCS, and does not impose any design requirements on human factors (HF) and ergonomics, (e.g., number of displays, manual controls, switches etc.). Appendix 3, while not specifically defining the format of the data to be displayed, identifies the capabilities that the CUCS shall provide in order for the qualified UAS operator(s) to effectively operate the UAS. The HCI requirements also address the display and operator interactions that are imposed on the CUCS by the CCI and DLI.

Related to Human Computer Interface (HCI) Requirements

  • Meteorological Data Reporting Requirement (Applicable to wind generation facilities only)

  • CERTIFICATION REGARDING DRUG-FREE WORKPLACE REQUIREMENTS 1. The Contractor certifies that it will provide a drug-free workplace by: a. Publishing a statement notifying employees that the unlawful manufacture, distribution, dispensing, possession or use of a controlled substance is prohibited in the Contractor’s workplace and specifying the actions that will be taken against employees for violation of such prohibition;

  • Information Technology Accessibility Standards Any information technology related products or services purchased, used or maintained through this Grant must be compatible with the principles and goals contained in the Electronic and Information Technology Accessibility Standards adopted by the Architectural and Transportation Barriers Compliance Board under Section 508 of the federal Rehabilitation Act of 1973 (29 U.S.C. §794d), as amended. The federal Electronic and Information Technology Accessibility Standards can be found at: ▇▇▇▇://▇▇▇.▇▇▇▇▇▇-▇▇▇▇▇.▇▇▇/508.htm.

  • Human and Financial Resources to Implement Safeguards Requirements The Borrower shall make available necessary budgetary and human resources to fully implement the EMP and the RP.

  • Trunk Group Architecture and Traffic Routing 5.2.1 The Parties shall jointly establish Access Toll Connecting Trunks between CLEC and CBT by which they will jointly provide Tandem-transported Switched Exchange Access Services to Interexchange Carriers to enable such Interexchange Carriers to originate and terminate traffic from and to CLEC's Customers. 5.2.2 Access Toll Connecting Trunks shall be used solely for the transmission and routing of Exchange Access and non-translated Toll Free traffic (e.g., 800/888) to allow CLEC’s Customers to connect to or be connected to the interexchange trunks of any Interexchange Carrier that is connected to the CBT access Tandem. 5.2.3 The Access Toll Connecting Trunks shall be one-way or two-way trunks, as mutually agreed, connecting an End Office Switch that CLEC utilizes to provide Telephone Exchange Service and Switched Exchange Access Service in the given LATA to an access Tandem Switch CBT utilizes to provide Exchange Access in the LATA.