HARDWARE SET NUMBERS Sample Clauses

HARDWARE SET NUMBERS. A. All doors shall be equipped with finish hardware of the types listed and in accordance with the following set numbers. The contractor is to refer to the schedule and plans for the total number of each set required. Sets, as listed herein, shall be supplied as complete units and must include all components. No omissions will be accepted. Manufacturer’s List XX Xxxxx Xxxxxxx XX Xxxx XX LCN XX XxXxxxxx PE Pemko XX Xxxxxxxx RX Rixson SC Schlage SO Sonitrol VD Von Duprin Hardware Sets HARDWARE SET 1 EACH TO RECEIVE: 2 EA CONTINUOUS HINGE MCK-25HD x PT x LAR 628 MK 2 EA POWER TRANSFER EPT-10 689 VD 1 EA KEYED MULLION KR4954 PC VD 1 EA MOUNTING BRACKET MT54 PC VD 1 EA EXIT DEVICE SD-EL-RX-99NL-OP 626 VD 1 EA EXIT DEVICE CD-RX-99EO 626 VD 1 EA POWER SUPPLY PS914-2RS 600 VD 2 EA RIM CYLINDER 20-057T 626 SC 1 EA MORTISE CYL 26-091T XQ11-948 626 SC 1 EA MORTISE CYL. 26-091T 626 SC 4 EA CONSTRUCTION CORE 23-030 ICX 626 SC 4 EA PERMANENT CORE 00-000 000 SC 2 XX XXXXXX TRIM VR900 SERIES 630 IV 2 EA SPACER KIT 4110-61 689 LC 2 EA SUPPORT BRACKET 4110-30 689 LC 2 EA KICK PLATE 8" x 2" LDW x .050" x B4E 630 RO 1 EA THRESHOLD 271A x LAR 628 PE 2 EA DOOR SWEEP 18061CP x LAR 628 PE 1 EA DRIP CAP 346C x DOOR WIDTH + 4” 628 PE 2 EA STATUS SWITCH 1078W SO 1 EA WIRING DIAGRAM COMPLETE WITH POINT TO POINT VD 1 SET GASKET BY FRAME MANUFACTURER (HEAD & JAMBS) 1 SET GASKET BY DOOR MANUFACTURER (MEETING XXXXXX) ELECTRICAL OPENING TO OPERATE AS FOLLOWS: OUTSIDE, CARD READER (BY OTHERS) OR TIMER (BY OTHERS) SIGNALS POWER SUPPLY TO RETRACT EXIT DEVICE LATCHES ALLOWING ENTRY BY DOOR PULL. INSIDE, FREE EGRESS AT ALL TIMES BY EXIT DEVICE. SWITCH IN RAIL SIGNALS ACCESS CONTROL SYSTEM OF AUTHORIZED EXIT. SEE ELEVATION #1. HARDWARE SET 1A EACH TO RECEIVE: 2 EA CONTINUOUS HINGE MCK-25HD x LAR 628 MK 1 EA KEYED MULLION KR4954 689 VD 1 EA MOUNTING BRACKET MT54 Door 129C PC VD 1 EA EXIT DEVICE SD-EL-RX-99NL-OP 626 VD 1 EA EXIT DEVICE CD-RX-99EO 626 VD 1 EA POWER SUPPLY PS914-2RS 600 VD 2 EA RIM CYLINDER 20-057T 626 SC 1 EA MORTISE CYL 26-091T XQ11-948 626 SC 1 EA MORTISE CYL. 26-091T 626 SC 4 EA CONSTRUCTION CORE 23-030 ICX 626 SC 4 EA PERMANENT CORE 00-000 000 SC 2 XX XXXXXX TRIM VR900 SERIES 630 IV 2 EA SPACER KIT 4110-61 689 LC 2 EA SUPPORT BRACKET 4110-30 689 LC 2 EA KICK PLATE 8" x 2" LDW x .050" x B4E 630 RO 1 EA THRESHOLD 271A x LAR 628 PE 2 EA DOOR SWEEP 18061CP x LAR 628 PE 1 EA DRIP CAP 346C x DOOR WIDTH + 4” 628 PE 1 SET GASKET BY FRAME MANUFACTURER (HEAD & JAMBS) HARDWARE SET 1B EAC...
Sample 1
AutoNDA by SimpleDocs

Related to HARDWARE SET NUMBERS

  • Contact Numbers The Parties agree to provide one another with toll-free nation- wide (50 states) contact numbers for the purpose of ordering, provisioning and maintenance of services.

  • -wire Unbundled Digital/DS0 Loop These are designed 4-wire Loops that may be configured as 64kbps, 56kbps, 19kbps, and other sub-rate speeds associated with digital data services and will come standard with a test point, OC, and a DLR.

  • Local Number Portability Database 10.6.1 The Permanent Number Portability (PNP) database supplies routing numbers for calls involving numbers that have been ported from one local service provider to another. BellSouth agrees to provide access to the PNP database at rates, terms and conditions as set forth by BellSouth and in accordance with an effective FCC or Commission directive.

  • Meteorological Data Reporting Requirement (Applicable to wind generation facilities only) The wind generation facility shall, at a minimum, be required to provide the Transmission Provider with site-specific meteorological data including: • Temperature (degrees Fahrenheit) • Wind speed (meters/second) • Wind direction (degrees from True North) • Atmosphere pressure (hectopascals) • Forced outage data (wind turbine and MW unavailability)

  • Voice Grade Unbundled Copper Sub-Loop Unbundled Sub-Loop Distribution – Intrabuilding Network Cable (aka riser cable)

  • Web-based-WHOIS query RTT Refers to the RTT of the sequence of packets from the start of the TCP connection to its end, including the reception of the HTTP response for only one HTTP request. If Registry Operator implements a multiple-step process to get to the information, only the last step shall be measured. If the RTT is 5-times or more the corresponding SLR, the RTT will be considered undefined.

  • Project Number The project number has been assigned by the Commission as the unique identifier for your project, and it cannot be changed. The project number should appear on each page of the grant agreement preparation documents to prevent errors during its handling.

  • Wire Unbundled DS1 Digital Loop This is a designed 4-wire Loop that is provisioned according to industry standards for DS1 or Primary Rate ISDN services and will come standard with a test point, OC, and a DLR. A DS1 Loop may be provisioned over a variety of loop transmission technologies including copper, HDSL-based technology or fiber optic transport systems. It will include a 4-Wire DS1 Network Interface at the End User’s location.

  • PRICING for Markup of Non-Prepriced Items in RS Means Unit Price Book What is your proposed Markup Percentage on materials not found in the RS Means Price Book? If any materials being utilized for a project cannot be found in the RS Means Price Book, this question is what is the markup percentage on those materials? When answering this question please insert the number that represents your percentage of proposed markup. Example: if you are proposing a 30 percent markup, please insert the number "30". Remember that this is a ceiling markup. You may markup a lesser percentage to the TIPS Member customer when pricing the project, but not a greater percentage. EXAMPLE: You need special materials that are not in the RS Means Unit Price Book for a project. You would buy the materials and mark them up to the TIPS Member customer by the percentage you propose in this question. If the materials cost you, the contractor, $100 and you proposed a markup on this question for the material of 30 percent, then you would charge the TIPS Member customer $130 for the materials.

  • Conflicts with RS Means Unit Price Book If the terms of the solicitation referenced RS Means Unit Price Book occur, the RS Means Book shall control if it determines the legality of the solicitation award as it relates to the requisite Means Unit Price Book.

Time is Money Join Law Insider Premium to draft better contracts faster.