Generator Qualifications Sample Clauses

Generator Qualifications. Is Generator powered from a Nonfossil Fuel Source? X Yes No Type of Nonfossil Fuel Source: PV CSP WindOther Hydro PV Array DC Rated Output: kW PV Array AC Rated Output: kW Maximum Site Load without Generator Capability: kW Maximum Generator Capability: kW Minimum Site Load without
Sample 1Sample 2Sample 3See All (5)
AutoNDA by SimpleDocs
Generator Qualifications. All data collected in Sections 2, 3, and 4 are applicable only to the generator facility, NOT the necessary interconnection facilities Energy source: Solar Wind Hydro Hydro Type (e.g. Run-of- River) Diesel Natural Gas Fuel Oil Other (state type) Type of Generator: Synchronous Induction DC Generator or Solar with Inverter Generator Nameplate Rating: kW (Typical) Generator Nameplate KVAR: Applicant or Customer-Site Load: kW (if none so state) (Typical); (Reactive Load, if known) Maximum Physical Export Capability Requested: kW List components of the Generating Facility that are currently certified by a U.S. Department of Energy-approved laboratory and/or listed by the Underwriters Laboratory: Equipment Type UL Listing or U.S. Lab Certification (Identify) 1.
Sample 1
Generator Qualifications. Is QREG powered from a renewable energy source? Yes No Type of Qualifying Renewable Energy Source (if applicable): Solar Wind Other If Other, Please Describe: If Wind, Maximum Height: QREG Manufacturer, Model Name & Number: Output Power Rating in kWDC: Nominal DC Voltage in VDC: Number of Units to be Installed: Inverter Manufacturer, Model Name & Number: Output Rating in kWAC: Current Rating in AmpsAC: Voltage Rating in VAC: Power Factor %: _ Frequency in Hz: Harmonic Distortion Rating in Hz: Number of Inverters to be Installed: Maximum Installed System Output Power Rating in kWAC: Single Line Diagram (Required) attached? Yes Site Plan (Required) attached? Yes Will the QREG Facility include Battery Storage? Yes No If “no”, the Customer may not install battery storage at any time without prior written approval by the Borough. If “yes” the installed battery storage must comply with the National Electric Code, the Borough’s “Technical Requirements Covering Renewable Inverter-Based Customer Generators of 10 Kilowatts or Less and Interconnected with the Borough of Chambersburg Electric System” (“Technical Requirements”), and any applicable Borough requirements. Battery Storage Manufacturer, Model Name & Number: Battery Type: Battery Storage Capacity: Number of Batteries: Customer Owned Generation Disconnect Switch(s)/Isolation Device(s) Per the “Net Metering Rider for Renewable Inverter-Based Customer Generators of 10 Kilowatts or Less,” a QREG Facility must install isolation device(s) whether AC or DC as described in Section 8e below. The customer is obligated to maintain the QREG Facility and Customer Owned Generation Disconnect Switch(s) in compliance with the National Electric Code, IEEE 1547 and UL 1741(or subsequent approved revisions thereof) at all times during which the QREG Facility is interconnected with the Borough’s electric system. Failure to maintain the QREG Facility and Customer Owned Generation Disconnect Switch(s) in such condition shall be grounds for disconnection of the QREG Facility and termination of this Application/Agreement. Warning Labels Per the “Net Metering Rider for Renewable Inverter-Based Customer Generators of 10 Kilowatts or Less,” a QREG Facility must prominently display the Borough-installed Warning Labels on the meter base(s) and isolation device(s). The Warning Labels are intended to protect the safety of Borough personnel, emergency personnel, and others who might be working at the facility by notifying them of the fact ...
Sample 1
Generator Qualifications. Type of Generating Facility or Nonfossil Fuel Source Solar Wind Hydro Biomass Hybrid System (consisting of 2 or more other types of systems) Maximum Site Load without Generation: kW Maximum Generating Capability: kW Minimum Site Load without Generation: kW Maximum Export: kW Section 3, Generator Technical Information Type of Generator: Synchronous Induction DC Generator or Solar with Inverter Generator (or solar collector) Manufacturer, Model Name & Number: (A copy of Generator Nameplate and Manufacturer’s Specification Sheet may be substituted) Total Capacity Rating in kW (for solar kWDC): Inverter Manufacturer, Model Name & Number (if used): (A copy of Inverter Nameplate and Manufacturer’s Specification Sheet may be substituted) Rating in kW: Energy Storage Device Capacity (if used): Rating in kW: Fault Current Contribution of Generator: Amps [If generator type is DC Generator or Solar with Inverter, example – photovoltaic (PV) system, go to Section 5.]
Sample 1
Generator Qualifications. Type of Generating Facility or Nonfossil Fuel Source ✔ Solar Wind Hydro Biomass Hybrid System (consisting of 2 or more other types of systems) Maximum Site Load without Generation: Curr Max Demand kW Maximum Generating Capability: PV System Max kW Minimum Site Load without Generation: Curr Min Demand kW Maximum Export: PV System Max kW Section 3, Generator Technical Information Type of Generator: Synchronous Induction ✔ DC Generator or Solar with Inverter Generator (or solar collector) Manufacturer, Model Name & Number: Sharp NU-U235F3, Qty. 170 (A copy of Generator Nameplate and Manufacturer’s Specification Sheet may be substituted) Total Capacity Rating in kW (for .2117 kW (PTC) x 170 = 35.90 kW (PTC) solar kWDC): 35.90 kW (PTC) Inverter Manufacturer, Model Name & Number (if used): Enphase M190-72-240, Qty. 170 (A copy of Inverter Nameplate and Manufacturer’s Specificati 0.19 kW x 170 = 32.30 kW on Sheet may be substituted) Rating in kW: 32.30 kW Energy Storage Device Capacity (if used): Rating in kW: List if Battery Backup Used Fault Current Contribution of Generator: Amps [If generator type is DC Generator or Solar with Inverter, example – photovoltaic (PV) system, go to Section 5.]
Sample 1

Related to Generator Qualifications

  • Contractor Qualifications Contractor warrants that Contractor has the necessary licenses, experience and technical skills to provide services under this Contract.

  • Vendor Qualifications Minimum Qualifications Based on the Contractor’s submission, OGS has determined that Contractor met the minimum qualifications for the lot(s) as identified in Appendix G, Contractor and OGS Information. If Contractor is awarded Lot 1 as a New York State Certified Minority- or Women- Owned Business Enterprise or as a New York State Small Business, Contractor agrees that it must retain at least one of such statuses to retain its Lot 1 award. Should a Contractor no longer retain at least one of such statuses, OGS shall suspend its Lot 1 award and the Contractor shall not be able to respond to Authorized User’s requests. If the Contractor fails to regain at least one of the statuses within 90 calendar days and provide OGS with documentation of such status, then its Lot 1 award shall be terminated. Any transaction awarded prior to Contractor’s loss of such statuses may continue until completion, unless otherwise terminated in accordance with this Contract. Lot 1– For projects up to $200,000 total Eligibility for this Lot is limited to the following:  Contractor is a New York State Certified Minority- or Women-Owned Business Enterprise; or  Contractor meets the definition of a New York State Small Business which is as follows: o A business which is resident in New York State, independently owned and operated, not dominant in its field and employs one hundred or less persons (see State Finance Law section 160(8)).

  • Driver Qualifications All drivers shall be trained and qualified in the operation of collection vehicles, and must have in effect a valid license, of the appropriate class, issued by the California Department of Motor Vehicles. Contractor shall use the Class II California Department of Motor Vehicles employer “Pull Notice Program” to monitor its drivers for safety.

  • IRO Qualifications The IRO shall:

  • Staff Qualifications a) CONTRACTOR shall ensure that all individuals employed, contracted, and/or otherwise hired by CONTRACTOR to provide classroom and/or individualized instruction or related services hold a license, certificate, permit, or other document equivalent to that which staff in a public school are required to hold in the service rendered consistent with Education Code section 56366.1(n)(1) and are qualified pursuant to Title 5 of the California Code of Regulations sections 3064 and 3065.

  • Minimum Qualifications If applicable pursuant to Article 3, I acknowledge that the Bidder meets the minimum qualification requirements established for this solicitation.

  • General Qualifications General qualifications commonly required of all candidates for, appointees to, and employees in the classified service such as integrity, honesty, sobriety, dependability, industry, thoroughness, accuracy, good judgment, initiative, resourcefulness, courtesy, ability to work cooperatively with others, good health, and freedom from disabling defects, shall be deemed to be a part of the personal characteristics of the minimum qualifications of each class specification and need not be specifically set forth therein. The Commission may prescribe alternative or additional qualifications for individual classes and such qualifications also shall be deemed to be a part of the specifications for such classes.

  • Personnel Qualifications Contractor shall assign properly qualified and experienced personnel to the program contemplated under this Agreement, and Contractor shall use reasonable efforts to retain such personnel on Customer’s program for the duration of such program.

  • Professional Qualifications It shall be a condition of continued professional employment that employees must apply for enrolment in their appropriate professional licensing body by the thirtieth day of continuous service.

  • Required Qualifications Not Applicable

Time is Money Join Law Insider Premium to draft better contracts faster.