Electrical Switches Clause Samples

Electrical Switches. Landlord will supply and install a single pole wall switch in the amount of one for each 250 square feet or as required by code. These switches will be installed in the building standard partitions at the building standard mounting height.
View SourceView Similar (2)
Electrical Switches. A. Design guidance for Infrastructure described in this section is provided in HFDG Section 6.4.7.5 – “Electrical Switches”. B. Provide disconnect switches in fibreglass cabinets inside the TPSS. 1. Local controls, located in lockable enclosures, must be provided for maintenance activities. C. Ground mats are required at all disconnect switch operating handle locations. D. Disconnect switches must be suitably rated switches to connect/disconnect two adjacent electrical sections of OCS.
View Source
Electrical Switches. One single pole light switch shall be provided per 500 sq. ft. of rentable area. Switches required over this allowance are $76.00.
View Source
Electrical Switches. At the start of a job, all electrical switches that could be activated accidentally shall be locked out. Bidder shall notify Customer before deactivating any electrical switches or systems. When job is completed, all electrical switches and system components shall be returned to an operable state. Cleaning Materials: Flammable solvents or other flammable cleaning aids shall not be used. Pumping Service Range: Bidder shall provide service within one hundred fifty (150) feet of the pumping location, beyond 150 feet Bidder may charge by the linear foot for extra hoses to reach the job location. Repair or Replacement Work: Any repair and replacement work of Customer’s equipment/tanks/lines shall not be considered a part of this Contract.
View Source
Electrical Switches. A. Design guidance for Infrastructure described in this section is provided in HFDG Section 6.2.14 – “Electrical Switches”. B. Feeder and tie switches
View Source

Related to Electrical Switches

  • Electrical Provide drawings for the following systems: .1 Lighting including circuiting and luminaire identification and switching. Also provide illuminance computer printout for all indoor typical indoor spaces and parking lots. .2 Convenience outlets and circuiting, special outlets and circuiting, television outlets, and power systems and equipment. Provide riser diagrams for all electrical systems including master clock, intercom, fire alarm, ITV, computer networking/telephone. Also, provide for emergency and normal power distribution. Provide luminaire schedule. .3 Panel schedule may be in preliminary form but circuitry must be included. .4 Applicable installation details. .5 General legend and list of abbreviations. .6 Voltage drop computation for all main feeders. .7 Short circuit analysis .8 Provide 1/2" scale floor plan and wall elevations for all electrical rooms.

  • Lighting A system of fixtures providing or controlling the light sources used on or near the airport or within the airport buildings. The field lighting includes all luminous signals, markers, floodlights, and illuminating devices used on or near the airport or to aid in the operation of aircraft landing at, taking off from, or taxiing on the airport surface.