DOOR GUIDE Clause Samples

DOOR GUIDE. Refer to Figure 8-1. This figure shows the door from a top, front, and bottom view with the door cover removed. 12 adjustment screws are used to prop- erly position the door. Each screw has a nylon tip to allow the door to slide properly. Prior to adjusting, visually inspect each screw to verify that the nylon tip is intact. Replace any screws missing its nylon tip. Remove door cover and adjust as follows: 1. Front screws — top left and right (designated “A” on Figure 8-1) • Loosen the locknut and back the screw out. Then adjust the screw back in so the tip is flush with the inner door surface. Using a flat sur- face, as shown on Figure 8-2 is beneficial in adjusting the screw flush. Once screws are flush, turn clockwise two additional turns and 8-1 764326-797 2. Rear screws — bottom left and right (designated “B” on Figure 8-1) • Loosen the locknut and back the screw out. Then adjust the screw back in so the tip is flush with the inner door surface. Using a flat sur- face, as shown on Figure 8-2, is beneficial in adjusting the screw flush. Once screws are flush, turn clockwise two additional turns and tighten lockwasher. 3. Side screws — right and left, top and bottom (designated “C” on Figure 8-1) • Pin door to endframe. • Loosen the locknuts and adjust all four side screws until they just make contact with the endframe or door guide bars; then back the right-hand screws out 3 / 4 turn. Tighten lock- nuts. 4. Rear screws — top left and right (designated “D” on Figure 8-1) • With door down about 1", loosen locknuts and adjust screws in until they make contact; then