CONTRACT DRAWINGS AND SPECIFICATIONS Clause Samples

CONTRACT DRAWINGS AND SPECIFICATIONS. All the design documents provided by Design-Builder and approved by City pursuant to the Contract including, without limitation, those for use in constructing the Project, performing the Work and the rendering of the Project fully operational, signed and sealed detailed plans, drawings, specifications, manuals, and related materials prepared by the Architect/Engineer of Record.

CONTRACT DRAWINGS AND SPECIFICATIONS. A. The City of Durham will provide to the Contractor, without charge, five (5) sets of contract drawings and specifications, except publications incorporated into the contract and technical provisions by reference, in electronic or paper media as requested by the Contractor, subject to approval by the City of Durham. B. The Contractor shall: (1) Check all drawing furnished immediately upon receipt; (2) Compare all drawings and verify the figures given before laying out the work; (3) Promptly notify the City of Durham of any discrepancies; (4) Be responsible for any errors that might have been avoided by complying with this paragraph (b) above; and (5) Reproduce and print additional contract drawings and specifications, other than those noted above, as may be required for their use. C. In general, the following rules of precedence of the specifications and drawings shall apply with precedence listed from highest to lowest: (1) The project specifications shall govern over the plans; (2) Project special provisions or instructions; (3) Project drawings; and full size drawings shall govern over half-size drawings; and the Contractor shall follow figures marked on drawings in preference to scale measurements; (4) N.C. Department of Transportation Standard Specifications; (5) City of Durham Standards and Specifications; (6) Other specification and drawing references; (7) Omissions from the drawings or specifications or the misdescription of details of work that are manifestly necessary to carry out the intent of the drawings and specifications, or that are customarily performed, shall not relieve the Contractor from performing such omitted or misdescribed details of the work. The Contractor shall perform such details as if fully and correctly set forth and described in the drawings and specifications.