Hybrid Loop A Loop composed of both fiber optic cable and copper wire or cable. An FTTP Loop is not a Hybrid Loop.
EPP service availability Refers to the ability of the TLD EPP servers as a group, to respond to commands from the Registry accredited Registrars, who already have credentials to the servers. The response shall include appropriate data from the Registry System. An EPP command with “EPP command RTT” 5 times higher than the corresponding SLR will be considered as unanswered. If 51% or more of the EPP testing probes see the EPP service as unavailable during a given time, the EPP service will be considered unavailable.
Measurement method An isolation resistance test instrument is connected between the live parts and the electrical chassis. The isolation resistance is subsequently measured by applying a DC voltage at least half of the working voltage of the high voltage bus. If the system has several voltage ranges (e.g. because of boost converter) in conductively connected circuit and some of the components cannot withstand the working voltage of the entire circuit, the isolation resistance between those components and the electrical chassis can be measured separately by applying at least half of their own working voltage with those components disconnected.
Funding Availability This Contract is at all times subject to state appropriations. The Department makes no express or implied representation or guarantee of continued or future funding under this Contract. The Department has, as of the date of the execution of this Contract, obtained all requisite approvals and authority to enter into and perform its obligations under this Contract, including, without limitation, the obligation to make the initial payment or payments required to be made under this Contract on the date or dates upon which such initial payment or payments may otherwise be disbursed during the current contract period, (i.e., Sept ember 1, 2015, through August 31, 2017). The Grantee acknowledges the Department’s authority to make such payments is contingent upon the Texas Legislature's appropriation to the Department of sufficient funds and the availability of funds to the Department for such purpose. If the State of Texas or the federal government terminates its appropriation through the Department or fails to pay the full amount of the allocation for the operation of any grant or reimbursement program hereunder , or the funds are otherwise unavailable, the Department may immediately and without penalty reduce payments or terminate this Contract, in whole or in part. Upon termination of the Contract or reduction of payments, the Grantee shall return to the Department any unexpended funds already disbursed to the Grantee. Neither the Department nor the State of Texas shall incur liability for damages or any loss that may be caused or associated with such termination or reduction of payments. The Department shall not be required to give prior notice for termination or reduction of payments.
Performance Measurement Satisfactory performance of this Contract will be measured by:
Mileage Measurement Where required, the mileage measurement for LIS rate elements is determined in the same manner as the mileage measurement for V&H methodology as outlined in NECA Tariff No. 4.
Positive sequence component of the fundamental frequency AC bus voltage at either the Xxxx 00xx Xxxxxx 345kV Substation 345kV AC bus or the Bergen 230kV AC bus greater than the upper limit or less than the lower limit as specified in Figure G-1. For the period up to 0.5 seconds, the upper voltage limit specified in Figure G-1 shall be applied to the greater of the fundamental- frequency positive-sequence AC bus voltage in pu on the nominal line-to-line rms voltage, the crest phase-to-ground voltage of any AC bus phase in pu of times the nominal line-to-line rms voltage, and the crest phase-to-phase voltage of any AC bus phase in pu of times the nominal line-to-line rms AC bus voltage.
