CHAINAGE Sample Clauses

The CHAINAGE clause defines a system for referencing specific locations along a linear project, such as a road, pipeline, or railway, by assigning numerical values (chainages) to points along the project's alignment. In practice, this clause establishes a baseline or starting point and measures distances from it, allowing all parties to refer to precise positions using chainage numbers. This system ensures clarity and consistency in communication, planning, and execution of works, reducing the risk of misunderstandings about locations on the project.
CHAINAGE. 7.1 Slack distance measurement will be made using 50 M steel tape or 30 M Chain. However, in case of abrupt slope change the tape / chain is straightened parallel to the probable grading. 7.2 Distance between Intersection Point staked along the pipeline route shall be measured and recorded. In addition, distance between level points shall also be measuredand recorded. 7.3 Chaining will be continuous in the direction of survey. 7.4 The true bearing of all straights shall be observed and recorded. 7.5 Data on nature of terrain, viz. ▇▇▇▇▇, stony, vegetation, etc. and type of ground will also be recorded along with chainages of change points. 7.6 Check on distance measurements will be by stadia method atthe time of leveling. 7.7 Standard chain survey format will be used for record keeping.
View Source

Related to CHAINAGE

  • Drainage ▪ Prevent silt bearing road surface and ditch runoff from delivering sediment to any streams or wetlands. ▪ Maintain rolling dips and drivable waterbars as needed to keep them functioning as intended. ▪ Maintain headwalls to the road shoulder level with material that will resist erosion. ▪ Maintain energy dissipaters at culvert outlets with non-erodible material or rock. ▪ Keep ditches, culverts, and other drainage structures clear of obstructions and functioning as intended. ▪ Inspect and clean culverts at least monthly, with additional inspections during storms and periods of high runoff. This shall be done even during periods of inactivity. ▪ Perform preventative maintenance work to safeguard against storm damage, such as blading to ensure correct runoff, ditch and culvert cleaning, and waterbar maintenance.

  • Electrical Provide drawings for the following systems: .1 Lighting including circuiting and luminaire identification and switching. Also provide illuminance computer printout for all indoor typical indoor spaces and parking lots. .2 Convenience outlets and circuiting, special outlets and circuiting, television outlets, and power systems and equipment. Provide riser diagrams for all electrical systems including master clock, intercom, fire alarm, ITV, computer networking/telephone. Also, provide for emergency and normal power distribution. Provide luminaire schedule. .3 Panel schedule may be in preliminary form but circuitry must be included. .4 Applicable installation details. .5 General legend and list of abbreviations. .6 Voltage drop computation for all main feeders. .7 Short circuit analysis .8 Provide 1/2" scale floor plan and wall elevations for all electrical rooms.

  • Lighting A system of fixtures providing or controlling the light sources used on or near the airport or within the airport buildings. The field lighting includes all luminous signals, markers, floodlights, and illuminating devices used on or near the airport or to aid in the operation of aircraft landing at, taking off from, or taxiing on the airport surface.

  • Drainage Systems (1) Clear culvert inlets, outlets, and sediment catching basins. (2) Maintain waterbars, drainage dips, and other water diversion measures. (3) During active use, patrol and maintain functional drainage. (4) Repair damaged culvert ends.

  • Retrenchment At any time during an individual’s service, the individual may be subject to retrenchment in accordance with the provisions of Article 22 of the Agreement. In such cases, the notice provisions and all other terms of that article shall apply, anything above to the contrary notwithstanding.