Adjustments tab Clause Samples

Adjustments tab. Rocker Mode If you enable this option, you can change the scanning conditions while TIP Rocker Mode is available only for prescanning. Once the scanning position has been moved, you can turn on the Rocker Mode at any position and scan in data repeatedly from the same position. With the image displayed in the Preview window, move the mouse cursor to the area for which you wish to make the settings for scanning, and then right-click to return the scanning position to a previous position and turn on the Rocker mode. You can turn the Rocker mode off if you right-click in the Preview window when in Rocker mode. When Output is Bilevel Intensity Adjusts the overall brightness level. The higher the Intensity value, the whiter Intensity Correction Specify the degree of correction that applies to auto adjustment of the Edge Adjustment Setting a larger value here sharpens thin lines, characters, etc. TIP If a good image is not obtained by default when you select “Bilevel” for Output, adjust the control settings in the following order: Intensity > Intensity Correction> Edge Adjustment White Level All pixels whiter than the setting will be scanned in as white. Black Level All pixels blacker than the setting will be scanned in as black. Gray balance The three RGB colors are used to scan the document. The blue and yellow Automatic Despeckling Speckle Size ................ Set the size of speckles that are to be removed by automatic despeckling. (1 to 30 pixels, in 1-pixel increments) Automatic Deskew If you enable this option, any skewed image will be corrected if the scanner