Type 0 definition

Type 0. Manual cannibalisation of appliances (no depollution) • Type 1: Manual treatment, including all or some depollution. • Type 2: Mechanical treatment (pre-treatment and intermediate treatment), or specific manual treatment, including some or all depollution (where indicated). • Type 3: Advanced mechanical treatment, including some or all depollution (where indicated). • Type 4: End-processing (pure fractions), or incineration / energy from waste facilities Type 1, 2 and 3 are including in the certification, however type 4 is not part of it. The plastics sorting is included in Type 3. Eligible treatment for the WEEELABEX (B02TR Eligibility of Treatment Operators – DEFREV11_version 1 – 4th August 2020) where A: Large appliance; B: Mixed equipment; C Temperature exchange equipment; D: CRT display appliances and cathode ray tubes; E: Flat panel display equipment and flat panel displays; F: Gas discharge lamps; G: Photovoltaic panel; H: Other In order to obtain the certification for one type mention above, an audit will be organized to make sure the treatment recovery processes are compliant to the Cenelec standards. Obtaining the certification is allowing recyclers to position themselves as parties that take corporate responsibility as core action. The scheme illustrated in Figure 10 explains the procedure to obtain the certification as well as the interaction between the different parties.
View Source

Examples of Type 0 in a sentence

  • The configuration space is accessed by a Type 0 configuration transaction on the primary interface.

  • A Type 0 configuration transaction is identified by the configuration command and the lowest two bits of the address set to 00b.

  • To support hierarchical PCI bus systems, two types of configuration transactions are specified: Type 0 and Type 1.

  • Type 0 configuration transactions are issued when the intended target resides on the same PCI bus as the initiator.

  • The function number is also included in both Type 0 and Type 1 formats and indicates which function of a multifunction device is to be accessed.

  • The register number is found in both Type 0 and Type 1 formats and gives the DWORD address of the configuration register to be accessed.

  • Type 0 configuration write and read transactions do not use data buffers; that is, these transactions are completed immediately, regardless of the state of the data buffers.

  • Type 1 to Type 0 configuration read or write transactions are limited to a single 32-bit data transfer.

  • Ultimately, this transaction is translated to a Type 0 configuration command or to a special cycle transaction by a downstream PCI-to-PCI bridge.

  • If the target bus is the bridge’s secondary bus: claim and pass through as a Type 0 Configuration Read.