Transfer Facilities definition
Examples of Transfer Facilities in a sentence
Following receipt of a Connection Notice, Antero Water shall cause the necessary facilities to be constructed to connect the Fresh Water System to such Well Pads and to deliver and install at such Well Pads the necessary High-Rate Transfer Facilities, such that the Fresh Water Services can be commenced when hydraulic fracturing operations are ready to be commenced at such Well Pad.
Antero Water shall ensure that all such High-Rate Transfer Facilities remain on the Well Pad or on such site and be available to perform the High-Rate Transfer Services at all times during which Producer has notified Antero Water in accordance with Section 10.2 that hydraulic fracturing operations will be carried out on such Well Pad until such time as Producer has advised Antero Water that all hydraulic fracturing operations have been completed on all Planned ▇▇▇▇▇ at such Well Pad.
Subject to the other provisions of this Agreement, Antero Water shall construct and operate the Fresh Water System in a manner so as to permit Fresh Water to be made available at the points of interconnection to the High-Rate Transfer Facilities at the rates of flow required by Section 3.1(c) and shall install and operate the High-Rate Transfer Facilities in a manner so as to make Fresh Water available at the Fresh Water Delivery Points at the applicable Fresh Water Delivery Rates.
The inlet to Antero Water’s Measurement Facilities located at the inlet to the High-Rate Transfer Facilities located at or in the vicinity of each Well Pad.
The parties have identified their respective access needs on the map entitled Transfer Facilities, Marine Access Points and Proposed Transportation Corridors in Southeast Alaska, numbered 92337, and dated June 15, 2005 (“Map”), which is Attachment A and is hereby incorporated and made part of this MOU.
The inlet to Service Provider’s Measurement Facilities at the truck unloading facility located at or in the vicinity of each Well Pad where Produced Water that is to be mixed with Fresh Water in accordance with Producer’s instructions is measured as or before it goes into the High-Rate Transfer Facilities.
Producer may also check Antero Water’s measurements of Fresh Water using data collected by Producer or its hydraulic fracturing contractors regarding the actual volumes of Fresh Water delivered from the High-Rate Transfer Facilities into the Fresh Water Delivery Points.
The Fresh Water System, including the Impoundment Facilities, will be designed to permit Fresh Water to be made available at the points on interconnection with the High-Rate Transfer Facilities at a minimum flow rate of 60 Barrels per minute, assuming that Fresh Water will be made available for hydraulic fracturing operations on only one Well per trunkline at any given time (the “Minimum Flow Rate”).
Service Provider shall install, own, operate, and maintain Measurement Facilities to measure the volumes of Fresh Water made available on each Day at each Fresh Water Measurement Point and the volumes of Produced Water delivered by truck on each Day at each Produced Water Measurement Point for mixing with Fresh Water in the High-Rate Transfer Facilities.
Antero Water shall have the right to remove and re-install or re-erect such High Rate Transfer Facilities from time to time as long as no delay or disruption in Producer’s hydraulic fracturing operations results therefrom.