Test Requirements definition

Test Requirements means the test plans and test procedures set forth in Exhibit D (Test Plan Requirements), as may be amended pursuant to this Contract.
Test Requirements has the meaning given in paragraph 1.12 of Part A of this Schedule 6.2;
Test Requirements means the test requirements set forth in Exhibits A and B, as may be amended pursuant to this Agreement.

Examples of Test Requirements in a sentence

  • Glaze in accordance with recommendations of glazing and framing manufacturers, and as required to meet the Performance Test Requirements specified in other applicable sections of specifications.

  • The greatest challenge was seen as flats, where on average, 40% of products collected from flats were contaminated.

  • ASTM Test Requirements Type -- Unsupported between posts Apparent opening size D 4751 No. 30 max., No. 100 min.

  • All deliveries shall be subject to Acceptance Test Requirements pursuant to GCC Clause 4 in which case the awardee-supplier shall include additional quantity in every batch of delivery for acceptance and testing purposes.

  • General Test Requirements: Materials to be furnished under the Contract are subject to testing and inspection for compliance with the requirements of drawings and inspections.

  • Test Requirements: ASTM E 84-96, "Surface burning characteristics".

  • If a performance test is required, the test report documenting the results of the performance test, which includes the elements required in the Test Requirements section of this permit, including measurements and calculations to support special compliance provisions for multiple emissions units controlled by a common add-on air pollution control device.

  • Mix and apply the bonding agent ensuring the slot is completely full with no voids beneath the sensor.695-3.2.2 Test Requirements: Perform the manufacturer’s recommended on-site pre-installation test to determine the sensor’s condition using an Inductive Capacitance Resistance meter.

  • Regional Haze Test Requirements (See Section IV.C and IV.D of Part B).

  • If the Project does not meet the Minimum Performance Test Requirements, Seller shall take corrective action and repeat the Performance Test until the Performance Test is Successfully Run and the Minimum Performance Test Requirements are met.


More Definitions of Test Requirements

Test Requirements. Medium: Water, as specified in this Section. Pressure: 150 PSI Duration: 120 minutes Leakage: Zero, as specified in this Section
Test Requirements. Medium: Water, as specified in this Section. Pressure: 150 PSI. See Remarks for Seal Water. C3 – 30
Test Requirements. Medium: Preliminary test: Air, Nitrogen, or Inert gas Final test: Lube oil and fuel oil, as specified in this Section. Pressure: 150 PSI (fuel piping, pressure piping)
Test Requirements. Medium: Air; as specified in this Section. Pressure: 15 psig for FA piping 10” and smaller 20” water column for 12” and larger ductwork. Duration: 60 minutes.

Related to Test Requirements

  • Project Requirements means the statement included in the Request for Proposal detailing the technical and other requirements of Canada which are to be met by the successful Bidder, and which are to be addressed in the Bid;

  • Relevant Requirements means all applicable Law relating to bribery, corruption and fraud, including the Bribery Act 2010 and any guidance issued by the Secretary of State for Justice pursuant to section 9 of the Bribery Act 2010;

  • Service Requirements means the specification that the Flexibility Services must be capable of meeting, as defined in Schedule 1;

  • Pretreatment requirements means any substantive or procedural requirement related to pretreatment, other than a pretreatment standard, imposed on an industrial user.

  • Program Requirements means certain minimum program entry requirements as well as ongoing program requirements, to be fulfilled by Partner, some of which are general PartnerEdge requirements, some of which are specific for the “Sell Engagement” and some of which are specific for the different “Cloud” Product Families, including, without limitation payment of the Program Fee(s), meeting certain minimum annual revenue requirements, upholding a Sell Authorization for at least one “Cloud” Product Family and other requirements as set out in detail in the PartnerEdge Program Guide and the RSPI.

  • OHS Requirements means all Laws applicable to the Supply and related to occupational health or safety, and all of the City Policies that relate to occupational health or safety, and includes without limitation the WCA;

  • End Client Requirements means the specific requirements of the End Client, as notified to the Supplier in writing;

  • Minimum Requirements means the minimum requirements for available commercial structures. The minimum requirements may be found at this link: https://portlandgeneral.com/energy- choices/renewable-power/green-future-impact The minimum requirements may be updated from time to time to reflect PGE’s criteria from its latest Commission accepted renewable request for proposals.

  • Performance Requirements The ordering entity reserves the right to inspect and verify that all deliveries are in accordance with specifications, both at the point of delivery and at the point of use. For orders that specify an “authorized party” to receive and inspect deliveries and/or installations, acceptance and inspection procedures must be performed by the” authorized party” to be considered and accepted by the ordering entity. Products inspected at the time of use are subject to refusal and return requirements for issues of quality such as defects in manufacturing and/or workmanship. Products will not be considered accepted by the ordering entity until the installation is complete for the applicable products.

  • Payment Requirement means the amount specified as being applicable to the Reference Entity in the Standard or its equivalent in the relevant Obligation Currency (or, if no such amount is specified, USD 1,000,000 or its equivalent in the relevant Obligation Currency) in either case as of the occurrence of the relevant Failure to Pay or Potential Failure to Pay, as applicable.

  • Design requirements means the written description of the infrastructure facility to be procured pursuant to this article, including:

  • Maintenance Requirements shall have the meaning set forth in Clause 14.2;

  • Debt Service Requirements means the aggregate principal payments (whether at maturity or pursuant to scheduled mandatory sinking fund redemption requirements) and interest payments on the Bonds for the period of time for which calculated; provided, however, that for purposes of calculating such amount, principal and interest shall be excluded from the determination of Debt Service Requirements to the extent that such principal or interest is payable from amounts deposited in trust, escrowed or otherwise set aside for the payment thereof with the Paying Agent or other commercial bank or trust company located in the State and having full trust powers.

  • Minimum Balance Requirements You must maintain a minimum daily balance of $2,000.00 in your Money Market Savings account to obtain the disclosed annual percentage yield. We impose a monthly maintenance fee if the balance falls below $500 any day of the month. Basic Checking Account Rate Information: This account does not pay interest.

  • MREL Requirements means the laws, regulations, requirements, guidelines, rules, standards and policies relating to minimum requirements for own funds and eligible liabilities applicable to the Issuer and/or the Group, from time to time, (including any applicable transitional or grandfathering provisions), including, without limitation to the generality of the foregoing, any delegated or implementing acts (such as regulatory technical standards) adopted by the European Commission and any regulations, requirements, guidelines, rules, standards and policies relating to minimum requirements for own funds and eligible liabilities adopted by the Federal Republic of Germany or the Republic of Italy, a relevant resolution authority or the European Banking Authority from time to time (whether or not such requirements, guidelines or policies are applied generally or specifically to the Issuer and/or the Group), as any of the preceding laws, regulations, requirements, guidelines, rules, standards, policies or interpretations may be amended, supplemented, superseded or replaced from time to time.

  • Statement of Requirements means a statement issued by the Authority or any Other Contracting Body detailing its Services Requirement issued in accordance with the Ordering Procedure;

  • performance requirement means a requirement that:

  • Operational requirements means the need to ensure that the Agency is to be operated as effectively, efficiently and economically as possible.

  • Technical Requirements means the Technical Requirements in Section VII of the tendering documents.

  • Debt Service Requirement means, as of any date of calculation with respect to the Bonds, the sum of (i) all interest due or to become due on such date on all Outstanding Bonds plus (ii) all Principal Installments due or to become due on such date on all Outstanding Bonds or, if no Principal Installment is due and payable on such date on any Outstanding Bonds, one- half of the Principal Installments, if any, due and payable on all Outstanding Bonds on the next succeeding Interest Payment Date.

  • Contract Minimum Investment Requirement means, with respect to the Project, investment by the Company and any Sponsor Affiliates of at least $10,000,000 in Economic Development Property subject (non-exempt) to ad valorem taxation (in the absence of this Fee Agreement).

  • Test means such test as is prescribed by the particulars or considered necessary by the Inspecting Officer whether performed or made by the Inspecting Officer or any agency acting under the direction of the Inspecting Officer;

  • Default Requirement means the amount specified as being applicable to the Reference Entity in the Standard, or its equivalent in the relevant Obligation Currency (or, if no such amount is specified, U.S.$ 10,000,000 or its equivalent in the relevant Obligation Currency) in either case, as of the occurrence of the relevant Credit Event.

  • Monitoring Requirements Schedule means the Schedule containing details of the monitoring arrangements.

  • MREL Requirement means the minimum requirement for own funds and eligible liabilities which is or, as the case may be, will be applicable to the Issuer;

  • Storage Injection Requirements means all volumes required by the Seller for injection into underground storage, including cushion gas, and for liquification, including fuel used for injection and in liquification plants, or for such other storage projects that may be developed expressly for the protection of supply to high priority users.