Test pit definition

Test pit means an excavation used to examine a soil profile in order to assess soil permeability and depth to a seasonal high water table using soil texture, structure, and redoximorphic features as a basis for assessing site suitability.
Sample 1Sample 2Sample 3
Test pit means an excavation used to observe the soil profile in its original condition for purpose of completing a soil log.
Sample 1Sample 2Sample 3
Test pit means an open pit dug to sufficient size and depth to permit thorough examination of the soil to evaluate its suitability for subsurface sewage disposal.
Sample 1Sample 2Sample 3

Examples of Test pit in a sentence

  • Test pit information certified by a Licensed Site Evaluator, or a Professional Engineer must show that three feet of separation exists between the Seasonal High Groundwater Table and the bottom of any proposed infiltration structure.

  • Test pit and monitoring wells may not show high ground water levels during low precipitation years.

  • Test pit holes will be a maximum 125 m² Surface soils will be stripped to a depth of 15cm and stored at test pit locations.

  • Test pit excavations shall have neat, clean-cut and vertical sides.

  • Test pit reports and soil boring logs shall include the date(s) data was collected and the location referenced to a site plan.

  • Test pit survey is only used in areas that cannot be subject to ploughing or cultivation.

  • Test pit logs must provide a description of all organic and mineral horizons in accordance with the standards established by the National Cooperative Soil Survey.

  • Test pit data to within either the seasonal high water table or a minimum of six feet below the proposed excavation depth.

  • Test pit logs indicate that the predominant overburden soil consists of brown to gray clay, silty clay and fine sand to gravel.

  • Test Pit Excavation Test pit excavations are carried out to verify the archaeological potential within a study area.


More Definitions of Test pit

Test pit means an open pit dug to sufficient size and depth to permit thoroughly examining the soil to evaluate its suitability for subsurface wastewater treatment.
Sample 1Sample 2
Test pit means a test hole excavated by hand or using mechanical excavators.
Sample 1
Test pit means an excavation for prospecting by means other than drilling. Materials obtained from a test pit are used for test purposes and not for direct economic profit.
Sample 1

Related to Test pit

  • Test Pass has the meaning stated in Section 3.4(a).

  • Test Plan means a plan: for the Testing of the Deliverables; and setting out other agreed criteria related to the achievement of Milestones, as described further in paragraph 4 of Call of Schedule 5 (Testing);

  • COVID-19 test means a viral test for SARS-CoV-2 that is:

  • Test Date means, with respect to any Start Date, the last day of the most recent fiscal quarter of the Borrower ended immediately prior to such Start Date.

  • RDDS test Means one query sent to a particular “IP address” of one of the servers of one of the RDDS services. Queries shall be about existing objects in the Registry System and the responses must contain the corresponding information otherwise the query will be considered unanswered. Queries with an RTT 5 times higher than the corresponding SLR will be considered as unanswered. The possible results to an RDDS test are: a number in milliseconds corresponding to the RTT or undefined/unanswered.

  • Test Facility means any WRAS suitably accredited test laboratory;

  • DNS test Means one non-­‐recursive DNS query sent to a particular “IP address” (via UDP or TCP). If DNSSEC is offered in the queried DNS zone, for a query to be considered answered, the signatures must be positively verified against a corresponding DS record published in the parent zone or, if the parent is not signed, against a statically configured Trust Anchor. The answer to the query must contain the corresponding information from the Registry System, otherwise the query will be considered unanswered. A query with a “DNS resolution RTT” 5 times higher than the corresponding SLR, will be considered unanswered. The possible results to a DNS test are: a number in milliseconds corresponding to the “DNS resolution RTT” or, undefined/unanswered.

  • Test means such test as is prescribed by the particulars or considered necessary by the Inspecting Officer whether performed or made by the Inspecting Officer or any agency acting under the direction of the Inspecting Officer;

  • Test cycle means a sequence of test points each with a defined speed and torque to be followed by the engine under steady state (WHSC) or transient operating conditions (WHTC).

  • Test Report means a written report issued by The Sequoia Project that documents the outcomes of the Testing Process; that is, the Applicant’s compliance with the Specifications and Test Materials.

  • 2 Wire Analog Voice Grade Loop or “Analog 2W” provides an effective 2-wire channel with 2-wire interfaces at each end that is suitable for the transport of analog Voice Grade (nominal 300 to 3000 Hz) signals and loop-start signaling. This Loop type is more fully described in Verizon Technical Reference (TR)-72565, as revised from time-to-time. If “Customer-Specified Signaling” is requested, the Loop will operate with one of the following signaling types that may be specified when the Loop is ordered: loop-start, ground-start, loop- reverse-battery, and no signaling. Customer specified signaling is more fully described in Verizon TR-72570, as revised from time-to- time. Verizon will not build new facilities.

  • Critical Test Concentration or "(CTC)" means the specified effluent dilution at which the Permittee is to conduct a single-concentration Aquatic Toxicity Test.

  • Plant Test Date or "PTD" means the date acceptance testing is performed with CLEC. "Point of Interface", "Point of Interconnection," or "POI" is a demarcation between the networks of two (2) LECs (including a LEC and CLEC). The POI is that point where the exchange of traffic takes place.

  • Stand-Alone Test Environment or "SATE" shall have the meaning set forth in Section 12.2.9.3.2.

  • Test Period means, at any time, the four consecutive fiscal quarters of Borrower then last ended (in each case taken as one accounting period) for which financial statements have been or are required to be delivered pursuant to Section 5.01(a) or (b).

  • First Lien Net Leverage Ratio means, with respect to any Test Period, the ratio of (i) Consolidated Total Indebtedness secured on a first lien basis, net of Unrestricted Cash, as of the last day of such Test Period, to (ii) Consolidated EBITDA for such Test Period.

  • Cannabis testing facility means an entity registered by

  • Collateral Quality Test means a test that is satisfied if, as of any date of determination, in the aggregate, the Collateral Loans owned (or in relation to a proposed acquisition of a Collateral Loan, both owned and proposed to be owned) by the Borrower satisfy each of the tests set forth below, calculated in each case in accordance with Section 1.3:

  • Acceptance Test Document means a document, which defines procedures for testing the functioning of installed system. The document will be finalized with the contractor within 7 days of issuance of the Letter of Award.

  • Consolidated Senior Leverage Ratio means the ratio of Consolidated Senior Debt, determined as of the last day of any fiscal quarter of the Company, to Consolidated EBITDA for the period of 12 months ending on such last day.

  • Consolidated Senior Secured Net Leverage Ratio means, for any Measurement Period, the ratio of (a) Consolidated Senior Secured Net Debt for Borrowed Money to (b) Consolidated EBITDA, in each case for such period.

  • Collateral Quality Tests means the Collateral Quality Tests set out in the Investment Management Agreement being each of the following:

  • Drug test means a test designed to detect the illegal use of a controlled substance.

  • Instantaneous flow measurement means the flow measured during the minimum time required for the flow-measuring device or method to produce a result in that instance. To the extent practical, instantaneous flow measurements coincide with the collection of any grab samples required for the same sampling period so that together the samples and flow are representative of the discharge during that sampling period.

  • Incurrence Test means the incurrence test set out in Clause 12.1 (Incurrence Test).

  • Operational Acceptance Tests means the tests specified in the Technical Requirements and Agreed Project Plan to be carried out to ascertain whether the System, or a specified Sub system, is able to attain the functional and performance requirements specified in the Technical Requirements and Agreed Project Plan, in accordance with the provisions of GCC Clause 27.2 (Operational Acceptance Test).