System Power definition

System Power means: (a) Use Limited System Capacity which was contracted to be made available by a seller to a purchaser (and for greater certainty does not include any generation reserves established or required by the RRO to which the purchaser belongs); and (b) energy which was contracted to be sold to a purchaser.
System Power means power flowing through a connection to a customer from the distribution system;
System Power means wholesale electricity procured from a system power supplier and NERC e-tagged as a representative weighted average power output from all generation resources under the ownership or control of the system power supplier which contribute to the power output mix.

Examples of System Power in a sentence

  • One or more reactor vessel head closure bolts less than full tensioned.Table 15.0-4—Nuclear Steam Supply System Power Levels Assumed in the Accident Analysis‌ Parameter DescriptionTable 15.0-5—Plant Parameters Used in Accident Analyses‌ Plant ParameterNominal Value atRated Thermal Power Notes: 1.

  • The 250 MW Use Limited System Capacity is acknowledged by the Parties to be the generating capacity component of the 250 MW System Power that is being purchased and sold herein.

  • Subject to the provisions of this Agreement, during the Contract Term MH shall sell to MP and MP shall purchase from MH 250 MW of System Power (the “250 MW System Power”).

  • Alarm Gate 1 Seal Heating System Power Gate 2Seal Heating System Fail To Start Gate 2 Seal Heating System Low Temp.

  • The grounding and cathodic protection designs of any direct current power distribution system shall specifically be subject to the acceptance of the Owner as part of the APM Operating System Power Distribution System Design Review.11 AUTOMATIC TRAIN CONTROL (ATC)‌ The Contractor shall design, provide, install and test an ATC system with all hardware and software necessary to comply with the requirements of this section.

  • Create additional higher pay level (UA-V), with no more than one (1) position per System (Power, Water, and Joint systems); create new additional higher pay level (UA-VI), filled by only one (1) employee Department-wide.

  • The Contractor shall define its requirements for propulsion feeder wire/conduit installation, including that between the power distribution system substations and the power rails, and the location and aesthetic treatment of this wayside equipment, in the APM Operating System Power Distribution System Design Review.13.7 SWITCHING‌ Guideway switches shall be provided and installed by the Contractor to enable the APM Operating System to operate as specified in TP 3 and 5.

  • Engine Type: Duramax 6.0L Diesel V8 Displacement 6.0 liters Fuel System Turbocharged SAE net HP 342 @ 5400 RPM SAE net Torque 373 foot pounds @ 4400 RPM Wheelbase: 139 inches Transmission: 6 - speed Automatic, Electronic w/Overdrive and Tow/Haul mode Rear Axle Ratio: 3:73 heavy-duty locking rear differential Tire Size: LT225/75R16D, 2 front, 4 rear, All season blackwall Spare Tire Size: LT225/75R16D Wheels All including spare, steel 16.0 x 6.5, 8 lug Brakes: ABS System, Power Disc Brakes front and rear.

  • A CAT-6 cable shall be installed between the existing switchgear control section and the station controller to facilitate the new control system architecture.B. Replace Control System Power Supplya.

  • Get to know your mailing system in this section.2.1 Mailing System Components 11How to use the Handheld Scanner 192.2 Operator Controls 202.3 System Power Management 23How to Turn the System ON/OFF 24How to Switch Between 'Sleep' And 'Wake' Modes 259How to Start / Stop the mail processing 26 2.1Mailing System Components The illustrations and tables below show the basic Mailing System configuration, including optional accessories you may have added.


More Definitions of System Power

System Power refers to the Energy resource mix for electricity in the State of California net of electricity sold to consumers as specific purchases.

Related to System Power

  • Electric power train means the electrical circuit which includes the traction motor(s), and may also include the REESS, the electrical energy conversion system, the electronic converters, the associated wiring harness and connectors, and the coupling system for charging the REESS.

  • cogeneration means the simultaneous generation in one process of thermal energy and electrical or mechanical energy;

  • Power System means all aspects of generation, transmission, distribution and supply of electricity and includes one or more of the following, namely:-

  • Transmission System Operator means a natural or legal person responsible for operating, ensuring the maintenance of and, if necessary, developing the transmission system in a given area and, where applicable, its interconnections with other systems, and for ensuring the long-term ability of the system to meet reasonable demands for the transmission of electricity;

  • Interconnector means equipment used to link the electricity system of the State to electricity systems outside of the State;

  • Interconnection Point means the point(s) of connection(s) at which the project is connected to the grid i.e. it shall be at 11 / 22 kV bus bar level of substation of MSEDCL.