Examples of Standard Tolerance in a sentence
Class C & F Tournaments: The Standard Tolerance Chart in the Appendix shall be used.
Where tolerances are not stated in the Specifications, permissible deviations will be in accordance with ACI 117 – Standard Tolerance for Concrete Construction and Materials.
Class F Tournaments: The Standard Tolerance ABT Chart in the Appendix may be used.
The ratings of the transformer shall be as follows or as shown on the drawings: kVA Rating * / Impedance * HV * HV BIL * HV De-energized Taps * LV * LV BIL * *[AA] [AA/FFA] [AA/FA] %*[+/- 7-1/2%] [ANSI Standard Tolerance] [Minimum] [Maximum] kV *[Delta] [Wye] kV +/- 2 - 2-1/2% full capacity Volts *[Wye] [Delta] kV 2.03 CONSTRUCTION A.
Where tolerances are not indicated, permissible deviations will be in accordance with ACI 117 - Standard Tolerance for Concrete Construction and Materials.
Standard Tolerance – Except in particulars specified by the Buyer expressly agreed to in writing signed by the Seller, the goods furnished hereunder are produced in accordance with standard manufacturing practices at the country of origin.
Class F Tournaments: the Standard Tolerance ABT Chart in the Appendix may be used.
Definition 4.4 (Standard Tolerance Specifications) Given specification Spec,• The masking tolerance specification is Spec itself.• The failsafe tolerance specification is safety(Spec).• The nonmasking tolerance specification is T∗; Sˆpec, where T is some set of traces and the traces of Sˆpec are the set of desired eventually good behavior.
The ratings of the transformer shall be as follows or as shown on the drawings:kVA Rating *Impedance *HV *HV BIL *HV De-energized Taps **[AA] [AA/FFA] [AA/FA]%*[+/- 7-1/2%] [ANSI Standard Tolerance] [Minimum] [Maximum] kV *[Delta] [Wye]kV+/- 2 - 2-1/2% full capacity* Note to Spec.
However, its variation from design specified values is less than that of Standard Tolerances.Examples of tolerance application may be an engine casting that uses Standard Tolerance.