SPMDD definition

SPMDD means “Standard Proctor Maximum Dry Density”
View Source
SPMDD means Standard Proctor Maximum Dry Density; (ee) “UDHR” means United Nations Declaration of Human Rights; (ff) “USC” means Unified Soil Classification;
View Source

Examples of SPMDD in a sentence

  • Sewer service pipe bedding shall consist of approved Granular “A” material compacted to 100% of material’s Standard ▇▇▇▇▇▇▇ Maximum Dry Density (SPMDD) in accordance with OPSD 802.010.

  • Bedding shall be Class “B” unless otherwise stipulated, consisting of approved Granular “A” material compacted to 100% of material’s Standard ▇▇▇▇▇▇▇ Maximum Dry Density (SPMDD) in accordance with OPSD 802.010.

  • The minimum acceptable depths of granular and asphalt will be as follows: Minimum of 150mm Granular “A” compacted to 100% of material’s Standard ▇▇▇▇▇▇▇ Maximum Dry Density (SPMDD) Minimum of 50mm compacted depth of HL 3 or HL 3A Surface Hot Mix Asphalt Dropped curb for driveway entrances for each Lot shall be as shown on Schedule “A-1” hereto and shall be on the side of the Lot remote from the water service.

  • Within the building areas - minimum of 98 percent standard ▇▇▇▇▇▇▇ maximum dry density (SPMDD) for slab-on-grade support.

  • The minimum acceptable depths of granular and asphalt will be as follows: • Minimum of 150mm Granular “A” compacted to 100% of material’s Standard ▇▇▇▇▇▇▇ Maximum Dry Density (SPMDD) • Minimum of 50mm compacted depth of HL 3 or HL 3A Surface Hot Mix Asphalt Dropped curb for driveway entrances for each Lot shall be as shown on Schedule “A-1” hereto and shall be on the side of the Lot remote from the water service.

  • The backfill should be placed in lifts not more than 200 mm thick in the loose state, each lift being compacted to at least 98 percent SPMDD under the floor slab and 95 percent SPMDD elsewhere, before subsequent lifts are placed.

  • Pavement areas - minimum of 95 percent SPMDD to within 600 mm of final subgrade level and 98 percent SPMDD for the upper 600 mm.

  • Driveway entrances for each building Lot must be paved within the boulevard between the road edge of pavement and the street line The minimum acceptable depths of granular and asphalt will be as follows:  Minimum of 150mm Granular “A” compacted to 100% of material’s Standard ▇▇▇▇▇▇▇ Maximum Dry Density (SPMDD)  Minimum of 50mm compacted depth of HL 3 or HL 3A Surface Hot Mix Asphalt In no case shall a driveway or driveway entrance be sited over a water service or a hydro service.

  • The Class A should be placed in lifts suitable for the compaction equipment being used and compacted to 100 percent standard ▇▇▇▇▇▇▇ maximum dry density (SPMDD).

  • General backfill including trench backfill and backfill adjacent to foundation walls - minimum of 98 percent SPMDD.