Soldering definition

Soldering means a process of joining metals without melting them using a filler metal melting at 800 degrees Fahrenheit, 427 degrees centigrade, or below.
View Source

Examples of Soldering in a sentence

  • This includes, but is not limited to: Brazing, Cutting, Grinding, Soldering, Torch Applied Roofing and Welding.

  • To 12mm.) Punch and chisel set Leak detector (Halide or equivalent) Soldering and brazing kit (Turbo torch) Cordless electric drill (3/8”) Tape measure (25’, 1” width min.) Flash light Clamp on volt-Amp meter (Amprobe or better) One digital multi-meter (Fluke or equivalent) For winter operations a deflection meter is recommended Subject to approval by the Employer, any tools supplied by the Employee in addition to the above list will be identified in writing to the Employer.

  • AstenJohnson will also supply all employees with Scissors, Pick Counters, Soldering Irons, etc., where needed.

  • This investigation quantified emissions from: • Abrasive blasting • External Combustion • Internal Combustion • Fuel Storage and Transfer • Hazardous Materials • Welding and Soldering.

  • Welding, Fitting for a Welder, Soldering, Testing, or cutting of any pipe for Installation.

  • Sheet metal; Sheet metal gages; Layout tools; Dividers; Punches; Rivets and riveting tools; metal cutting chisels; Using a chisel; Hammers; Metal cutting snips; Dressing, Notchers; Bench stakes; Forming tools; Hand seamer; Soldering sheet metal safety.

  • Pneumatics LED outputs to help make life easier on the driver Vision systems Skills Wiring/Electronics Soldering Crimping Best Practices Identify and explain purpose of every component used in a complete control system Know every rule related to S/C ▇▇.

  • Obtain “Hot Work Permit” forms, included as Exhibit D, for Soldering and Welding projects.

  • Basic Soldering and Circuit Board Repair for Electronics: (IACD01) provides instruction in soldering, soldering preparations, procedures, component replacement methods, and printed circuit board repair techniques.

  • Suppliers shall perform on an yearly basis a self- evaluation of each applicable special process listed below in compliance with the Automotive Industry Action Group (AIAG) Manual and provide results to WABCO upon request: • CQI-9: Heat Treat System Assessment; • CQI-11: Plating System Assessment; • CQI-12 : Coating System Assessment; • CQI-15: Welding SystemAssessment; • CQI-17 :Soldering System Assessment; • CQI-23: Molding System Assessment.

Related to Soldering

  • Stack means any point in a source designed to emit solids, liquids, or gases into the air, including a pipe or duct but not including flares.

  • Fabrication means intentional and unauthorized falsification or invention of any information or citation.

  • Fabricating means to make, build, create, produce, or assemble components or property to work in a new or different manner.

  • Dewatering means the removal of water for construction activity. It can be a discharge of appropriated surface or groundwater to dry and/or solidify a construction site. It may require Minnesota Department of Natural Resources permits to be appropriated and if contaminated may require other MPCA permits to be discharged.

  • Connector means a flanged, screwed, welded, or other joined fitting used to connect two pipelines or a pipeline and a piece of process equipment.